CONTENTS Component Checklist
(1) Vehicle
(4) Body Pins (1) Battery Charger (1) 9.6V Battery Pack (2) AA Batteries ce Ney Do not recharge Battery Pack if it is hot or warm to the touch. Allow Battery Pack to cool before recharging. Recharging a hot or warm Battery Pack will shorten the life of the Pack. Do not recharge a Battery Pack if it appears to be damaged or leaking. Always unplug Charger when not in use. Always remove Battery Pack from Battery Compartment when not in use. Do not dispose batteries in fire. Leakage, explosion and personal injury may occur. Dispose of Lithium lon Battery Pack properly. Do not attempt to disassemble Battery Pack or Charger. Do not use Battery Charger for any use other than instructed in this booklet. Only an adult should charge Batteries. Do not attempt jumps or tricks with this vehicle. 75 i(e 8s Locate and align arrow on battery pack with arrow inside battery compartment. Place battery pack in battery compartment and slide battery forward in direction of arrow. Once in place, turn locking tab to keep battery pack secure. *
*If battery pack is not completely in place locking tab will not fully turn. ee Pest
- ETA pVa Ric Lcleceyg)
* If vehicle pulls to the left or right during forward driving the Steering Trim may need to be adjusted. The Steering Trim is located on bottom of chassis between the front wheels. Locate and remove the Battery Compartment Cover which is located on the front face of the Transmitter. Insert 2 AA size batteries. Make sure the positive (+) and negative (-) markings on the batteries match up to the ones inside the Battery Compartment. Replace the Battery Compartment Cover making certain that the Compartment tab has snapped into the locked position. Note: When replacing Transmitter batteries:
Do not mix old and new batteries. Do not mix alkaline, standard or rechargeable batteries Use alkaline batteries only. ON/OFF Wheel Alignment Switch (Steering Trim) a Vlate dolar Syncing Battery Compartment This transmitter is equipped with 2.4GHz technology which allows up to 12 vehicles to be raced at the same time. When both the vehicle
\ and transmitter have the batteries correctly installed and turned on, the transmitter will automatically sync with the vehicle
LefuRight Steering ON/OFF Switch Battery Charging IMPORTANT!
The included 9.6V Lithium lon battery pack is only PARTIALLY CHARGED prior to shipment and it is recommended the battery be fully charged before first use. Charging Status Light Battery Charger Push and J Hold Button To Remove 9.6V Battery Pack 1. Insert the 9.6V Lithium lon rechargeable battery pack securely into the charger and push up to lock. Be sure the arrows are properly matched (as shown above). 2. Plug the Charger into a standard indoor electrical outlet. This power unit is intended to be correctly orientated in a vertical or wall mount position. 3. Allow battery to charge for 1-1.5 Hours. Charging Status Light will be solid red while battery is charging. When charging is complete, light will blink green. 4. To remove the battery, press and hold the release button and slide battery down to unlock. 5. Charge will last approximately 18 minutes depending on terrain and driving style. IMPORTANT: It is normal for the battery pack to become warm after charging and/or use. Be sure to allow the battery pack to cool before using or recharging. Recharging a warm battery pack will greatly reduce the battery life. ATTENTION PARENTS:
+ The Battery Charger & Battery Pack need to be periodically examined for potential hazards. Any potentially hazardous parts need to be repaired or replaced. PROPER USE Precautions and Care Do not use chemicals Wipe body with a or water to clean soft rag or cloth. Switch vehicle OFF when not in use. Brush areas where dirt gets trapped. DONOT DRIVE ON SAND RUN INTO DONOT HARD = ; . OSES GETWET OBJECTS || * f ee o-
Locate the body pins on top of vehicle body. Pull pins as shown and set aside. e
. Lift and remove body shell. SUPPORT Trouble Shooting & Support Problem - Vehicle does not move or moves slowly.
- Has the Battery Pack been installed in the vehicle?
- Has the rechargeable Battery Pack been fully charged?
- Are the metal contact tabs touching, rusty or dirty in the battery compartment?
- Make certain there are fresh alkaline batteries in the transmitter and that they have been installed in the correct position.
- Are the (+) and (-) markings on the alkaline batteries in the same position as the (+) and (-) markings in the Transmitter Battery Compartment?
- Are the (+) and (-) markings on the Battery Pack in the same position as the
(+) and (-) markings in the Battery Compartment?
- Make certain that the vehicle ON/OFF switch is in the ON position. Problem - Vehicle moves by itself or exhibits reduced range from the transmitter.
- Make certain there is no outside radio interference in your area. The best way to test this is to take the vehicle as far away from radio towers, electrical lines or tall buildings as possible to ensure no further radio interference will occur. FCC CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential instalation. Th is equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. This device complies contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Lmetteur/rcepteur exempt de licence contenu dans le prsent appareil est conforme aux CNR d'Innovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes : (1) Lappareil ne doit pas produire de brouillage; (2) Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. USA & Canada 30-Day Limited Warranty New Bright Industries warrants to the original purchaser that this product will be free of defects in materials and workmanship for thirty (30) days from the date of purchase. In the event of such defect within the warranty period, New Bright will repair or replace the product at our sole discretion. This warranty does not cover damage resulting from unauthorized modifications, accident, misuse or abuse. Should your item have a defect covered under this warranty, first call the toll free number listed below. Most problems can be resolved in this manner. f necessary, you will be issued a Return Authorization (RA) number and instructions on how to obtain a Product Retum Form. The Product Return Form is to be used when returning a product to us (postage pre-paid and insured by the consumer). When returning a defective product, please package the product, the Product Return Form and a copy of the dated sales receipt as proof of purchase. Be sure to mark the RA number on the Product Return Form. If the product is returned without a dated sales receipt, it will be excluded from coverage under this warranty. Please allow 4 to 6 weeks for delivery of repaired or replacement vehicles (depending on your location). New Bright Industries liability for defects in materials and workmanship under this warranty shall be limited to repair or replacement at our sole discretion. In no event shall we be responsible for incidental, consequential or contingent damages (except in those states that do not allow this exclusion or limitation). Valid only in the USA & Canada. Contact New Bright Industries Customer Service Toll Free at:
1-877-NBI-TOYS:
(1-877-624-8697) Monday through Friday, 8:00 AM to 5:00 PM Eastern Time REF- 6.9 12018 226081 GTDC! OED FD OT RECOMMENDED FOR CHILOREN UNDER 8 YEARS OF AGE AS WITH ALL ELEGTRIG PRODUGTS, PRECAUTIONS SHOULD BE OBSERVED DURING MANDLING AND USE TO PREVENT ELECTRIC SHOCK, INPUT: 120V AG 6OH2 10W. OUTPUT: S.6V DC S00mA, ise He OWNERS MANUAL Please read and understand all precautions prior to use. Thank you for choosing a premium New Bright product. 1620112690 /JN283-18 Filename: 81021 Eng(283-18) Front_cu.ai Software: Adobe Illustrator CS5 Color: K+1788c Date: 2018-06-22 By: LiLing