Transmitter Battery Installation OWNERS MANUAL Please read and understand all precautions prior to use. Thank you for choosing a premium New Bright product. Note: When replacing Transmitter batteries:
Use alkaline batteries only. Do not mix old and new batteries Do not mix alkaline, standard or rechargeable batteries. USA & Canada 30-Day Limited Warranty Featu res and Fu nctions New Bright Industries warrants to the original purchaser that this product will be free of defects in materials and workmanship for thirty (30) days from the date of purchase. In the event of such defect
# within the warranty period, New Bright will repair or replace the product at our sole discretion. This warranty does not cover damage resulting from unauthorized modifications, accident, misuse or abuse. Should your item have a defect covered under this warranty, first call the toll free number listed below. Most problems can be resolved in this manner. If necessary, you will be issued a Return Authorization number (RA) and instructions on how to obtain a Product Return Form. The Product Return Form is to be used when returning a product to us (postage pre-paid and insured by the consumer). When returning a defective product, please package the product, the Product Return Form and a copy of the dated sales receipt as proof of purchase. Be sure to mark the RA number on the Product Return Form. If the product is returned without a dated sales receipt, it will be excluded from coverage under this warranty. Please allow 4 to 6 weeks for delivery of repaired or replacement vehicles (depending on your Forward/Reverse Left/Right location). Drive Steering New Bright Industries liability for defects in materials and workmanship under this warranty shall be limited to repair or replacement at our sole discretion. In no event shall we be responsible for incidental, consequential or contingent damages (except in those states that do not allow this exclusion or limitation). Valid only in the USA & Canada.
; Se ; ; . Bright Industries C ice Toll Free at:
This transmitter is equipped with 2.4GHz technology which allows up to 6 PORE PE Ee ce ret Seve el ree at
. : (1-877-624-8697) vehicles to be raced at the same time. Monday through Friday, 8:00 AM to 5:00 PM Eastern Time The transmitter will automatically sync with the vehicle. JNO72-19 Section1: Table of Contents Section 2: Component Checklist Section 3: Vehicle Features & Functions
| e (1) R/C Vehicle With USB Cord Section 4: Charging the Battery e (1) Transmitter Section 5: Transmitter Battery Installation Transmitter Features & Functions e (2) AA Batteries Section 6: Proper Use Precautions & Care. Section 7: Trouble Shooting & Support REF-U47416 722091 Vehicle This vehicle is equipped with an internal Lithium-ion battery that is recharged via USB. ON/OFF Switch must be in the OFF position prior to charging. USB Charging Cable and Storage Compartment 1. Locate the ON/OFF switch and USB cord on the under-side of the vehicle. 2. Turn the ON/OFF switch to the OFF position. 3. Open Storage Compartment cover. 4. Remove USB cable from the Storage Compartment. (Use care when extending cord as it is attached to inside internal battery). Cord can be plugged into any computer or USB outlet brick (not included). This device complies with industry Canada licence-exempt RSS standard(s). Operat lowing two conditions:
(1) this device may nd (2 this device must Charge ON/OFF Switch Status Light susceptible d'en cr Ps 5. While charging, the LED under the vehicle will be on. Once fully charged
* If vehicle pulls to the left or right during forward driving the Wheel Alignment the LED will turn off. Charging is completed in approximately 2.5 hours may need to be adjusted. The Wheel Alignment Dial is located on bottom of i ?
Se ae ale nae ae dea ce i> nape Return cord and secure storage lid before operating the vehicle. chassis between the front wheels. eae Megmmp>>
wes S Switch vehicle OFF when not in use. Wipe body with a soft rag or tact cloth. Proper Use 7 y_\ S i Sa i) D ey ne) a ; i Brush areas where dirt gets trapped. Do not use chemicals or water to clean Trouble Shooting & Support Problem - Vehicle does not move or moves slowly. /
- Make certain there are fresh alkaline batteries in the transmitter and that they have been installed in the correct position.
- Are the (+) and () markings on the alkaline batteries in the same position as the (+) and () markings in the Transmitter Battery Compartment?
- Are the metal contact tabs touching, rusty or dirty in the transmitter?
- Has the vehicle been fully charged?
- Make certain that the vehicle ON/OFF switch is in the ON position. Problem - Vehicle moves by itself or exhibits reduced range from the transmitter.
- Make certain there are no outside radio interference in your area. The best way to test this is to take the vehicle as far away from radio towers, electrical lines or tall buildings as possible to ensure no further radio interference will occur. Always remove Batteries from transmitter when not in use. Do not dispose batteries in fire. Leakage, explosion and personal injury may occur. Do not attempt jumps or tricks with this vehicle. Do not attempt to remove internal battery. Do not use included USB cord for anything other than its intended purpose. Always keep USB cord stored when not in use. Adult supervision recommended. FCC CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.