PRODUCT INFORMATION Cel-Fi QUATRA Networked Smart Booster PRODUCT INFORMATION Cel-Fi QUATRA Networked Smart Booster STOP!!! Do not call your service provider until you have read the User Manual. STOP!!! Do not call your service provider until you have read the User Manual. If you need help, visit: http://www.celfihelp.com Safety Precautions Use Cel-Fi indoors. It should not be used outdoors. These products are designed to be used with a direct plug-in power supply unit that shipped with the Network Unit.. When installing the equipment, all the requirements of the manufacturer and the referenced standards must be met. There are no user serviceable parts inside. CAUTION: Changes or modifications to this product not expressly approved by Nextivity may void your right to operate the equipment. Warranty Nextivity Inc provides a limited warranty for its products. For details, please refer to http://cel-fi. com/warranty. Limitation of Liability In no event shall Nextivity, nor its directors, employees, agents, suppliers or End Users, be liable under contract, tort, strict liability, negligence or any other legal or equitable theory with respect to the Products or any other subject matter of this Agreement (i) for any lost profits, cost of procurement of substitute goods or services, or special, incidental, punitive, or consequential damages of any kind whatsoever or (ii) for any direct damages in excess of (in the aggregate) the fees actually received by Nextivity from End User with respect to the Products actually purchased and paid for. See celfi.com for list of patents covering this product. Trademark Cel-Fi, trademarks of Nextivity, Inc. IntelliBoost, and Nextivity logo are indirect, FCC Statement (Applicable in the USA only) This is a CONSUMER device. BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your providers consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider. WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device. When used with any mobile device utilizing the 1710-1755 MHz band, the FCC limits booster equipment placement to a maximum of 10 meters above ground level. Installation of this equipment which does not comply with federal requirements may subject the owner to FCC enforcement action. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful in a residential installation. This equipment generates, interference If you need help, visit: http://www.celfihelp.com Safety Precautions Use Cel-Fi indoors. It should not be used outdoors. These products are designed to be used with a direct plug-in power supply unit that shipped with the Network Unit.. When installing the equipment, all the requirements of the manufacturer and the referenced standards must be met. There are no user serviceable parts inside. CAUTION: Changes or modifications to this product not expressly approved by Nextivity may void your right to operate the equipment. Warranty Nextivity Inc provides a limited warranty for its products. For details, please refer to http://cel-fi. com/warranty. Limitation of Liability In no event shall Nextivity, nor its directors, employees, agents, suppliers or End Users, be liable under contract, tort, strict liability, negligence or any other legal or equitable theory with respect to the Products or any other subject matter of this Agreement (i) for any lost profits, cost of procurement of substitute goods or services, or special, incidental, punitive, or consequential damages of any kind whatsoever or (ii) for any direct damages in excess of (in the aggregate) the fees actually received by Nextivity from End User with respect to the Products actually purchased and paid for. See celfi.com for list of patents covering this product. Trademark Cel-Fi, trademarks of Nextivity, Inc. IntelliBoost, and Nextivity logo are indirect, FCC Statement (Applicable in the USA only) This is a CONSUMER device. BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your providers consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider. WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device. When used with any mobile device utilizing the 1710-1755 MHz band, the FCC limits booster equipment placement to a maximum of 10 meters above ground level. Installation of this equipment which does not comply with federal requirements may subject the owner to FCC enforcement action. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful in a residential installation. This equipment generates, interference uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. the separation between Increase equipment and receiver. the Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help External Antenna (option):
Only use with approved Cel-Fi MIMO Panel Antenna A52-X12-100. Industry Canada (IC) Statement The Manufacturers rated output power of this equipment is for single carrier operation. For situations when multiple carrier signals are present, the rating would have to be reduced by 3.5 dB, especially where the output signal is re-
radiated and can cause interference to adjacent band users. This power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device. La puissance de sortie nominale indique par le fabricant pour cet appareil concerne son fonctionnement avec porteuse unique. Pour des appareils avec porteuses multiples, on doit rduire la valeur nominale de 3,5 dB, surtout si le signal de sortie est retransmis et quil peut causer du brouillage aux utilisateurs de bandes adjacentes. Une telle rduction doit porter sur la puissance dentre ou sur le gain, et ne doit pas se faire au moyen dun attnuateur raccord la sortie du dispositif. Nextivity Inc Headquarters:
12230 World Trade Drive Suite 250 San Diego, CA 92128, USA http://www.nextivityinc.com Bureau in Europe:
Whitehill Way, Swindon, UK SN5 6QR This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Gain Bandwidth Input and Output Impedances Output Power Uplink Downlink 100dB 75Mhz 50 ohm 22dBm per band 16dBm per band Le prsent appareil est conforme aux CNR dIndustrie Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes : (1) lappareil ne doit pas produire de brouillage, et (2) lutilisateur de lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. Compliance Contact In the event of regulatory compliance issue, please contact Nextivity Inc. directly. Contact information is available at www.nextivityinc.com. Patents This product is covered by Nextivity, Inc., US patents and patents pending. Please refer to CEL-FI.com for details. Copyright Copyright 2016 by Nextivity, Inc. All rights reserved. Reproduction or media conversion by any means is protected by copyright and may only occur with prior written permission of Nextivity. Designed by Nextivity in California. uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. the separation between Increase equipment and receiver. the Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help External Antenna (option):
Only use with approved Cel-Fi MIMO Panel Antenna A52-X12-100. Industry Canada (IC) Statement The Manufacturers rated output power of this equipment is for single carrier operation. For situations when multiple carrier signals are present, the rating would have to be reduced by 3.5 dB, especially where the output signal is re-
radiated and can cause interference to adjacent band users. This power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device. La puissance de sortie nominale indique par le fabricant pour cet appareil concerne son fonctionnement avec porteuse unique. Pour des appareils avec porteuses multiples, on doit rduire la valeur nominale de 3,5 dB, surtout si le signal de sortie est retransmis et quil peut causer du brouillage aux utilisateurs de bandes adjacentes. Une telle rduction doit porter sur la puissance dentre ou sur le gain, et ne doit pas se faire au moyen dun attnuateur raccord la sortie du dispositif. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Gain Bandwidth Input and Output Impedances Output Power Uplink Downlink 100dB 75Mhz 50 ohm 22dBm per band 16dBm per band Le prsent appareil est conforme aux CNR dIndustrie Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes : (1) lappareil ne doit pas produire de brouillage, et (2) lutilisateur de lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. Compliance Contact In the event of regulatory compliance issue, please contact Nextivity Inc. directly. Contact information is available at www.nextivityinc.com. Patents This product is covered by Nextivity, Inc., US patents and patents pending. Please refer to CEL-FI.com for details. Copyright Copyright 2016 by Nextivity, Inc. All rights reserved. Reproduction or media conversion by any means is protected by copyright and may only occur with prior written permission of Nextivity. Designed by Nextivity in California. PI_QUATRA-English_15-0629 PI_QUATRA-English_15-0629 Nextivity Inc Headquarters:
12230 World Trade Drive Suite 250 San Diego, CA 92128, USA http://www.nextivityinc.com Bureau in Europe:
Whitehill Way, Swindon, UK SN5 6QR