FCC ID: G6D31HHA TOY Transmitter

| Component Checklist 8 ponent Checklist | Battery Installation Installation | Functions | Functions Light-Up Eyes rs 1. To open battery compartment cover on transmitter, slide in the direction indicated by the arrow. Left Tread Control Right Tread Control a mp at te ee \~_ _ ~/

ee Ree FEN OS ee ee (_ NUL. Make sure the positive (+) and negative (-) markings on the batteries match up to the ones Vehicle has working lights. When vehicle is USB Charging Cord Screw Hole for inside the Battery Compartment. } \ powered ON, eyes will glow. When vehicle is in Compartment Cover Pi il 3. Replace the Battery Compartment Cover making certain that the Compartment tab has Cc) motion; eye corr: will change: o 2 snapped into the locked position. aN a. f FORWARD AND REVERSE DRIVING Ls Toa} fy FORWARD DRIVING

| IE Push BOTH joysticks forward for Forward Driving. REVERSE DRIVING Pull BOTH joysticks backward for Reverse Driving.

| | Note: When replacing Transmitter batteries:

DO NOT MEX OFC Bnd New Dattenes. a)RCT Do not mix alkaline, standard or rechargeable batteries. TURNING NOS

(1) Use alkaline batteries only, ON / OFF Switch smbleBee RIGHT TURNING

| | Push LEFT joystick forward _ Charging Cord _ Chargii forward. Pull LEFT joystick

\ UJ to turn right while driving Raa es 8 1_I Lt back to turn right in reverse. | Charging This vehicle is equipped with an internal Lithium-Ion battery that is recharged via USB. ON/OFF Switch must be in the OFF position prior to charging. used at the same time. TEMS WGTDSTRter I> CUM POU WILE 2.SN TIE COCTIOIOGY WERE GHOWS Up tU 0 VEFICICs 10 De | |

LEFT TURNING Push RIGHT j To evnc trancmitter and vehicle fnilaw thece ctanc:

[Y_W"

Pm 1. Install batteries in Transmitter. Canon lleteaaiabric teats ates Nwca tame |

forward, Pull RIGHT joystick back to turn left in reverse. 1, Locate the Charging Cord Compartment Cover on the underside of vehicle. 2. Use a screwdriver to remove the small screw keeping the cover in place.

& Paras 1IGR vahia fir the Charan Camnatinant (lek rane whan antandind cord ae te ke 2. Turn on Vehicle. Once the batteries are installed and the vehicle is turned on, the Transmitter will sync

= ad =

attached to inside internal battery). Cord can be plugged into any computer or USB outlet brick

(not included). 4. Insert the U5b connector into a computer or other U56 power source. 5. While charging, the Charging Status Light under the vehicle will be on. Once fully charged the light will turn off. Charging is completed in approximately 2 hours (when charaing from a

) ae NU | ee Se ee eee |

(1) Transmitter (2) AA Batteries | | Sound ll computer). 6. After charging is complete, store the USB cord in the Charging Cord Compartment. Replace the L. 7

=~ SS a 4 360 SPINS - Clockwise 360 SPINS - Counter-Clockwise Touch the head to hear Laughing sound. Push joysticks as shown for Push joysticks as shown for

| | | | | Clockwise Spinning. Counter-Clockwise Spinning. | | ee ee ae a ee ee |

Semmens

| Precautions and Care and Care | Trouble Shooting Shooting

| AI [fe | | tL | | | Problem - Vehicle does not move or moves slowly. NES - Has the rechargeable Internal Battery been fully charged?

- Make certain there are fresh alkaline batteries in the transmitter and that they Wipe body wit Do not use Seema Brush areas where Switch vehicle OFF NAVE BES ISTAeC IT ae: COMECE PUSstaOn. se EE Se pipe - Are the (+) and (-) markings on the alkaline batteries in the same position as the PR Poe eae, Oe tO, Oe EO SL Se ey ee eT |

DONOT ORIVEON SAND bs Ja atetenel 4, Te sa

- Make certain that the vehicle ON/OFF switch is in the ON position. Se ee eee Se ee ee OUTIN

) THESUN Problem - Vehicle moves by itself or exhibits reduced range from the transmitter.

- Make certain there is no outside radio interference in your area. The best way to ails Ok UNS FS WU LGRE HIR VEINS Go IGE GWaYy PULTE FGUI LUWEIO, CISUMILGE MICS UE Late eee buildings as possible to ensure no further radio interference will occur. USA & Canada holt 30-Day Limited Warranty Api yr -_rivvViivVl ff am Ye e.e s VhtL_oew.s.e RUN INTO New Bright Industries warrants to the original purchaser that this product will be free of defects in Ww Wwe ewebe FR es EW ELC SS Go 2S HARD materials and workmanship for thirty (30) days from the date of purchase. In the event of such defect A 5 OBJECTS within the warranty period, New Bright will repair or replace the product at our sole discretion. This Please read and understand all precautions prior to use. warranty does not cover damaae resulting from unauthorized modifications. accident. misuse or abuse. l - ] 7 ll aE aie Should your item have a defect covered under this warranty, first call the toll free number listed below. Thank you for choosing a premium New Bright product.

| CAUTION! Most problems can be resolved in this manner. If necessary, you will be issued a Return Authorization F.C.C. CAUTION: number (RA) and instructions on how to obtain a Product Return Form. The Product Return Form is to be

- nt Changes or modifications not expressly approved by the party responsible for compliance could void the used when returning a product to us (postage pre-paid and insured by the consumer). Do not recharge Internal Battery if vehicle is hot or warm to the touch. Allow Battery to user's authority to operate the equipment. cool before recharging. Recharging a hot or warm Battery will shorten the life of the unit. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditior sro ard ay Vb 90 Ues, Prensa 6 Dror tay Petia Petar Soe ed eye the dated sales receipt as proof of purchase. Be sure to mark the RA number on the Product Return a (1) this device may not cause harmful interference, and (2) this device must accept any interference Form. If the product is returned without a dated sales receipt, it will be excluded from coverage under this Do not recharge the Internal Battery if it appears to be damaged or leaking. received, including interference that may cause undesired operation. warranty. Please allow 4 to 6 weeks for delivery of repaired or replacement vehicles (depending on your location). Alwavs store charaina cord in storage compartment when not in use.

" . i a ai " New Bright Industries liability for defects in materials and workmanship under this warranty shall be Do not dispose batteries in fire. Leakage, explosion and personal injury may occur. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, limited to repair or replacement at our sole discretion. In no event shall we be responsible for incidental, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection consequential or contingent damages (except in those states that do not allow this exclusion or limitation). against harmful interference in a residential installation. This equipment generates, uses and can ee eS | ee, ee ee ee Leen: |

eae baal ee Nr ceria he ee aa at rie a ee ee Ba Noe al Fadiate radio Trequency energy ana, If NOt installed and Used In accordance with the instructions, tr onl dult should ch Batteri may calle fern ul interference to foci Soe) However, fae is no Suarantes a NVald coly inthe USA'& Canece:

nly an adult should charge Batteries. interference will not occur in a particular installation. If this equipment does cause harm! i i interference to radio or television reception, which can be determined by turning the equipment Contact New Bright Industries Customer Service Toll Fieelat:

VO NOT atLeEMpPC JUMPS OF TICKS WITH thls venice, OFF ang on, Me User Is Encouraged tO Uy to Correct tne interference Dy one of more oF Me '1-877-624-869 following measures: _ (1-877 7) Monday through Friday, 8:00 AM to 5:00 PM Eastern Time

- Reorient or relocate the receiving antenna. - 00S tied Ritinn aiid taint ent:

~ Increase the separation between the equipment and receiver. : 30260 Oak Creek Drive 2nd Floor

- Connect the equipment into an outlet on a circuit different from that to which the Wixom MI 48393 receiver is connected. 1-877-624-8697

- Consult the dealer or an experienced radio/TV technician for help. py TR RT Ea ano |

REF- 8173 920102 JN369-20

FCC CAUTION:

Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help. This device complies contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). 4 Operation is subject to the following two conditions: (1) This device may not cause Zo. interference; and (2) This device must accept any interference, including interference that R may cause undesired operation of the device. Couisinrtors Lmetteur/rcepteur exempt de licence contenu dans le prsent appareil est conforme aux NEW BRIGHT CNR dInnovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. L exploitation est autorise aux deux conditions suivantes : (1) Lappareil ne doit pas produire de brouillage; (2) Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. L948177021/JN216-14

2.4GHz New Biche A Made in China This device complies with part 15 of the FCC Rules. ited is subject to the icllewinghivic conditions:

i this device may not cause harmful interference, and this device must accept any interference received, including interference that may cause undesired operation. 2.4GHz IC:9650A-31Fip, Model: 31HHA Modle: 31HHA

Date: 02/04/2021 Federal Communications Commission 7435 Oakland Mills Road Columbia MD 21046 To whom it may concern:

I, the undersigned, hereby authorize UL Verification Services Inc. to act on our behalf in all manners relating to application for equipment authorization, including signing of all documents relating to these matters. Any and all acts carried out by UL Verification Services Inc. on our behalf shall have the same effect as acts of our own. I, the undersigned, hereby certify that we are not subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 853(a). In authorizing UL Verification Services Inc. as our representative, we still recognize that we are responsible to:

a) comply with the relevant provisions of the certification program;

b) c) d) e) make all necessary arrangements for the conduct of the evaluation, including provision for examining documentation and access to all areas, records (including internal audit reports) and personnel for the purposes of evaluation (e.g. testing, inspection, assessment, surveillance, reassessment) and resolution of complaints;

make claims regarding certification only in respect of the scope for which certification has been granted;

do not use our product certification in such a manner as to bring the Certification Division into disrepute and not make any statement regarding our product certification which the Certification Division may consider misleading or unauthorized;

upon suspension or cancellation of certification, discontinue use of all advertising matter that contains any reference thereto and return any certification documents as required by the Certification Division;

f) g) h) i) j) use certification only to indicate the products are certified as being in conformity with specified standards;

endeavor to ensure that no certificate or report nor any part thereof is used in a misleading manner;

ensure that any reference to our product certification in communication media such as documents, brochures or advertising, complies with the requirements of the Certification Division;

keep a record of all complaints made known to us relating to the products compliance with requirements of the relevant standard and to make these records available to the when requested;

take appropriate action with respect to such complaints and any deficiencies found in products or services that affect compliance with the requirements for certification;

k) document the actions taken. This authorization is valid until further written notice from the applicant. Sincerely Yours, Signed by:

Company Name: New Bright Industrial Co Ltd Contact Name: Eric Kwok Title of PersonQuality Manager Address: New Bright Bldg 11 Sheung Yuet Road, Kowloon Bay Kowloon, Hong Kong

Federal Communications Commission 7435 Oakland Mills Road Columbia MD 21046 Subject:

Request for Confidentiality FCC ID:

G6D31HHA To Whom It May Concern:

Pursuant to the provisions of Sections 0.457 and 0.459 of the Commissions rules (47 CFR 0.457, 0.459), we are requesting the Commission to withhold the following attachments as confidential document from public disclosure indefinitely. Schematic Diagram Block Diagram Theory of Operation Above mentioned document contains detailed system and equipment description are considered as proprietary information in operation of the equipment. The public disclosure of above documents might be harmful to our company and would give competitor an unfair advantage in the market. It is our understanding that all measurement test reports, FCC ID label format and correspondent during certification review process cannot be granted as confidential documents and those information will be available for public review once the grant of equipment authorization is issued. Best Regards Company Name: New Bright Industrial Co., Ltd. Contact Name: Eric Kwok Title of Person: Quality Manager Address: New Bright Building 11 Sheung Yuet Road, Kowloon Bay, Kowloon Hongkong Date: 11/04/2021