1/2 PA- series Specification
. The picture of the adaptor and the remote controller PA-US1-01RFP WATERPROOF IP44 LED Indicator Single control button remote controller(SD-US2-RF) remote controller(SD-US1-RF)
.User instruction 1. Press momentary on the Key, the LED indicator was lightened up when the socket-outlet become live, the socket-outlet is broke when this LED will be extinguished 2.Remote control Press the Key for 5 seconds, and let go until seeing the LED indicator flickering, then, press on the single control button of remote controller, it means registering successfully when you hear the sound of D, this button which you press on just will become effective after successful registration. Note: Both touch keys cant be registered at the same time. Technical Data:
Items Rated Voltage Rated Current Output Power Technical data 110V~125VAC, 60Hz 15A Maximum resistive load: 1800W 2/2 Maximum motor load: 1/3hp Maximum tungsten load: 1000W
-100dBm Battery: 27A 12VDC; Battery life: one year; remote control distance: 20mSending sensitivity-25dBm Controls up to 4 channels. Battery: 23A 12VDC; Battery life: one year; remote control distance: 40m; Sending sensitivity-25dBm Controls up to 20 channels. Receiving Sensitivity SD-US1-RF parameter SD-US2-RF parameter Attention 1. Due to the fact the product produces some slight heat during the operation, it isnt allowable to put it onto some furniture or radiators, and to be covered by any blind, table cloth or any other objects. 2. Dont use it with an over loading electrical appliance. 3. The product must be properly connected to a grounded three-line receptacle Reminding This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. NINGBO COMEN ELECTRONICS TECHNOLOGY CO.,LTD ADD: NO.2 HONGXING ROAD,ZONE A HONGTANG INDUSTRY PARK,NINGBO,CHINA TEL:+86 574 87259391 FAX:+86 574 87259390 E-mail: sales@comen.com.cn HTTP: www.comen.com.cn