Precautions and Care PULA! OEM) POD ici NOT RECOMMENDED FOR CHLOREN UNDER 8 YEARS OF AGE AS WITH ALL ELECTRIC PRODUCTS, PRECAUTIONS IF BE OBSERVED DURING HANDLING AND USE 70 PREVENT ELECTRIC ae SHOCK, INPUT: 120V AC ik OUTPUT: 9.6V DC 500mA, PSOL CS, Wipe body with a Do not use chemicals Brush areas where Switch vehicle OFF soft rag or cloth. or water to clean dirt gets trapped. when not in use. WALL OWNERS MANUAL Beto] io. || tegen ers 2 HARD a aa Pell s GET WET C6 aD ALO), Q
: yuo if VO: G 174 s OBJECT:
Please read and understand all precautions prior to use. cts Thank you for choosing a premium New Bright product. Locate the body pins on top of vehicle body. ;
Pull pins as shown and set aside. Lift and remove body shell. ew
L897129116/JN426-18 Component Checklist
(1) Vehicle ursrom 10N CHARGER
(4) Body Pins (1) Battery Charger (1) 9.6V Battery Pack (3) AAA Batteries CAUTION!
Do not recharge Battery Pack if it is hot or warm to the touch. Allow Battery Pack to cool before recharging. Recharging a hot or warm Battery Pack will shorten the life of the Pack. '
Do not recharge a Battery Pack if it appears to be damaged or leaking. Always unplug Charger when not in use. Always remove Battery Pack from Battery Compartment when not in use. Do not dispose batteries in fire. Leakage, explosion and personal injury may occur. Dispose of Lithium lon Battery Pack properly. Do not attempt to disassemble Battery Pack or Charger. Do not use Battery Charger for any use other than instructed in this booklet. Only an adult should charge Batteries. Do not attempt jumps or tricks with this vehicle. Battery Installation Locate and align arrow on battery pack with arrow inside battery compartment. Place battery pack in battery compartment and slide battery forward in direction of artow. Once in place, turn locking tab to keep battery pack secure.*
*If battery pack is not completely in place locking tab will not fully turn. Features ON/OFF Switch
Ca
Al aa
* If vehicle pulls to the left or right during forward driving the Steering Trim may need to be adjusted. The Steering Trim is located on bottom of chassis between the front wheels. Wheel Alignment
(Steering Trim) yA Battery Charging Battery Installation
| 1. Remove screw and slide to open battery compartment cover on transmitter. IMPORTANT!
. Pl The included 9.6V Lithium lon battery pack is only PARTIALLY CHARGED prior
. Insert 3 AAA size batteries. f to shipment and it is recommended the battery be fully charged before first use. Make sure the positive (+) and ngative (-) markings on the batteries match up to the ones inside the Battery Compartment. Replace the Battery Compartment Cover Charging Status making certain that the Compartment tab Light has snapped into the locked position. Replace the screw. Battery Charger Note: When replacing Transmitter batteries: 2 | nal t Do not mix old and new batteries. Do not mix alkaline, standard or rechargeable batteries. Use alkaline batteries only:
Release Button Push and Hold Button Functions To Remove Battery Syncing 9.6V Battery Pack This transmitter is
| equipped with 2.4GHz
| technology which allows oe 1. Insert the 9.6V Lithium lon rechargeable battery pack securely into the charger and push up to 12 vehicles to be up to lock. Be sure the arrows are properly matched (as shown above).
| raced at the same time. 2. Plug the Charger into a standard indoor electrical outlet. This power unit is intended to be correctly orientated in a vertical or wall mount position. 3. Allow battery to charge for 1-1.5 Hours. Charging Status Light will be solid red while battery is charging. When charging is complete, light will blink green.
| When both the vehicle and transmitter have the batteries correctly installed and turned on, 4. To remove the battery, press and hold the release button and slide battery down to unlock. the transmitter will 5. Charge will last approximately 12 minutes depending on terrain and driving style. automatically sync with the vehicle IMPORTANT: It is normal for the battery pack to become warm after charging and/or use. Be sure to allow the battery pack to cool before using or recharging. Recharging a warm battery pack will greatly reduce the battery life. ATTENTION PARENTS:
* The Battery Charger & Battery Pack need to be periodically examined for potential hazards. Any potentially hazardous parts need to be repaired or replaced. UO] a Trouble Shooting & Support Problem - Vehicle does not move or moves slowly.
- Has the Battery Pack been installed in the vehicle?
- Has the rechargeable Battery Pack been fully charged?
- Are the metal contact tabs touching, rusty or dirty in the battery compartment?
_. ~ Make certain there are fresh alkaline batteries in the transmitter and that they have been installed in the correct position.
- Are the (+) and () markings on the alkaline batteries in the same position as the (+) and () markings in the Transmitter Battery Compartment?
- Are the (+) and (-) markings on the Battery Pack in the same position as the
(+) and () markings in the Battery Compartment?
- Make certain that the vehicle ON/OFF switch is in the ON position. Problem - Vehicle moves by itself or exhibits reduced range from the transmitter.
- Make certain there is no outside radio interference in your area. The best way to test this is to take the vehicle as far away from radio towers, electrical lines or tall buildings as possible to ensure no further radio interference will occur.
FCC CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna. ;
- Increase the separation between the equipment and receiver.
- - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. This device complies contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s).
, Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Lmetteur/rcepteur exempt de licence contenu dans le prsent appareil est conforme aux CNR dInnovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes : (1) Lappareil ne doit pas produire de brouillage; (2) Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. USA & Canada 30-Day Limited Warranty New Bright Industries warrants to the original purchaser that this product will be free of defects in materials and workmanship for thirty (30) days from the date of purchase. In the event of such defect within the warranty period, New Bright will repair or replace the product at our sole discretion. This warranty does not cover damage resulting from unauthorized modifications, accident, misuse or abuse. Should your item have a defect covered under this warranty, first call the toll free number listed below. Most problems can be resolved in this manner. If necessary, you will be issued a Return Authorization (RA) number and instructions on how to obtain a Product Return Form. The Product Return Form is to be used when returning a product to us (postage pre-paid and insured by the consumer). When returning a defective product, please package the product, the Product Return Form and a copy of the dated sales receipt as proof of purchase. Be sure to mark the RA number on the Product Return Form. If the product is returned without a dated sales receipt, it will be excluded from coverage under this warranty. Please allow 4 to 6 weeks for delivery of repaired or replacement vehicles (depending on your location). New Bright Industries liability for defects in materials and workmanship under this warranty shall be limited to repair or replacement at our sole discretion. In no event shall we be responsible for incidental, consequential or contingent damages (except in those states that do not allow this exclusion or limitation). Valid only in the USA & Canada. Contact New Bright Industries Customer Service Toll Free at:
1-877-NBI-TOYS
(1-877-624-8697) Monday through Friday, 8:00 AM to 5:00 PM Eastern Time REF- 6.9 13018 8102