PRODUCT INFORMATION Cel-Fi GO M Smart Signal Booster PRODUCT INFORMATION Cel-Fi GO M Smart Signal Booster STOP!!! Do not call your service provider until you have read the Quick Start Guide. STOP!!! Do not call your service provider until you have read the Quick Start Guide. If you need help, visit: www.cel-fi.com/support. Safety Precautions These products are designed to be used with a direct plug-in power supply unit that shipped with the Network Unit. When installing the equipment, all the requirements of the manufacturer and the referenced standards must be met. There are no user serviceable parts inside. CAUTION: Changes or modifications to this product not expressly approved by Nextivity may void your right to operate the equipment. liable under contract, tort, strict Warranty Nextivity Inc provides a limited warranty for its products. For details, please refer to http://cel-fi. com/warranty. Limitation of Liability In no event shall Nextivity, nor its directors, employees, agents, suppliers or End Users, be liability, negligence or any other legal or equitable theory with respect to the Products or any other subject matter of this Agreement (i) for any lost profits, cost of procurement of substitute goods or services, or special, indirect, incidental, punitive, or consequential damages of any kind whatsoever or (ii) for any direct damages in excess of (in the aggregate) the fees actually received by Nextivity from End User with respect to the Products actually purchased and paid for. See cel-fi.com for list of patents covering this product. Trademark Cel-Fi, trademarks of Nextivity, Inc. This is a CONSUMER device. BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your providers IntelliBoost, and Nextivity logo are consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by the FCC, Innovation, Science and Economic Development Canada or a licensed wireless service provider. WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device. External Antenna:
Only the antennas listed in the Antenna Kitting section of the Quick Start Guide are allowed to be used with Cel-Fi Smart Signal Boosters. FCC Statement (Applicable in the USA only) When used with any mobile device utilizing the 1710-1755 MHz band, the FCC limits booster equipment placement to a maximum of 10 meters above ground level. Installation of this equipment which does not comply with federal requirements may subject the owner to FCC enforcement action. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital de-
vice, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protec-
tion against harmful interference in a residential installation. This equipment generates, uses and If you need help, visit: www.cel-fi.com/support. Safety Precautions These products are designed to be used with a direct plug-in power supply unit that shipped with the Network Unit. When installing the equipment, all the requirements of the manufacturer and the referenced standards must be met. There are no user serviceable parts inside. CAUTION: Changes or modifications to this product not expressly approved by Nextivity may void your right to operate the equipment. liable under contract, tort, strict Warranty Nextivity Inc provides a limited warranty for its products. For details, please refer to http://cel-fi. com/warranty. Limitation of Liability In no event shall Nextivity, nor its directors, employees, agents, suppliers or End Users, be liability, negligence or any other legal or equitable theory with respect to the Products or any other subject matter of this Agreement (i) for any lost profits, cost of procurement of substitute goods or services, or special, indirect, incidental, punitive, or consequential damages of any kind whatsoever or (ii) for any direct damages in excess of (in the aggregate) the fees actually received by Nextivity from End User with respect to the Products actually purchased and paid for. See cel-fi.com for list of patents covering this product. Trademark Cel-Fi, trademarks of Nextivity, Inc. This is a CONSUMER device. BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your providers IntelliBoost, and Nextivity logo are consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by the FCC, Innovation, Science and Economic Development Canada or a licensed wireless service provider. WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device. External Antenna:
Only the antennas listed in the Antenna Kitting section of the Quick Start Guide are allowed to be used with Cel-Fi Smart Signal Boosters. FCC Statement (Applicable in the USA only) When used with any mobile device utilizing the 1710-1755 MHz band, the FCC limits booster equipment placement to a maximum of 10 meters above ground level. Installation of this equipment which does not comply with federal requirements may subject the owner to FCC enforcement action. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital de-
vice, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protec-
tion against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equip-
ment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help ISED STATEMENT BEFORE USE, meet all requirements set out in CPC-2-1-05. This device may operate in a fixed location only, for in-building use. In order to comply with ISED RF Exposure requirements, this device must be installed to provide at least 20 cm separation from the human body at all times. Afin de se conformer aux exigences dexposition RF de ISED, cet appareil doit tre install pour fournir au moins 20 cm de sparation du corps humain en tout temps. The Manufacturers rated output power of this equipment is for single carrier operation. For situations when multiple carrier signals are present, the rating would have to be reduced by 3.5dB, especially where the output signal is re-
radiated and can cause interference to adjacent band users. This power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device.
[FRENCH: La puissance de sortie nominale indique par le fabricant pour cet appareil concerne son fonctionnement avec porteuse unique. Pour des appareils avec porteuses multiples, on doit rduire la valeur nominale de 3,5dB, surtout si le signal de sortie est retransmis et quil peut causer du brouillage aux utilisateurs de bandes adjacentes. Une telle rduction doit porter sur la puissance dentre ou sur le gain, et ne doit pas se faire au moyen dun attnuateur raccord la sortie du dispositif.]
This device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
[FRENCH: Le prsent appareil est conforme aux CNR dIndustrie Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes: (1) lappareil ne doit pas produire de brouillage, et (2) lutilisateur de lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement.]
Gain Bandwidth Input and Output Impedances Output Power Uplink Downlink 58dB (=<1GHz) 65dB (>1GHz) 75Mhz 50 ohm 22dBm per band 16dBm per band Compliance Contact In the event of regulatory compliance issue, please contact Nextivity Inc. directly. Contact information is available at www.nextivityinc.com. Patents This product is covered by Nextivity, Inc., US patents and patents pending. Please refer to cel-fi.com for details. Copyright Copyright 2017 by Nextivity, Inc. All rights reserved. Reproduction or media conversion by any means is protected by copyright and may only occur with prior written permission of Nextivity. Designed by Nextivity in California. can radiate radio frequency energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equip-
ment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help ISED STATEMENT BEFORE USE, meet all requirements set out in CPC-2-1-05. This device may operate in a fixed location only, for in-building use. In order to comply with ISED RF Exposure requirements, this device must be installed to provide at least 20 cm separation from the human body at all times. Afin de se conformer aux exigences dexposition RF de ISED, cet appareil doit tre install pour fournir au moins 20 cm de sparation du corps humain en tout temps. The Manufacturers rated output power of this equipment is for single carrier operation. For situations when multiple carrier signals are present, the rating would have to be reduced by 3.5dB, especially where the output signal is re-
radiated and can cause interference to adjacent band users. This power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device.
[FRENCH: La puissance de sortie nominale indique par le fabricant pour cet appareil concerne son fonctionnement avec porteuse unique. Pour des appareils avec porteuses multiples, on doit rduire la valeur nominale de 3,5dB, surtout si le signal de sortie est retransmis et quil peut causer du brouillage aux utilisateurs de bandes adjacentes. Une telle rduction doit porter sur la puissance dentre ou sur le gain, et ne doit pas se faire au moyen dun attnuateur raccord la sortie du dispositif.]
This device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
[FRENCH: Le prsent appareil est conforme aux CNR dIndustrie Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes: (1) lappareil ne doit pas produire de brouillage, et (2) lutilisateur de lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement.]
Gain Bandwidth Input and Output Impedances Output Power Uplink Downlink 58dB (=<1GHz) 65dB (>1GHz) 75Mhz 50 ohm 22dBm per band 16dBm per band Compliance Contact In the event of regulatory compliance issue, please contact Nextivity Inc. directly. Contact information is available at www.nextivityinc.com. Patents This product is covered by Nextivity, Inc., US patents and patents pending. Please refer to cel-fi.com for details. Copyright Copyright 2017 by Nextivity, Inc. All rights reserved. Reproduction or media conversion by any means is protected by copyright and may only occur with prior written permission of Nextivity. Designed by Nextivity in California. U.S. Headquarters: Nextivity Inc. 16550 West Bernardo Drive Bldg. 5, Suite 550 San Diego, CA 92127, USA
+1 858.485.9442 tel
+1 858.485.9445 fax www.cel-fi.com Bureau in Europe:
Unit 6, Basepoint Business Centre Rivermead Drive, Westlea Swindon SN5 7EX Nextivity Singapore Pte. Ltd.:
2 Changi Business Park Avenue 1 Level 2 Suite 16, 486015 Singapore U.S. Headquarters: Nextivity Inc. 16550 West Bernardo Drive Bldg. 5, Suite 550 San Diego, CA 92127, USA
+1 858.485.9442 tel
+1 858.485.9445 fax www.cel-fi.com Bureau in Europe:
Unit 6, Basepoint Business Centre Rivermead Drive, Westlea Swindon SN5 7EX Nextivity Singapore Pte. Ltd.:
2 Changi Business Park Avenue 1 Level 2 Suite 16, 486015 Singapore legal_GO-M-Eng_17-0302 legal_GO-M-Eng_17-0302