DC6010 Emitter Specification Version NO. : A/00 T Type specification When you press the Setting button, the required use of tools,dont be too sharp tool. LED selection}
Channel 1 2 3 4 5 STOP Up button Down button Setting button
(P2) Bracket 5-channel emitter Back T Technical support Technical specification Fucntion instruction Input voltage3V(CR2430) Transmitting frequency433MHz Transmitting power10 milliwatt Operating temperature-100C500C Transmssion distance200 meters open office 35 meters on two walls DC6010 is 5-channel emitter,red light represents the currently selected channel, press the current channel again, cancel selected channel, when all the red light is bright, on behalf of the group control state. Press stop, up, down key when the red light fast flash tips. CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS Notice: transmitter do not exposed to moisture and strike, so as not to affect life.When you use transmitter, if found emission distance obviously short or less sensitive, please change another same new battery. Please have batteries for recycling. A Additional function Power on A Additional function Power on A Additional function Matchable R tubular motor setting up Delete all the datas of the motor and the new emitter has been programmed. During the settings,the time between two operation must be shorter than 4s,otherwise it will quit the setting P21 P21 Sound from motor hear long sound Beep once Beep once Up1 1 2 3 4 5 STOP Down1 1 2 3 4 5 STOP Run or beep for hint OK Set up is ok. The up button control the motor clockwise Run or beep for hint OK Set up is ok. The down button control the motor clockwise Matchable DC1680 setting up During the settings,the time between two operation must be shorter than 6s,otherwise it will quit the setting Press (up+down)1 at the same time Indicator flashing Stop1 Indicator long flashing Up1 Indicator flashing then extinguished 1 2 3 4 5 STOP OK Setting is ok DC1680 DC1680 DC1680 DC1680 DC1680 Matchable DC136 setting up During the settings,the time between two operation must be shorter than 10s,otherwise it will quit the setting Setting button1 Indicator flashing Stop1 Indicator long flashing Up1 Indicator flashing then extinguished Power on DC136 DC136 DC136 DC136 DC136 1 2 3 4 5 STOP OK Setting is ok FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.