USER MANUAL Strobe Press again to strobe mode. Item no.SA211 Wirelesss Speaker Power off Press again to turn off. ON/OFF(speaker) Power on Press and hold Mode key until LED light will be blinking Power off Press and hold Mode key until LED light disappeared Wireless Set Up:
Press and hold Mode key until Blue& Red LEDbegins blinking (this is pairing Mode). Using a Bluetooth enabled audio device,search the possible connections for
"GC-01. Audio Functions:
1.Play/Pause Press Mode button to play. Press again to pause 2.Incoming Calls:
1 LED indicator 2 Mode(speaker) 3 Charging Port 4 Mode(torch) First Time Use:
(Fully charged before first time use) 1. Connect the provided charging cable to a power source and to the micro USB port on the headphones. If receiving a call via Bluetooth connection,audio will automatically pause and begin toplay again when call ends. Under connected mode when phone call 2. The LED indicator light shows red when comes in:
charging and turns off when fully charged. ON/OFF(torch) Double press the Mode key to reject Short press the Mode key to answer Short press the Mode key to end the call Power on Press Mode key to turn on. NOTE: This equipment has been tested and circuit different from that to which the found to comply with the limits for a receiver is connected. Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio
-Consult the dealer or an experienced radio/TV technician for help frequency energy and, if not installed and Changes or modifications not expressly used in accordance with the instructions, approved by the party responsible for may cause harmful interference to radio compliance communications. However, there is no could void the user's authority to operate the guarantee that interference will not occur in a equipment. particular installation. If this This device complies with Part equipment does cause harmful interference 15 of the FCC Rules. Operation is subject to to radio or television reception, which the following two conditions:
can be determined by turning the equipment
(1) this device may not cause harmful off and on, the user is encouraged to interference, and try to correct the interference by one or more
(2) this device must accept any interference of the following measures:
received, including interference that may
- Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a cause undesired operation.