Remocon Engine Starter operation manual Configuration Parts names Key fob LED indicators Product label Battery cover Lock/Stop button Unlock/Start button Engine control button Ring Door lock / unlock Pressing the Lock/Stop button, the vehicle door will be locked. Pressing the Unlock/Start button, the vehicle door will be unlocked. Main specification Key fob Transmission frequency Transmission power Antenna Transmission frequency Transmission power Antenna Switches Link state acknowledgment Battery Operation temperature range Dimensions Weight Antenna module Transmission frequency Transmission power Power supply Current consumption Antenna Operation temperature range Dimensions Weight 902 MHz928MHz band
< 20mW chip antenna 315 MHz
< 75.6dBuV/m @3m PWB pattern antenna Lock/Stop, Unlock/Start, Engine control LED indicators Lithium battery (CR2032 x 2)
-20 to +60 (-4F to 140F) 81.5 mm x 30 mm x 13 mm ( not including protrusion) 37 g 902 MHz928MHz band
< 20mW 4.2 V 3 mA (for receiving) 1/4 lambda printed antenna
-30 to +85 (-22F to 185F) 52 mm x 25 mm x 52 mm 35 g After sales service For after sales service, contact :
OMRON Automotive Electronics Co. Ltd. 6368 nenjyozaka, okusa Komaki, Aichi 485-0802 JAPAN URL: http://www.oae.omron.co.jp Regulatory compliance FCC / IC CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. Tout changement ou toute modification effectus par lutilisateur et dont la conformit nest pas expressment approve par lorganisme responsable de sa conformit peut entraner lannulation de droit de cet utilisateur de se servir de lquipment. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. This device complies with part 15 of FCC Rules and Industry Canadas licence-exempt RSSs. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le prsent appareil est conforme la partie 15 des rgles de la FCC et aux normes des CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes :
(1)l'appareil ne doit pas produire de brouillage, et (2)l'appareil doit accepter tout brouillage subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. Battery replacement We recommend that you replace the batteries after one year's use as a guide. Batteries: CR2032 x 2 How to replace the batteries 1. Remove the battery cover Remove the screw and the battery cover. 2. Take out the old batteries Insert the flathead screw driver which put cloth and take out the old batteries. 3. Replace the new batteries Insert the new batteries (CR2032) with the positive ( + ) side facing up. 4. Place the battery cover Place the battery cover and fasten the screw. How to use Remote engine start Battery cover Screw Lithium batteries
(CR2032 x 2) 1. Pressing the Engine control button for more than 1 second. 2. Release the Engine control button, and then press the Unlock/Start button.
(The vehicle engine will start.) 3. If a response signal from the vehicle is properly received, the LED indicators will be blinked. Remote engine stop 1. Pressing the Engine control button for more than 1 second. 2. Release the Engine control button, and then press the Lock/Stop button.
(The vehicle engine will stop.) 3. If a response signal from the vehicle is properly received, the LED indicators will be blinked. Regulatory compliance
[Key fob]
[Antenna module]
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that are deemed to comply without testing of specific absorption rate (SAR). Cet quipement est conforme aux limites dexposition aux rayonnements nonces pour un environnement non contrl et respecte les rgles les radiolectriques (RF) de la FCC lignes directrices d'exposition et dexposition aux frquences radiolectriques (RF) CNR-102 de lIC. Cet quipement met une nergie RF trs faible qui est considre conforme sans valuation du dbit dabsorption spcifique (DAS). This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that it deemed to comply without maximum permissive exposure evaluation
(MPE). Cet quipement est conforme aux limites dexposition aux rayonnements nonces pour un environnement non contrl et respecte les rgles les radiolectriques (RF) de la FCC lignes directrices d'exposition et dexposition aux frquences radiolectriques (RF) CNR-102 de lIC. Cet quipement met une nergie RF trs faible qui est considre conforme sans valuation de lexposition maximale autorise (MPE).