FCC ID: G6D64BS TOY Receiver

CAUTIOVSLECTCALL OPERATED PRODUC NOT RECOMMENDED FOR CHILDREN LNDER 8 VARS OF ASE AS WITH ALL ELECTRIG PRODUCTS, PRECAUTIONS SHOULD BE OBSERVED DURING HANDLING AND USE TO PREVENT ELECTRIC SHOCK. INPUT: 120V AC 602 10M, OUTPUT: 64VDC500mA, Charging Status Light eee OWNERS MANUAL Please read and understand all precautions prior to use. Thank you for choosing a premium New Bright product. 1. Insert the 6.4V Lithium lon rechargeable battery pack securely into the earner and push up to lock. Be sure the arrows are properly matched (as shown above). | |

2. Plug the Charger into a standard indoor electrical outlet. This power unit i is intended to be correctly orientated in a vertical or wall mount position. 3. Allow battery to charge for 1-1.5 Hours. Charging Status Light will be solid i red while battery is charging. When charging is complete, light will blink green. 4. To remove the battery, press and hold the release button and slide battery down to unlock. 5. Charge will last approximately 12 minutes depending on terrain and driving style. IMPORTANT: It is normal for the battery pack to become warm after charging and/or use. Be sure to allow the battery pack to cool before using or recharging. Recharging a warm battery pack will greatly reduce the battery life. ATTENTION PARENTS:

Ne es Cae THe Dalley Cllaige: & DAllGly FavR NHeCU WW UG POVUlUally GAGIINIGU IE PUkollial hazards. Any potentially hazardous parts need to be repaired or replaced. JN225-18 New Bright . New Bright Section 1: Table of Contents Section 2: | Component Checklist Section 3:

Section 4:

Section 5:

Section 6:

Section 7:

Charging the Battery Battery Installation in Vehicle Vehicle Features and Functions Transmitter Battery Installation Transmitter Features and Functions pattery Unarger 6.4V Lithium lon Battery Pac Transmitter

(2) AA Batteries Section 8: Proper Use Precautions and Care Section 9: Trouble Shooting Section 10: Cautions Section 11: Warranty Information REFO8516 0425 ma (=) a} (ed (=) Ai7Tg q | NOI MNIHAET| |

wor wnt) fi

* If vehicle pulls to the left or right during forward driving the Steering Trim may need to hx ne! Fk Pca idm tc tenn wn Khedbak at alhemoue hata the feeb ume:

ee Sees LEI Ree ee ee ee New Brigh ) Transmitte USA & Canada 30-Day Limited Warranty New Bright Industries warrants to the original purchaser that this product will be free of defects in materials and workmanship for :

thirty (30) days from the date of purchase. In the event of such defect within the warranty period, New Bright will repair or replace i the product at our sole discretion, This warranty does not cover damage resulting from unauthorized modifications, accident, :

misuse or abuse. Should your item have a defect covered under this warranty, first call the toil free number listed below. Most problems can be resolved in this manner. {finecessary, you will be issued a Return Authorization number (RA) and instructions on how to obtain a Product Return Form. The Product Return Form is to be used when returning a product to us (postage pre-paid and insured by the consumer). |

When returning a defective product, please package the product, the Product Return Form and a copy of the dated sales receipt as proof of purchase. Be sure to mark the RA number on the Product Return Form. If the product is returned without a dated sales receipt, it will be excluded from coverage under this warranty. Please allow 4 to 6 weeks for delivery of repaired or replacement vehicles (depending on your location). i New Bright industries liability for defects in materials and workmanship under this warranty shall be limited to repair or replacement at our sole discretion. In no event shall we be responsible for incidental, consequential or contingent damages

{except in those states that do not allow this exclusion or limitation). Valid only in the USA & Canada. Contact New Bright Industries Customer Service Toll Free at:

1-877-NBI-TOYS

(1-877-624-8697) Manday thranrak Criday 2:00 AM in GOD DRA Lactarn Timo ates ela sianiitis aladilialanias 5 ial ila a a Note: When replacing batteries:

Use alkaline batteries only. Do not mix old and new batteries. Do not mix alkaline, standard or rechargeable batteries. Transmitter Proper Use

> Derren a oS Forward/Reverse Left/Right Drive Steering L__J This transmitter is equipped with 2.4GHz technology which allows up to 6 vehicles to be raced at the same time. JU |

The transmitter will automatically sync with the vehicle. 90% of all difficulties experienced with radio controlled vehicles Do not recharge Battery Pack if it is hot or warm to the touch. Allow Battery Pack to cool are due to either weak batteries or batteries that have been installed incorrectly. i : f . When batteries become weak, the vehicle may not necessarily stop completely but may before recharging. Recharging a hot or warm Battery Pack will shorten the life of the Pack. exhibit slow response, slow speed or erratic behavior. Do not recharge a Battery Pack if it appears to be damaged or leaking.

; Always unplug Charger when not in use. Problem Vehicle does not move or moves slowly. eB Sener ae ieee ne hse feaeeedagsiecau tea ites ay tel YY On eae ree ee EIS IE DEI

- Make certain there are fresh alkaline batteries in the transmitter and that they have : altace a i Do not dispose batteries in fire. Leakage, explosion and personal injury may occur. heed etelledh ie conectipaetion, Dispose of Rechargeable Battery Pack properly.

- Are th i th ine batteries in th iti id re the (+) and (-) markings on the alkaline batteries in the same position as the (+) an Do not attempt to disassemble Battery Pack or Charger. Sow al :

(imaridge in iy pnastatir eatery Conipareiient? Do not use Battery Charger for any use other than instructed in this booklet. 7 H i . o 2 jas the Battery Pack been installed in the vehicle Only an adult should charge Batteries.

7 3 2 Has the rechargeable Battery Pack been fully charged? Do not attempt jumps or tricks with this vehicle.

- Are the (+) and 4 markings on the Battery Pack in the same position as the (+) and (-)

markings in the Battery Compartment?

Ron tha matal nantant daha taunhina rien: ar dirty in tha tranomittar?

RE EAE SE OO SO Se ee ee ee . + wa _ i *4 an i NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FOC Rules. These fimits are designed to provide reasonable protection against harmful interference in a residential installation. This

~ Make certain thatthe vehicle ON/OFF switch is in the.ON position. ceuipment generates, uses and can radiate rado frequency energy and, if not installed and used in accordance wih the

| instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio oF television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Problem ~Vehicle moves by itself or exhibits reduced range from the transmitter.

{ - Reorient or relocate the receiving antenna.

= Increase the separation between the equipment and receiver.

- Make certain there is no outside radio interference in your area. The best way to test this aration t nent an a i . + Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. is to take the vehicle as far away from radio towers, electrical lines or tall buildings as ~ Consult he dear or an experienced rado/TY techrician for help, possible to ensure no further radio interference will occur. FCC CAUTION:

- Changes or modifications not expressly approved by the party responsible for compliance could void i - tha neare aiithorify fo onerate the earinment.

30 o UC 20

we) ee ee eee ee rece eee ee ee ee eee ee eee eee yet eee ee Te east alltel) la aaa iat may 2 96 AN 12 34 5 6 TO aru 7 24 Ff &7 8 910.1 2Zesgeawo. te 9 4a Matalin MUTT TT HATA TAT TTT ATV ATPASES EOE SUSTAINS HTN LAER bee eh ch nie New Bright ~ a Made in China This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

CM CIM Met Me) HI this device may not cause harmtul interference, ane 4 re Seti in BCC RUE mc CORO Cl

VAS Yd lor HATE AKL |Z INEW{BRIGH TYINDUSTRIALTCOMLTDS New Bright Building, 11 Sheung Yuet Road, Kowloon Bay, Kowloon, Hong Kong. Tel: (852) 2798 1188 Fax: (852) 2795 3665 Date: 2019/3/29 Federal Communications Commission 7435 Oakland Mills Road Columbia MD 21046 To whom it may concern:

I, the undersigned, hereby authorize UL Verification Services Inc. to act on our behalf in all manners relating to application for equipment authorization, including signing of all documents relating to these matters. Any and all acts carried out by UL Verification Services Inc. on our behalf shall have the same effect as acts of our own. I, the undersigned, hereby certify that we are not subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 853(a). -

In authorizing UL Verification Services Inc. as our representative, we still recognize that we are responsible to:

a) comply with the relevant provisions of the certification program;

b) make all necessary arrangements for the conduct of the evaluation, including provision for examining documentation and access to all areas, records (including internal audit reports) and personnel for the purposes of evaluation (e.g. testing, inspection, assessment, surveillance, reassessment) and resolution of complaints;

c) make claims regarding certification only in respect of the scope for which certification has been granted;

d) do not use,our product certification in such a manner as to bring the Certification Division into disrepute and not make any statement regarding our product certification which the Certification Division may consider misleading or unauthorized;

g) h) j) k) upon suspension or cancellation of certification, discontinue use of all advertising matter that contains any reference thereto and return any certification documents as required by the Certification Division;

use certification only to indicate the products are certified as being in conformity with specified standards;

endeavor to ensure that no certificate or report nor any part thereof is used in a misleading manner;

ensure that any reference to our product certification in communication media such as documents, brochures or advertising, complies with the requirements of the Certification Division;

keep a record of all complaints made known to us relating to the products compliance with requirements of the relevant standard and to make these records available to the when requested;

take appropriate action with respect to such complaints and any deficiencies found in products or services that affect compliance with the requirements for certification;

document the actions taken. This authorization is valid until further written notice from the applicant. Sincerely Yours, Signed by:

Company Name: New Bright Industrial Co Ltd Contact Name: Eric Kwok Title of Person : Quality Manager Address: New Bright Building 11 Sheung Yuet Road, Kowloon Bay, Kowloon Hong Kong

Federal Communications Commission 7435 Oakland Mills Road Columbia MD 21046 Subject:Request for Confidentiality FCC ID: G6D64BS To Whom It May Concern:

Pursuant to the provisions of Sections 0.457 and 0.459 of the Commissions rules (47 CFR 0.457, 0.459), we are requesting the Commission to withhold the following attachments as confidential document from public disclosure indefinitely. Schematic Diagram Block Diagram Theory of Operation Above mentioned document contains detailed system and equipment description are considered as proprietary information in operation of the equipment. The public disclosure of above documents might be harmful to our company and would give competitor an unfair advantage in the market. It is our understanding that all measurement test reports, FCC ID label format and correspondent during certification review process cannot be granted as confidential documents and those information will be available for public review once the grant of equipment authorization is issued. Best Regards Company Name: New Bright Industrial Co., Ltd. Contact Name: Eric Kwok Title of PersonQuality Manager Address: New Bright Building 11 Sheung Yuet Road, Kowloon Bay, Kowloon Hongkong Date:2020/03/02