FCC ID: G6D43HCW TOY Transmitter

TROUBLESHOOTING & SUPPORT Problem - Boat does not move or moves slowly.

- Make certain the water sensor is making contact with water.

- Make certain there are fresh alkaline batteries in the transmitter and that they have been installed in the correct position.

~ Are the (+) and (-) markings on the alkaline batteries in the same position as the (+) and (-) markings in the Transmitter Battery Compartment?

~ Has the intemal battery in the boat been charged?

- Are the metal contact tabs touching, rusty or dirty in the transmitter?

Problem - Boat moves by itself or exhibits reduced range from the transmitter.

- Make certain there is no outside radio interference in your area. The best way to test this is to take the vehicle as far away from radio towers, electrical lines or tall buildings as possible to ensure no further radio interference will occur. PROPER USE, PRECAUTIONS & CARE Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment, This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful intererence in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will nol occur in a particular installation,

'Y this equipment does cause harmlul interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

= Increase the separation between the equipment and receiver.

= Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radho/TV technician for help. OWNERS MANUAL Please read and understand all precautions prior to use. USA & Canada 30-Day Limited Warranty New Bright Industries warrants tothe orginal purcaser that this product wil be free of defects in materials ane workmanship for tity

(G0) days from the date of purchase. nthe event of such defect within the waranty period, Mew Bright wil repair or replace the product at our sole discretion. This warranty does not cover damage resuiting from unauthorized modifications, accident, misuse or abuse. Should your item have a defect covered under this warranty, frst call the tll free number listed below. Most problems can be resolved in thes manner. ff necessary, you wal be issued 2 Return Authorization (RA) number and instructions on how to cbtain a Product Return Form. The Product Return Form isto be used when retuming a product tous (postage pre paid and insured by the consumer). When returning a defective product please package the produc, the Product Retum Farm and a copy ofthe dated sles receipt as proof of perchase. Be ste to mark the RA number on the Product Return Form. the produc is returned without dated sales receipt, it wl be exch fom coverage under tis warranty. Please allow 4 1 6 weeks fer dear of repaired ex replacement vehicles (depending on you bastion. ew Bright Industries bility for defects in materias and workmanship under this werranty shall be fmited to repair or replacement at ax sole discretion. no event shall we be responsible for incdental, consequential or contingent damages (except in those states that dont allow this excusian or limitation).

\Valed only in the USA & Canada. Contact New Bright Industries Customer Service Tol Free at:

1-877-NBHTONS

(1-877-624-8697) Mondoy through Friday, 8:00 AM 10 5:00 PM Easter Teme U.S. Toy Sales and Marketing Co. Inc. 30260 Oak Creek Drive ~ 2nd Floor Wixom Mi 48393 1-877-624-8697 tp siwwrenewbright com!

TRANSMITTER BATTERY INSTALLATION BOAT FUNCTIONS 1. To open battery compartment cover on transmitter, remove the 4 small screws and set aside. 2. insert 2 AA size batteries. Water Sensor we arene eteen imate atewtemeaneym secs A ae ese elt team seme This is a safety feature that prevents the propeller 3. Replace and tighten the 4 small screws to secure the battery compartment cover. from running unless the boat is in water. Note:

CHARGING INSTRUCTIONS How to Charge:

1 Raise charging plug at top of controller. Auto pairing:

: R = 3.Plug the charging stick into the 4. Install batteries in transmitter charging pert on the top side of the Forward/Reverse 2.Tum vehicle ON/FF switch to the ON position Drive 4.Press any button on the controller to begin charging. The charging 3. Indicator light on transmitter featontor Rgnt cn in covercber ol will Nash for pairing. in { 8. When charging is completed, in flashing porno Koopa approximately 15 minutes. the You are now ready to play. | charging indicator light will tun otf

ana y eel Pert eT enE A Re eae Ts ee OL Ue iat CMa ean ewer) this device must accept any interference received, including interference that may cause undesired operation.

Date: 02/04/2021 Federal Communications Commission 7435 Oakland Mills Road Columbia MD 21046 To whom it may concern:

I, the undersigned, hereby authorize UL Verification Services Inc. to act on our behalf in all manners relating to application for equipment authorization, including signing of all documents relating to these matters. Any and all acts carried out by UL Verification Services Inc. on our behalf shall have the same effect as acts of our own. I, the undersigned, hereby certify that we are not subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 853(a). In authorizing UL Verification Services Inc. as our representative, we still recognize that we are responsible to:

a) comply with the relevant provisions of the certification program;

b) c) d) e) make all necessary arrangements for the conduct of the evaluation, including provision for examining documentation and access to all areas, records (including internal audit reports) and personnel for the purposes of evaluation (e.g. testing, inspection, assessment, surveillance, reassessment) and resolution of complaints;

make claims regarding certification only in respect of the scope for which certification has been granted;

do not use our product certification in such a manner as to bring the Certification Division into disrepute and not make any statement regarding our product certification which the Certification Division may consider misleading or unauthorized;

upon suspension or cancellation of certification, discontinue use of all advertising matter that contains any reference thereto and return any certification documents as required by the Certification Division;

f) g) h) i) j) use certification only to indicate the products are certified as being in conformity with specified standards;

endeavor to ensure that no certificate or report nor any part thereof is used in a misleading manner;

ensure that any reference to our product certification in communication media such as documents, brochures or advertising, complies with the requirements of the Certification Division;

keep a record of all complaints made known to us relating to the products compliance with requirements of the relevant standard and to make these records available to the when requested;

take appropriate action with respect to such complaints and any deficiencies found in products or services that affect compliance with the requirements for certification;

k) document the actions taken. This authorization is valid until further written notice from the applicant. Sincerely Yours, Signed by:

Company Name: New Bright Industrial Co Ltd Contact Name: Eric Kwok Title of PersonQuality Manager Address: New Bright Bldg 11 Sheung Yuet Road, Kowloon Bay Kowloon, Hong Kong

Federal Communications Commission 7435 Oakland Mills Road Columbia MD 21046 Subject: Request for Confidentiality FCC ID: G6D43HCW To Whom It May Concern:

Pursuant to the provisions of Sections 0.457 and 0.459 of the Commissions rules (47 CFR 0.457, 0.459), we are requesting the Commission to withhold the following attachments as confidential document from public disclosure indefinitely. Schematic Diagram Block Diagram Theory of Operation Above mentioned document contains detailed system and equipment description are considered as proprietary information in operation of the equipment. The public disclosure of above documents might be harmful to our company and would give competitor an unfair advantage in the market. It is our understanding that all measurement test reports, FCC ID label format and correspondent during certification review process cannot be granted as confidential documents and those information will be available for public review once the grant of equipment authorization is issued. Best Regards Company Name: New Bright Industrial Co Ltd Contact Name: Eric Kwok Title of PersonQuality Manager Address: New Bright Bldg 11 Sheung Yuet Road, Kowloon Bay Kowloon, Hong Kong Date: 02/04/2021