New Bright Industries warrants to the original purchaser that this product will be free of defects in materials and workmanship for thirty (30) days from the date of purchase. In the event of such defe within the warranty period, New Bright will repair or replace the product at our sole discretion. This warranty does not cover damage resulting from unauthorized modifications, accident, misuse or ab OWNERS MANUAL RSD Tale Ble een Maree le lela ORC Thank you for choosing a premium New Bright product. Model No. / Modle : GF64UM UST Bere) 30-Day Limited Warranty ct UhSt =o Should your item have a defect covered under this warranty, first call the toil free number listed below. Most problems can be resolved in this manner. If necessary, you will be issued a Return Authorization number (RA) and instructions on how to obtain a Product Return Form. The Product Return Form is to be used when returning a product to us (postage pre-paid and insured by the consumer). When returning a detective product, please package the product, the Product Return Form and a copy of the dated sales receipt as proof of purchase. Be sure to mark the RA number on the Product Return Form. If the product is returned without a dated sales receipt, it will be excluded from coverage under this warranty. Please allow 4 to 6 weeks for delivery of repaired or replacement vehicles (depending on your location). New Bright Industries liability for defects in materials and workmanship under this warranty shall be limited to repair or replacement at our sole discretion. In no event shall we be responsible for incidental, consequential or contingent damages (except in those states that do not allow this exclusion or limitation). PCR LAUR CMOS. 6 erie B Contact New Bright Industries Customer Service Toll Free at:
1-877-NBI-TOYS
(1-877-624-8697) Monday through Friday, 8:00 AM to 5:00 PM Eastern Time L/JN117-1 New Bright This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Jaulu exempis de licence. L'exploitation est autorise aux deux conditions suivantes
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter dout brouillage radiotectrique subi, mme si le brouillage est susceptible d'en comprometire le fonctionnement lable of Contents Section 1: Table of Contents Section 2: | Component Checklist . Section 3: Vehicle Features & Functions Section 4: Charging the Sra]
Section 5: Transmitter Battery Installation Transmitter Features & Functions Section6: Proper Use Precautions & Care Section 7: Trouble Shooting & Support Le prsent appareil est confarme aux CNR d'industrie Canada applicables aux appareils a E od ee TAN eatures and Functions Charge Wheel Alignment Status Light USB Charging Port ON/OFF Switch
* If vehicle pulls to the left or right during forward driving the Wheel Alignment may need to be adjusted. The Wheel Alignment Dial is located on bottom of chassis between the front wheels. Charging the Battery WA ECO me Um care aT att mot battery that is recharged via USB. ON/OFF Switch must be in the OFF position prior to charging. ort 1. Locate the ON/OFF switch and small USB port on the under-side of the W7>1al el (=m 2. Turn the ON/OFF switch to the OFF position. 3. Insert small end of supplied USB cord into the port. The large end of the supplied cord can be plugged into any computer or USB outlet brick (not included). mm AUER et 10 ao Am ADMD ace maT -M-\atfe RTM ey Mela Mm@ alors fully charged the LED will turn off. Charging is completed in approximately 2 hours. Remove and store cords when not in use. Battery Installation Note: When replacing Transmitter batteries:
EU Cat Melts crewelg] Wd Do not mix old and new batteries. Do not mix alkaline, standard or rechargeable batteries. Features and Functions Forward/Reverse Left/Right Drive Steering This transmitter is equipped with 2.4GHz technology which allows up to 6 vehicles to be raced at the same time. The transmitter will automatically sync with the vehicle. Precautions and Care Switch vehicle OFF Brush areas where when not in use, dirt gets trapped. Do not use chemicals or water to clean. NOTE: This equipment has been tested and found to comply with th FCC Rules. These limits are designed to provide reasonable installation. This equipment generates, uses and can radiate accordance with the instructions, may cause harmful interference to rad that interference will not occur in a particular installation. If this equipme television reception, which can be determined by turning the equipment the interference by one or more of the following measures:
or relocate the enna. the separation equipment and rece the equipment on a circuit different he dealer or an radio/TV technician Trouble Shooting & Support Problem - Vehicle does not move or moves Tea
- Make certain there are fresh alkaline batteries in the transmitter and that the have been installed in the correct position.
- Are the (+) and () markings on the alkaline batteries in the same position as the (+) and (-) markings in the Transmitter Battery Compartment?
- Are the metal contact tabs touching, rusty or or mle Alem Urclacietlltlats
- Has the vehicle been fully charged?
- Make certain that the vehicle ON/OFF switch is in the ON position. Problem - Vehicle moves by itself or exhibits reduced lee Re UR Ce Tea
- Make certain there are no outside radio interference in your area. The best way to test this is to take the vehicle as far away from radio towers, electrical lines or tall buildings as possible to ensure no further radio interference will occur. Always remove Batteries from transmitter when not in use. Do not dispose batteries in fire. Leakage, explosion and personal injury may occur. Do not attempt jumps or tricks with this vehicle. Do not attempt to remove internal battery. Do not use included USB cord for anything other than its intended purpose. Always keep USB cord stored when not in use. Adult supervision recommended. FCC CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. limits for a Class B digital device, pursuant to Part 15 of the Pe Ce lage turn VGC CHC ECG Cate) WR oI cUe ee Mma Cor Lent ece Ry RoR Ue eM aCe mene Cr nt does cause harmful interference to radio or off and on, the user is encouraged to try to correct mele can Cette
- increase elses t Ta a Saori syh into an outlet from that to which the receiver is connected,
- Consult t Cel pez) for help.