IDeA! DERE) PRD M NOT RECOMMENDED F0R CHILDREN UNDER YEARS OF AGE. AS WITH ALL ELECTRIC PRODUCTS, PRECAUTIONS SHOULD BE
| ay DURING HANDLING AND USE 10 PREVENT ELECTRIC
SHOGK, INPUT: 120V AC GOH 10W, OUTPUT: 9.6V DC 500m WAV ETE OWNERS MANUAL Please read and understand all precautions prior to use. Thank you for choosing a premium New Bright product. L856104745/JN227-18 Vehicle Featu res and Functions ON/OFF Charging the Battery Charging Status Light
~ Battery Charger Push and
= Hold Button To Remove
~ 9.6V Battery Pack 1. Insert the 9.6V Lithium lon rechargeable battery pack securely into the charger and push up to lock. Be sure the arrows are properly matched (as shown above). 2. Plug the Charger into a standard indoor electrical outlet. This power unit is intended to be correctly orientated in a vertical or wall mount position. 3. Allow battery to charge for 1-1.5 Hours. Charging Status Light will be solid red while battery is charging. When charging is complete, light will blink green. 4. To remove the battery, press and hold the release button and slide battery down to unlock. 5. Charge will last approximately 12 minutes depending on terrain and driving style. IMPORTANT: It is normal for the battery pack to become warm after charging and/or u sure to allow the battery pack to cool before using or recharging. Recharging a warm b pack will greatly reduce the battery life. ATTENTION PARENTS:
* The Battery Charger & Battery Pack need to be periodically examined for potential hazards. Any potentially hazardous parts need to be repaired or replaced. Vehicle Battery Installation Locate and align arrow on battery pack with arrow inside battery compartment. Place battery pack in battery compartment and slide battery forward in direction of arrow. Once in place, turn locking tab to keep battery pack secure. If battery pack is not completely in place, locking tab will not fully turn. Charging the Battery Charging Status Light
- Battery Charger Push and
~~ Hold Button To Remove 9.6V Battery Pack 1. Insert the 9.6V Lithium lon rechargeable battery pack securely into the charger and push up to lock. Be sure the arrows are properly matched (as shown above). 2. Plug the Charger into a standard indoor electrical gutlet. This power unit is intended to be correctly orientated in a vertical or wall mount position. 3. Allow battery to charge for 1-1.5 Hours. Charging Status Light will be solid red while battery is charging. When charging is complete, light will blink green. 4. To remove the battery, press and hold the release button and slide battery down to unlock. 5. Charge will last approximately 12 minutes depending on terrain and driving style. IMPORTANT: It is normal for the battery pack to become warm after charging and/or use. Be sure to allow the battery pack to cool before using or recharging. Recharging a warm battery pack will greatly reduce the battery life. _ ATTENTION PARENTS:
+ The Battery Charger & Battery Pack need to be periodically examined for potential hazards. Any potentially hazardous parts need to be repaired or replaced. Vehicle Battery Installation
) Locate and align arrow on battery pack with arrow inside battery compartment. Place battery pack in battery compartment and slide battery forward in direction of arrow. Once in place, turn locking tab to keep battery pack secure. If battery pack is not completely in place, locking tab will not fully turn. Transmitter | Proper Use a on p RC oy _ |
ies?
inl! a
: DRIVE FORWARD REVERSE FORWARD/REVERSE DRIVING Push BOTH joysticks forward for Forward Driving. Pull BOTH joysticks back to drive in Reverse. Switch vehicle OFF : . Brush areas where :
when not in use. dirt gets trapped. 360 SPINS Counter-Clockwise 360 SPINS - Clockwise Push both joysticks in opposite Push both joysticks in opposite directions continuously as shown for directions continuously as shown for Counter-Clockwise Spinning. Clockwise Spinning. This transmitter is equipped with 2.4GHz technology which allows up to 6 vehicles to be raced at the same time. S Wipe body with a Do not use chemicals The transmitter will automatically sync with the vehicle. soft rag or cloth or water to clean Trouble shooting & Support Problem - Vehicle does not move or moves slowly.
- Make certain there are fresh batteries in the transmitter and that they have been installed in the correct position.
- Are the (+) and () markings on the batteries in the same position as the (+) and (-) markings in the Transmitter Battery Compartment?
- Has the Battery Pack been installed in the vehicle?
- Has the rechargeable Battery Pack been fully charged?
- Are the (+) and (-) markings on the Battery Pack in the same position as the (+) and
(-) markings in the Battery Compartment?
- Are the metal contact tabs touching, rusty or dirty in the transmitter?
- Make certain that the vehicle ON/OFF switch is in the ON position. Problem - Vehicle moves by itself or exhibits reduced range from the transmitter.
- Make certain there is no outside radio interference in your area. The best way to test this is to take the vehicle as far away from radio towers, electrical lines or tall buildings as possible to ensure no further radio interference will occur.
FCC CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. :
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV tchnician for help. New Bright Cautions Do not recharge Battery Pack if it is hot or warm to the touch. Allow Battery Pack to cool before recharging. Recharging a hot or warm Battery Pack will shorten the life of the Pack. Do not recharge a Battery Pack if it appears to be damaged or leaking. Always unplug Battery Charger when not in use. Always remove Battery Pack from Battery Compartment when not in use. Do not dispose batteries in fire. Leakage, explosion and personal injury may occur. Dispose of Lithium-lon Battery Pack properly. Do not attempt to disassemble Battery Pack or Charger. Do not use Battery Charger for any use other than instructed in this booklet. Only an adult should charge Batteries. Do not attempt jumps or tricks with this vehicle. This device complies with industry Canada licence-exempt RSS standard(s) Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est contorme aux CNA dindustrie Canada applicables aux appareils radio exempls de licence. L'exploitation est autorise aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de apareil doit accepter tout brouitage radiotlectrique subi, mme sie broullage est susceptible Gen compromette le fonctionnement. New Bright Warranty Information USA & Canada :
30-Day Limited Warranty New Bright Industries warrants to the original purchaser that this product will be free of defects in materials and workmanship for thirty (30) days from the date of purchase. In the event of such defect within the warranty period, __,New Bright will repair or replace the product at our sole discretion. This warranty does not cover damage resulting from unauthorized modifications, accident, misuse, or abuse. Should your item have a defect covered under this warranty, first call the toll free number listed below. Most problems can be resolved in this manner. If necessary, you will be issued-a Return Authorization (RA) number and instructions on how to obtain a Product Return Form. The Product Return Form is to be used when returning a product to us (postage pre-paid and insured by the consumer). When returning a defective product, please package the product, the Product Return Form and a copy of the dated sales receipt as proof of purchase. Be sure to mark the RA number on the Product Return Form. If the product is returned without a dated sales receipt, it will be excluded from coverage under this warranty. Please allow 4 to 6 weeks for delivery of repaired or replacement vehicles (depending on your location). New Bright Industries liability for defects in materials and workmanship under this warranty shall be limited to repair or replacement at our sole discretion. In no event shall we be responsible for incidental, consequential or contingent damages (except in those states that do not allow this exclusion or limitation). Valid only in the USA & Canada. Contact New Bright Industries Customer Service Toll Free at:
1-877-NBI-TOYS
(1-877-624-8697) Monday through Friday, 8:00 AM to 5:00 PM Eastern Time Transmitter Battery Installation 1. Locate the Transmitter Battery Compartment, which is on the back of the Transmitter. 2. Move the Battery Compartment Lock towards the Battery Compartment and remove the Battery Compartment Cover. 3. Insert 2 AA batteries. Make certain the plus (+) and minus () markings on the batteries are in the same position as the plus (+) and minus () markings inside the Battery Compartment. 4. Replace Battery Compartment Cover making certain that the Battery Compartment Lock has snapped into the locked position. Note: When replacing batteries:
Use alkaline batteries only. Do not mix old and new batteries Do not mix alkaline, standard or rechargeable batteries.