UHF Wireless Handheld Microphone Illustration 1) UHF handheld microphone EJ-501TM a) 2) @) (4) ) a
(12) ell
(7) (8) (9) (10) (41)
(1) Mesh head (7) Talk/Mute button
(2) Microphone tube (8) Power Hi/Low switch
(3) Power indicator (9) Battery room
(4) Power ON/OFF button (10) Battery door
(5) LCD screen (11) Talk/Push mode switch
(channel, battery energy) (12) Charging contacts
(6) Channel adjustment and setup button i Insert battery Open battery door and insert 2 AA 1.2V (Ni-MH 1600mAh) or 2 AA 1.5V Alkaline batteries. Make sure the batteries are allocated in correct direction. UHF Wireless
| Operation and setup for handheld microphone EJ-501TM 1. Take batteries off and make your preferred microphone mode Talk/Push (11) TALK Under this mode, microphone will activate only when microphone icon turns into green; mute the microphone by a press to microphone icon which will be turned into red. 3 PUSH Under this mode, microphone will send out signal only when the talk/mute (7) button is pressed and held the microphone icon turns into green ; when talk/mute (7) button is released the microphone will mute any signal the microphone icon turns into red 2. Choose a preferred output power with Hi/Low power switch (8) 3 HI offer operation range up to 60M (line-of-sight); current drained at 100mA. 3 LOW - offer operation range up to 30M (line-of-sight); current drained at 70mA. 3. Insert batteries and resume battery door. Press and hold power ON/OFF button (4) for 1 second to turn on. The power indicator (3) lights up when power on progress is made successfully. Power indicator lights in green sufficient battery energy
* Power indicator lights in red low battery 4. Under Talk mode: Green microphone icon Talk; Red microphone icon Mute Under Push mode: Green microphone icon Talk; Flashing red microphone icon Mute 5. Turn off handheld microphone by pressing and holding power ON/OFF button (4) for 2~3 seconds.
6.The performance of signal transmission is highly involved with battery energy. Batteries with 1600MAh
(or above) in capacity are recommended. The optional charger HDC-502 is an economy solution for your daily use. HDC-502 3% Do NOT charge alkaline battery,which might lead to battery leakage or explosion! Only Ni-MH battery is allowed to charge. lease remove batteries once the device wont be in use for a long time! It will prevent the device from damage caused by battery leakage. pecifications Dimensions (Dia x L) 46 x 246 mm Weight 280 g (batteries included) Wireless Handheld Microphone EJ-501TM Microphone capsule condenser Antenna built-in RF output power 10 mW (Hi); 1 mW (Low) Audio control Talk/Mute button Battery 2 AA 1.2V (Ni-MH, 2000 mAh); or 2 AA 1.5V (Alkaline) Operation hours 15 (Ni-MH) / 20 (Alkaline) hours, typical Dimensions (Dia x L) 37 x 200 mm Weight 140 g (batteries included)