INSTRUCTION MANUAL Please read this instruction manual and obey it strictly before using:
1. The LED bulb cannot be replaceable. 2. The external cable or cord of this luminaire cannot be replaced, if the cord is damaged, the luminaire shall be destroyed. 3. Avoid direct contact between bulb (or protect galss) and the hand or skin when to adjust the irradiation angle, using the handle. 4. This appliance should only be used indoor. it cant be used after wetted. 5. Turn off the switch when nobody alongside. 6. Only use the transformer provided. 7. This product contains recyclable materials. Do not dispose this product as unsorted municipal waste. Please contact your local municipality for the nearest collection point. 8. Waterproof and dustproof IP20. 9. Place any Qi enabled device on the center of the lamp base for wireless charging. 10. Wireless module INPUT12v,0.625A 7.5WMAX/ Output5v 1A 5wmax. 11. Product input voltage 12V1.5A . Any Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmfui interference,
(2) this device must accept any interfeience received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Note: The Grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. such modifications could void the user's authority to operate the equipment. The device has been evaluated to meet general RF exposure requirement. To maintain compliance with FCC's RF exposure guidelines, the distance must be at least 20 cm between the radiator and your body, and fully supported by the operating and installation configurations of the transmitter and its antenna(s).