Remote control Manual 1. The key functions of the panel are shown in the figure Wire-controlled indicator light Wireless indicator Power start button OUTbutton INbutton 2. Function description: long press the power start button for 3 seconds, and the blue wireless indicator will turn on.Power off automatically after 2 minutes without any operation.Press the OUT button. The blue indicator flashes winch outgoing (nylon rope/steel cable).Press IN button blue indicator light flashes winch incoming (nylon rope/steel cable).When the wire control is used, the wireless remote control blue indicator light is off and the red wire control indicator light is long- bright 3. Distance: 40 feet. In case of different degrees of interference in the actual use environment, the distance of remote control will also change correspondingly (the distance will be shortened). 4.Transmitter voltage: DC2-3.6v, Receiver voltage: DC9-15v IC Statement:
This device complies with Industry Canadas licenceexempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. IC Radiation Exposure Statement:
This equipment complies with Canada radiation exposure limits set forth for uncontrolled environments.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Dclaration dIC sur lexposition aux radiations:
Cet quipement est conforme aux limites dexposition aux radiations dfinies par le Canada pour des environnements non contrls. Cet metteur ne doit pas tre install au mme endroit ni utilis avec une autre antenne ou un autre metteur.