1997 2000 CORVETTE REPLACEMENT TRANSMITTER P/N: 19299230 INSTRUCTION SHEET Remote Function Actuation System Your vehicle has a Remote Function Actuation (RFA) system that allows you to lock and unlock your doors, unlock your hatch/trunk lid, turn the panic alarm on and off and disarm or arm your theft-deterrent system. When using one of the key fob transmitters supplied with your vehicle range distance is as much as 100 feet
(30 m) away. Your RFA system operates on a radio frequency subject to Federal Communication Commission (FCC) Rules and with Industry Canada. FCC COMPLIANCE This device complies with Part 15 of the FCC rules and with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
1. This device may not cause harmful interference. 2. This device must accept any interference received, including any interference that may cause undesired operation. Le prsent appareil est conforme aux CNR dIndustrie Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deaux conditions suivantes:
1. lappareil ne doit pas produire de brouillage. 2. lutilisateur de lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. Warning!
Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment and void warranty. Operation You can use the buttons on the transmitter to unlock your vehicle. Press UNLOCK once to unlock the drivers door, or UNLOCK again within 10 seconds to unlock both doors. Pressing LOCK once will lock both doors and arm the theft-deterrent system. Your memory settings will also be recalled when you press the UNLOCK button on the key fob transmitter. See Memory in the vehicles Owners Manual Index for more information. The hatch/trunk lid will unlock when the button with the trunk symbol is pressed, as long as the ignition is turned to OFF. The system has a feature that makes it difficult for you to lock your keys in your vehicle. If you leave your keys in the ignition and attempt to lock the doors, the vehicle will not lock and a chime will sound reminding you that the keys are in the ignition. If the door lock is pressed again, within five seconds, the doors will lock and the keys can be locked in the vehicle The system will allow you to lock your keys in the vehicle if you didnt leave them in the ignition (for example, you leave the keys on the seat). Always remember to take your keys with you. Panic Alarm Button When you press the special horn button on the key fob transmitter, the horn will sound. This panic alarm button will allow you to attract attention, if needed. If the horn alarm sounds, there are three ways to turn it off:
Push the panic alarm button again on the key fob transmitter. Wait 90 seconds, and the horn will turn off by itself. Turn the key to any position in the ignition, except OFF. RFA Settings You can adjust the settings on the system through the Driver Information Center (DIC). See Driver Information Center Controls and Displays in the Index of your vehicles Owners Manual for more information. Matching Transmitter(s) To Your Vehicle Each key fob transmitter is coded to prevent another transmitter from unlocking your vehicle. If a transmitter is lost or stolen, a replacement can be purchased through your dealer. Remember to bring any remaining transmitters with you when you go to your dealer. When the dealer matches the replacement transmitter to your vehicle, any remaining transmitters must also be matched. Once your dealer has coded the new transmitter, the lost transmitter will not unlock your vehicle. Each vehicle can have only three transmitters matched to it. To match transmitters to your vehicle:
1. Turn the ignition key to ON. 2. Clear any warning messages on the Driver Information Center (DIC) by pressing the RESET button. 3. Press the OPTIONS button on the DIC several times until the blank page is displayed, the press and hold the RESET button for two seonds. 4. When the message FOB TRAINING is displayed, push the RESET button once. The message HOLD LK+UNLK 1ST FOB in DIC will be displayed. 5. Press and holf the LOCK and UNLOCK buttons on the transmitter simultaneously for 15 seconds. 6. When the transmitter is learned (matched), the DIC will display FOB LEARNED and then prompt you to learn the next transmitter. 7. Repeat steps 5 and 6 for each additional transmitter. 8. Remove the key from the ignition. The programming mode will shut off if:
You dont program any transmitter for two minutes. You take the key out of the ignition. You have programmed three transmitters.