Veh Cautions & Care PROPER USE AND CARE Wipe with soft rag or cloth. Do not use chemicals or water to clean. Brush areas where dirt gets trapped. Switch vehicle to OFF when not in use. Do not leave out in the sun. Do not run into hard objects. Do not drive on sand. Do not get wet. CAUTION!
Do not recharge Internal Battery if vehicle is hot or warm to the touch. Allow Battery to cool before recharging. Recharging a hot or warm Battery will shorten the life of the unit. Do not recharge the Internal Battery if it appears to be damaged or leaking. Always store charging cord in storage compartment when not in use. Do not dispose batteries in fire. Leakage, explosion and personal injury may occur. Do not attempt to disassemble or remove Internal Battery or charging cord. Only an adult should charge Batteries. Do not attempt jumps or tricks with this vehicle. upport Bicol le) aexed Lae) Problem - Vehicle does not move or moves slowly. Problem - Vehicle moves by itself or exhibits reduced range from the transmitter. Problem - App is not controlling vehicle.
- Has the rechargeable Internal Battery been fully charged?
- Make certain there are fresh alkaline batteries in the transmitter and that they have been installed in the correct position.
- Are the (+) and () markings on the alkaline batteries in the same position as the
(+) and (-) markings in the Transmitter Battery Compartment?
- Make certain that the vehicle ON/OFF switch is in the ON position.
- Make certain there is no outside radio interference in your area. The best way to test this is to take the vehicle as far away from radio towers, electrical lines or tall buildings as possible to ensure no further radio interference will occur.
- Make certain the proper connection or permission has been enabled on your device. Contact New Bright Industries Customer Service Toll Free at:
1-877-NBI-TOYS :
(1-877-624-8697) Monday through Friday, 8:00 AM to 5:00 PM Eastern Time U.S. Toy Sales and Marketing Co. Inc. 30260 Oak Creek Drive 2nd Floor Wixom MI 48393 1-877-624-8697 http:/www.newbright.com/
FCC CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. Nate Mgt Ley Vehicle has working lights. When vehicle is powered ON, lights will glow Red. When vehicle is in motion the lights will glow Blue. When vehicle stops, lights will glow Red again. ON / OFF Switch Compartment Cover Recharging the Vehicle This vehicle is equipped with an internal Lithium-lon battery that is recharged via USB. ON/OFF Switch must be in the OFF position prior to charging. 1. Locate the Charging Cord Compartment Cover on the underside of vehicle. 2. Open Storage Compartment Cover. 3. Remove USB cable from the Storage Compartment. (Use care when extending cord as it is attached to inside internal battery). Cord can be plugged into any computer or USB outlet brick (not included). 4. Insert the USB connector into a computer or other USB power source. 5, While charging, the Charging Status Light under the vehicle will be on. Once fully charged the light will turn off. Charging is completed in approximately 1.5-2 hours (when charging from a computer). 6. After charging is complete, store the USB cord in the Charging Cord Compartment. Replace the Compartment cover. Beleeiulian-ie TASTE Late St eM icc a) CASAS Batteries come pre-installed in this transmitter. To ensure the batteries remain fresh, there is a protective tab that must be removed prior to use. 1. To open battery compartment cover, remove the small screw and slide it in the direction indicated by the arrow. Locate and remove protective plastic tab. The tab can be discarded. 2. To replace old batteries, open the compartment as described above. Insert 2 AA" size batteries. Make sure the positive (+) and negative (-) markings on the batteries match up to the ones inside the Battery Compartment. 3, Replace the Battery Compartment Cover making certain that the Compartment tab has snapped into the locked position. Secure cover with screw. Note: When replacing Transmitter batteries:
Do not mix old and new batteries. Do not mix alkaline, standard or rechargeable batteries. Use alkaline batteries only. This transmitter is equipped with 2.4GHz technology which allows up to 6 vehicles to be used at the same time. To sync transmitter and vehicle, follow these steps:
1. Install batteries in Transmitter. 2. Turn on Vehicle. 3. Once the batteries are installed and the vehicle is turned on, the Transmitter will sync automatically with the vehicle. LWA Left Tread Right Tread Control Control a Push BOTH joysticks forward for straight Forward Driving. Pull BOTH joysticks back for straight Reverse Driving. O Push LEFT joystick forward to turn right while driving forward. A Pull LEFT joystick back to turn right in reverse. Push RIGHT joystick forward to turn left while driving forward. Pull RIGHT joystick back to turn left in reverse.