FCC ID: 2AXYP-OHP-610 Wireless Headset

OHP-610i 483:

100g#a RZ, Fhe, 4C+1 SEN Ml, Wireless Headset x 1 Type-C Charging Cable x 1 Om ==>)

(Tre 3.5mm AUX Cable x 1 Welcome Guide x 1 Bluetooth Version:

V5.3 Bluetooth Range:

=10m Speaker Diameter:

40mm Charging Time:

1.5 hours Playtime:

Up to 60 hours Supported Format:

Mic support / Aux in Mode / Type-C 5. LED Indicator 6. 3.5mm AUX Input 7. Microphone 8. Type-C Charging Port 1. Button + (Volume Up / Next Track) 2. Button O (Play/Pause/Call) 3. Button - (Volume Down / Last Track) 4. Power Switch 1. To preserve battery lifespan, fully charge at least once a month

. Use original or certified cables

. Do not expose to liquids

. Do not disassemble

. Avoid extreme temperatures

. Do not use the product outdoors during a thunderstorm 2 3 4 5. Avoid dropping 6 7 8

. Do not use any corrosive cleaner/oil to clean Toggle the power switch to power on/off. LED Indicator Status Steady blue for 1 second with voice prompt saying power on Power on Steady red for 2 seconds with voice prompt saying power off Power off

% The Headset will automatically turn off after 5 minutes if no device is connected. Problem Description Power on function fails. Recharging function fails. Cause The battery is exhausted. The power switch is not fully toggled. The recharging port is not properly connected. Solution Use the charger kit to fully recharge the battery. Toggle the power switch again. Reconnect the charging port. The headphone cannot be searched or pairing fails. The headphone does not enter into the pairing mode. The Bluetooth function of the device is in error. Turn on the headphone again to enable it enter into the pairing mode. Restart the device and the Bluetooth and then pair with the headphone again. When power on, the Headset will enter pairing mode automatically. Open the Bluetooth function and connect the Bluetooth named as BoomPop 2 on your device to finish the pair. S>

Bluetooth on imo BoomPop 2

LED Indicator Fast flashing blue with voice prompt saying pairing Enter pairing mode Steady blue with voice prompt saying connected Connected to a device 1. Do not turn up the volume to a fair high level constantly as this could shorten the service life of this product or impair your hearing. 2. When encounter any fault during operation, please cut off the power supply and disconnect the USB cable to prevent further damage to the product or other components. 3. The wireless transmission range or connectivity could be affected by low battery power. In that case, please recharge immediately. 1) Disconnect the Bluetooth connection with the last device:

a. Disconnect directly from your device. b. Or press the button + and button - simultaneously for 3 seconds. 2) Enter the pairing mode to achieve the connection again.

% Make sure the distance of the headphone and your device is less than 1 meter /

3.3 feet at the first time of connection.

% The headphone will automatically connect to the last connected device if available. If not, the headphone will enter pairing mode. Wireless Headset Model: OHP-610. Hereby, ORAIMO TECHNOLOGY LIMITED. Declares that this Wireless Headset is in compliance with the essential requirements and other relevant provisions of directive 2014/53/EU. CAUTION 1. Use careful with the earphone maybe excessive sound pressure from earphones and headphones can cause hearing loss 2. Risk of explosion if battery is replaced by an incorrect type, dispose of used batteries according to the instructions. disposal ofa battery into fre or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion;

leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas;

~a battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas. 3. The product shall only be connected to a USB interface of version USB 2.0. 4. EUT Temperature: 0C ~+45 C (Standalone).0C ~+40 C (with adapter) 5. To prevent possible hearing damage, do not listen at high volume levels for long periods 6.USB cable is shielded. Frequency Range(RF):

BT: 2400-2483.5MHz (TX/RX);

Max RF output power :

BT(BDR): 2.70dBm BLE: 2.48dBm High sound pressure with hearing damage risk. Do not listen at high volume levels for long periods. FCC Warning:

Chenges or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, ifnot installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a articular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna. increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help. RF Exposure Statement The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. EU DECLARATION OF CONFORMITY in accordance with Annex VI of Directive 2014/53/EU of the European Parliament and of the Council 1. For the following Radio equipment:Model: OHP-610, Product: Wireless Headset, Trade name or Brand: oraimo Software / Hardware number: VO17/ VO2 2. Name and address of the manufacturer or his authorized representative:-Manufacturer: ORAIMO TECHNOLOGY LIMITED Address: FLAT N 16/F BLOCK B UNIVERSAL INDUSTRIAL CENTRE 19-25 SHAN MEI STREET FOTAN NT HONGKONG 3. This declaration of conformity is issued under the sole responsibility of the Manufacturer. 4. Object of the declaration (identification of the radio equipment allowing traceability; it may include a colour image of sufficient clarity where necessary for the identification of the radio equipment):

5. The object of the declaration described above is in conformity with the relevant Union harmonization legislation: Directive 2014/53/EU (RED) 6. References to the relevant harmonised standards used or references to the other technical specifications in relation to which conformity is declared:

Article 3.1a Health: EN 62479:2010 Article 3.1a Electrical Safety: EN62368-1-2014+A11:2017 Article 3.1b: ETSI EN 301 489-1 V2.2.3 (2019-11) Article 3.2: ETSI EN 300 328 V2.2.2 (2019-07) 7. Notified Body Name: Eurofins Electrical and Electronic Testing NA, Inc. Notified Body Number: 0980, Notified Body Assessment Performed: Module B/C on Article 3.1a, 3.1b, 3.2 Technical File Identification Number: N/A 8. Where applicable, description of accessories and components, including software, which allow the radio equipment to operate as intended and covered by the EU declaration of conformity: User instructions are provided in the User Manual. The Software and Hardware versions are specified above. 9. Additional information:Referring to Article 10.2 of the Directive, this equipment is so constructed that it can be operated in all Member States, without infringing applicable requirements on the use of radio spectrum Referring to Article 10.10 of the Directive, there are no restrictions on putting this equipment into service or of requirements for authorisation of use. Please refer to the User Manual for details. On behalf of. Manufacturer: ORAIMO TECHNOLOGY LIMITED. Address: FLAT N 16/F BLOCK B UNIVERSAL INDUSTRIAL CENTRE 19-25 SHAN MEI STREET FOTAN NT HONGKONG

(place and date of issue):Shenzhen, 2023-07-20

(name, function):Nengyong.Wu/ Manager yor. we

(signature)

(Name and signature of person responsible) EN IEC 62368-1:2020+A11:2020 ETSI EN 301 489-17 V3.2.4 (2020-09)

% The speaker will enter AUX mode once the cable is plugged in.

(Mic will be banned when using AUX mode)

% Microphone will be enabled in AUX mode 365 DAYS WARRANTY 4 Email: service@carlcare.com India: care@oraimo.com All quality-related defects on items sold directly by oraimo or oraimos authorized resellers are covered by an extensive warranty, starting from the date of purchase. oraimos limited warranty is restricted to the country of purchase. The limited warranty is void on items taken outside the country they were originally bought in or shipped to directly from an authorized online purchase. This warranty covers only original oraimo products. It is not applicable to normal wear and tear, or any defects arising from damage caused by misuse of this product Warranty is for the primary product only nor transferable. Any free additional product(s) are not covered in this warranty. If the product fails regardless of usage in compliance with the instruction manual and other written precaution, replacement will be provided free of charge To receive replacement, bring the warranty certificate and the product itself to the store from where you have purchased the product. Play/Pause music: Short press the button O once. Volume up/down: Short press the button + / button - once. Next track/Last track: Long press the button + / button - for 1 second. Answer/End a call: Short press the button O once. Reject a call: Long press the button O for 1 second. Answer/End a call: Short press the button O once. Reject a call: Long press the button O for 1 second. After connecting to a third-party call, switch between two calls: Long press the button O for 1 second. Name:

LED Indicator Status Slowly flashing red with voice prompt Low battery Slowly flashing red Being recharged Steady blue Fully recharged Address:

Tel. No.:

Date of purchase(dd/mm/yy):

Store name:

Warranty period:

Long Press the Button O while the Headset is being charged.

is subject This device complies with Part 15 of the FCC Rules. Operation two to conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. following the Label Location:

ORAIMO TECHNOLOGY LIMITED Agent Authorization Letter

(July 21, 2023) Eurofins MET Labs 914 West Patapsco Avenue Baltimore, MD 21230 RE: LETTER OF AGENT AUTHORIZATION To Whom It May Concern:

We, the undersigned, hereby authorize (BTF Testing Lab (Shenzhen) Co., Ltd.) to act on our behalf in all matters relating to application for equipment authorization, including the signing of all documents relating to these matters. We also hereby certify that no party to the application authorized hereunder is subject to the denial of benefits, including FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C.853(a). This agreement expires one year from the current date. Sincerely, Greeny Xian / Manager

(ORAIMO TECHNOLOGY LIMITED)

(July 21, 2023) Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: Attestation Statements Part 2.911(d)(5)(ii) request for (2AXYP-OHP-610#)

[ORAIMO TECHNOLOGY LIMITED] (the applicant) certifies that the equipment for which authorization is sought is not covered equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules. Sincerely, Greeny Xian / Manager

(ORAIMO TECHNOLOGY LIMITED)

(July 21, 2023) Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: Attestation Statements Part 2.911(d)(5)(i) request for (2AXYP-OHP-610#)

[ORAIMO TECHNOLOGY LIMITED] (the applicant) certifies that, as of the date of the filing of the application, the applicant is not identified on the Covered List as an entity producing covered equipment. Sincerely, Greeny Xian / Manager

ORAIMO TECHNOLOGY LIMITED Long Term Confidentiality Request Letter

(July 11, 2023) Eurofins MET Labs 914 West Patapsco Avenue Baltimore, MD 21230 RE: CONFIDENTIALITY REQUEST FOR (Wireless Headset /OHP-610# 2AXYP-OHP-610#) To Whom It May Concern:

This letter serves as an official request for confidentiality under sections 0.457 and 0.459 of CFR 47. We have requested that the

- Block Diagram

- Schematics

- Operational Description

- BOM required to be submitted with this application be permanently withheld from public review. The above-mentioned documents belong to internal documents, is our proprietary information, that could never get into the possession of our competition. Please contact me if there is any information you may need. Sincerely, Clients name / Title : Greeny Xian / Manager Company Name: ORAIMO TECHNOLOGY LIMITED Contact information / address: dollyphin@oraimo.com / FLAT N 16/F BLOCK B UNIVERSAL INDUSTRIAL CENTRE 19-25 SHAN MEI STREET FOTAN NT HONGKONG

ORAIMO TECHNOLOGY LIMITED Short Term Confidentiality Request Letter

(July 21, 2023) MET Laboratories, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: Short Term Confidentiality Request For(Wireless Headset /OHP-610#

2AXYP-OHP-610#) To Whom It May Concern:

In accordance with sections 0.457 and 0.459 of CFR 47, < ORAIMO TECHNOLOGY LIMITED>. requests short-term Confidentiality of following sections of this application for a period of 180 days after grant is issued. Test setup photos External photos Internal photos Users manual These documents contain detailed system and equipment descriptions and related information about the product, which < ORAIMO TECHNOLOGY LIMITED. > considers to be proprietary, confidential, and a custom design and otherwise, would not release to the general public. Since this design is a basis from which future technological products will evolve, < ORAIMO TECHNOLOGY LIMITED.> feels that this information would be of benefit to its competitors, and that the disclosure of the information in these documents would give our competitors an unfair advantage in the market. Please contact me if there is any information you may need. Sincerely, Name: Greeny Xian Function: Manager Signature: