Electric winch wireless controller instructions A, Features Overview This wireless remote control firing frequency of 315MHz, the control range of more than 25 m, used in electric winch wireless control. B, The wireless remote control parameters 1, Working voltage: DC6V, 2 pcs CR2032 battery. 2, The working current: 25mA 5mA 3, Transmitting frequency: 315MHz 4, The transmit power: <10dBm 5, Standby current: <5uA C, Using The remote controler has 2 buttons. Press and hold the "OUT" and "IN" button at the same time more than 3 seconds, the remote powered on, while the LED indicator lights. Then press and hold on the remote control "OUT" or "IN" button, it will trigger 315 MHz high frequency. The high-frequency signal emitted by the antenna to control receiver unit. When the remote control has been powered on, press and hold down the "OUT" and "IN" button at the same time more than 3 seconds, the remote control is turned off, while LED is o f. If there is no key operation within 50 seconds, it will automatically shut down. D, Installation and function 1,Disconnect Power to the winch 2,Confirm that the plug is the correct type for this winch and plug it in 3.Select an area for the receiver on the vehicle close enough to the winch to allow cable connection 4.Investigate the chosen area to make sure no components will be damaged by installation. 5.Permanently (optional) mount the remote control receiver to the vehicle using appropriate hardware (not included). 6.Preare the winch for operation as explained in its manual 7.Reconnect winchs power 8.Release the clutch handle and pull out about 10 feet of wire rope Lea ve the wire rope laying on the ground and stay clear of the wire rope and hook 9.Reengage the clutch handle 10.Watch the spool and wire rope and briefly,press the out button on the remote control to verify that the cable feeds out WARNING! If the cabl e doe s not feed out ,check and correct the winchs wiring. Retest after correction. 11.Watch the spool and wire rope and briefly press the in button on the remote control to verify that the cable retracts WARNING! If the cabl e doe s not feed out ,check and correct the winchs wiring .Retest BOTH functions after correction. 12.If the remote operates the winch properly, it is ready for use. 13.After use, disconnect control box from winch to prevent accidental operation E, Wiring diagram F,WARNING!
To prevent serious injury 1. Disconnect control box from winch before service and after every use. WINCH CAN OPERATE SUDDENLY AT ANY TIME WHILE CONNECTED. 2. Stand clear of winch, fairlead, and wire rope while connected. Keep bystanders away. 3. Only operate controls when winch and entire wire rope is within view. 4. Use with vehicle mounted recovery winches only. Do not use for any other application. 5. Confirm control box mounting location has no wire or components that can be damaged drilling. 6. Read winch manual before use. FCC warning Any Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference (2) this device must accept any interference received, including interference that may cause undesired operation.