| OWNERS MANUAL |
Piease read anda understand ali precautions prior to use. Thank wai far chancinga a nramium Naw Bright nroduct. So Ree ee a ee es ae ee Ne ee ee L856104745/JN227-18 ee ae ae i ee ee ee ee ee Thee ee )_ eT L . s . | lD) lL Lo CAARGING TE VERILLE DALIERT =_ |
This vehicle is equipped with an internal Lithium-lon battery Pee Se See Saeea pee vem yy yy Mat Is FELMahyeu Via Vow, ON/OFF Switch must be in the OFF position prior to charging. i aie em RR Ne T, LOCALE Te Cia ging COUlU COMPA UIMent COVEN ONT UIE UNMET sive of vehicle. 2. Remove USB cable from the Storage Compartment. (Use care when extending cord as it is attached to inside internal battery). Cord can be plugged into any computer or USB outlet brick (not included). 3. Insert the USB connector into a computer or other USB power source. tN ck ON i ie Ee Bee ee SS. VWWiic Har yily, ic SNe wlaluos eygee MEISE BIE WEIR Vie be on. Once fully charged the light will turn off. Charging is completed in approximately 2-3 hours (when charging from a computer). 5. After charging is complete, store the USB cord in the Charging Cord Compartment. Replace the Compartment cover. Wheel [appara
- USB Alignment Ml talyt 'y Vi Cord Charge Qyaitrah 1 Sta tus Battery Installation es AK ASE
| 1. Locate the Transmitter Battery Compartment, which is on the back of the Transmitter. mm ke
. MOVE the battery Compartment Lock towaras ine battery VLompartment ana remove the Battery Compartment Cover. 3. Insert 2 AA batteries. Make certain the plus (+) and minus (-) markings on |
the batteries are in the same position as the plus (+) and minus () markings inside the Battery Compartment. 4. neplace battery Compartment Cover making certain tnat ine battery Compartment Lock has snapped into the locked position. Note: When replacing batteries:
USE alkaline Dalleres Only. Do not mix old and new batteries. Do not mix alkaline, standard or rechargeable batteries. realures ala FUnUuUUrto lr 1 em ew _eeemsG L/ | EFT XY 7 RIGHT UY A DRIVE \ J ORWARD FORWARD/REVERSE DRIVING Dich BOTH jinveticke forward for Forward Driving. wu? eS zs -.:C:C*~C~C~:*=<<sPSt:tC:ti ese eae Sn Ee Pull BOTH joysticks back to drive in Reverse. _ 360 SPINS Counter-Clockwise 360 SPINS - Clockwise Dich hoth ioveticks in opposite Push both joysticks in opposite directions continuously as shown for directions continuously as shown for Counter-Clockwise Spinning. Clockwise Spinning.
} This transmitter is equipped with 2.4GHz technology which allows up to 6 vehicles to \
be raced at ine same time. Tha tranemitar will autqmatically evne with the vehicle. EETNe GERAD EMEP EER RE Be EE os Sane ee eae. ol-) mm Oky= Ki Precautions and Care
)) Ss Switch vehicle OFF Brush areas where when not in use. dirt gets trapped. WIpe DOay Wwitn a VO Not Use CnemicalS soft rag or cloth or water to clean
| Trouble shooting & Support Problem - Vehicle does not move or moves slowly.
- Has the rechargeable Internal Rattary haan fiilhy ebese.d>
- Make certain there are fresh alkaline batteries in the ETS ESTEE i, EE A, RON OY 8:
i transmitter and that they have been installed in the cerrrart position.
- Are the (+) and (-) markings on the alkaline batteries in the same position as the (+) and () markings in the Transmitter Battery Compartment?
transmitter?
i ~ Are the metal contact tabs touching, rusty or dirty in the Make certain that the vehicle ON/OFF switch is in the ON position. Problem - Vehicle moves by itself or exhibits reduced range from the transmitter. \
- Make certain there is no outside radio interference in vour area. The best wav to test this is to take the vehicle as far away from radio towers, electrical lines or tall buildings as possible to ensure no further radio interference will occur. FCC CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance could sean a ic ce ii ain en Tie iy (CM a i a i I a VU HOCl oO GUNIUITY WU UME Le CUUIVITICII, NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance WIN ie Instructions, may Cause Narmtul interlerence to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an ontlet an 4 circuit differant fram that ta which the raraivar ie pannarctad Se eS ge ne ee a
- Consult th the dealer or an an experienced radio/TV technician for help. New Bright Warranty Information USA & Canada 30-Dav Limited Warranty MP SERIE SESE SSE tenant einen STE ea New Bright Industries warrants to the original purchaser that this product will be free of defects in materials and workmanship for thirty (30) days from the date of purchase. In the event of such defect within the warranty period, New Bright will renair ar ranlace the nradiuirt at aie cele Jiechi eke " E ne acridant mission meek Le aTTAny Goes not cover damage resulting from unauthorized modifications, accident, misuse, or abuse. Should your item have a defect covered under this Ww pemiee lew gee Be ee ee arranty, first call the toll free number listed below. Most problem<
bo pe pe TeceSSaly, YOU Will be Issued a Return Authorization (RA) number and instructions on how to obtain a Product Return Form. The Product Return Form is to be used when returning a product to us (postage pre-paid and insured by the consumer). When returning a defective product, please package the product, the Product Return Form and a copy of the dated sales receipt as proof of purchase. Be sure to mark the RA number on the Product Return Form. If the product is returned without a dated sales receipt, it will be excluded from coverage under this warranty. Please allow 4 to 6 weeks for delivery of repaired or replacement vahiclac (danandina an weiss leneeet\
ae eg ee eee, CREME ie:
New Bright Industries liability for defects in materials and workmanshi replacement at our sole discretion. In no event s damanne baunnn to divccce cee ik dk p under this warranty shall be limited to repair or hall we be responsible for incidental, consequential or contingent SE NEEL EE IILG SAIS MAIIGL IO HOU AMOW TNS EXClusiON or limitation). Valid only in the USA & Canada. Contact New Bright Industries Customer Service Toll Free at:
1-877-NBI-TOYS
(1-877-624-8697) Monday through Friday 2:00 AM tn E:0n DAA Cacao Te. OE EEE NA NN EYE RQOOLCTEE THI
, Valid only in the USA & Canada. Contact New Bright Industries Customer Service Toll Free at:
1-877-NBI-TOYS
(1-877-624-8697) Monday through Friday, 8:00 AM to 5:00 PM Eastern Time U.S. Toy Sales and Marketing Co. Inc. 30260 Oak Creek Drive 2nd Floor Wixom MI 48393. 1-877-624-8697 http:/Avww.newbright.com/