PRODUCT INFORMATION Support If you need help, visit: www.cel-fi.com/support. Safety Precautions These products are designed to be used with a direct plug-in power supply unit. When installing the equipment, all the requirements of the manufacturer and the referenced standards must be met. There are no user serviceable parts inside. CAUTION: Changes or modifications to this product not expressly approved by Nextivity may void your right to operate the equipment. Warranty Nextivity Inc provides a limited warranty for its products. For details, please refer to http://cel-
fi.com/warranty Limitation of Liability In no event shall Nextivity, nor its directors, employees, agents, suppliers or End Users, be liable under contract, tort, strict liability, negligence or any other legal or equitable theory with respect to the Products or any other subject matter of this Agreement (i) for any lost profit, cost of procurement of substitute goods or services, or special, indirect, incidental, punitive, or consequential damages of any kind whatsoever or (ii) for any direct damages in excess of (in the aggregate) the fees actually received by Nextivity from End User with respect to the Products actually purchased and paid for. See w w w .cel -fi.com for list of patents covering this product. FCC Trademark Cel-Fi, IntelliBoost, and Nextivity logo are trademarks of Nextivity, Inc. U.S. Headquarters 16550 West Bernardo Drive Building 5, Suite 550 San Diego, CA 92127 PRODUCT INFORMATION WARNING E911 location information may not be provided or may be inaccurate for calls served by using this device. This device may be operated ONLY in a fixed location for in-building use. External Antenna Only the antennas listed in the Antenna Kitting section of the Quick Start Guide are allowed to be used with Cel-Fi Smart Signal Boosters. FCC Statement When used with any mobile device utilizing the 1710-1755 MHz band, the FCC limits booster equipment placement to a maximum of 10 meters above ground level. Installation of this equipment which does not comply with federal requirements may subject the owner to FCC enforcement action. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Compliance Contact Patents In the event of regulatory compliance issue, please contact Nextivity Inc., directly. Contact information is available at www.nextivityinc.com/doc This product is covered by Nextivity, Inc., US patents and patents pending. Please refer to cel-fi.com for details. U.S. Headquarters 16550 West Bernardo Drive Building 5, Suite 550 San Diego, CA 92127