DC1770(B)/DC1771(B) Emitter Specification Version NO. : A/01 T Type specification Up button Stop button Down button setting button P2 DC1770 Single - channel emitter DC1770 back The first channel The second channel Up button Stop button Down button Up button Stop button Down button setting button P2 DC1771 Double - channel emitter DC1771 back T Technical support Technical specification Fucntion instruction Input voltage3V(CR2430) Transmitting frequency433MHz Transmitting power10 milliwatt Operating temperature-50C500C Transmssion distance200 meters open office 35 meters on two walls Transmitter: you can choose single channel DC1770(B), double channels DC1771(B) Notice: transmitter do not exposed to moisture and strike, so as not to affect life. When you use transmitter, if found emission distance obviously short or less sensitive, please change another same new battery. Please have batteries for recycling. A Additional function Matchable R tubular motor set up
Delete all the datas of the motor and the new emitter has been programmed.
Each time, the interval of pressing different buttons must within 4 seconds when you re-setting all instructions, otherwise the system will restore the original state. Sound from motor hear long sound Hear long sound
2 Hear di di... Press up button one time, sound tip three times Switch on Press the setting button 2 times OK Set up is ok. The up button control the motor clockwise OK Set up is ok. The down button control the motor clockwise Press down button one time, sound tip three times A Additional function Matchable DC1680 / DC1681 set up
Each time, the interval of pressing different buttons must within 6 seconds when you re-setting all instructions, otherwise the system will restore the original state.
One receiver store 20 emitters channels at most OK Setting is ok Switch on Press up button and down button one time at the same time See indicator flashing Press the receiver stop button one time See the receiver indicator long flashing Press the emitter up button one time See indicator flashing A Additional function Matchable DC136 set up
Each time, the interval of pressing different buttons must within 10 seconds when you re-setting all instructions, otherwise the system will restore the original state.
One receiver store 20 emitters channels at most Switch on Press the receiver set button See green indicator flashing Press the receiver stop button one time See the receiver indicator long flashing Press the emitter up button one time See green indicator flashing and extinguished OK Setting is ok FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.