Oro Technology Co., Ltd. Al Sensor Tire Pressure Monitor System (TPMS) Sensor Assemblies
#R Oe AG BR Ee Hl as Read all instructions before installing. Refer to Mitchell Manual for installation specifications. Professional installa-
tion only. These Tire Pressure Monitor System Sensor assemblies are replacement or maintenance parts for motor vehicles that have a factory installed Tire Pressure Monitoring System (TPMS). CAUTION:
Each TPMS sensor is designed and manufactured to operate in a specific motor vehicle year, make, and model, using the proper frequencies to communicate with the motor vehicle TPMS system. Only install TPMS sensors designated for your specific motor vehicle year, make, and model. Improper installation will cause the motor vehicle TPMS to fail to operate properly. Do not install sensors in damaged wheels. Upon completion of installation, test the TPMS system using the pro-
cedures described in Mitchell 1 Manual to confirm proper installation. If the TPMS system fails to operate properly, check all installation procedures to ensure proper installation and retest. If the TPMS system continues to fail to operate, immediately consult with an authorized motor vehicle dealership. If the OEM equipment wheels or tires are not used, it is the responsibility of the vehicle owner to ensure that the TPMS system is functioning properly. The vehicle owner expressly assumes sole and complete responsibility for the TPMS and vehicle function if the OEM equipment wheels and tires are not used. Failure to ensure that the TPMS system is functioning properly can result in severe injury or death. Rubber Washer Valve Stem If the sensor is removed or replaced, it is MANDATORY to replace the screw and rubber washer to ensure proper sealing. See assembly instructions on reverse side Safe Driving With ORO TPMS Install hexagonal nut into valve stem. Tighten the nut Use wrench to hold valve stem and keep vertical while Install sensor. Adjust the sensor to fit the drop well of the wheel. Use wrench to keep stem vertical then tighten. Tighten the screw until 2.2Nm
(Recommended Final Torque Setting) Transmitter Module Specification Power Supply Operating Humidity Storage Temperature 3V Lithium battery Max 95%
-40C to 125C
-30 C to 115C MAX 5dBm Operation Temperature Transmitting Power Transmitting Frequency 315MHz or 433.92MHz Pressure Monitoring Range 0 ~ 116 psi (or O~800 kPa or O~8 bar) Pressure Reading Accuracy +1 psi (or +7 kPa ; +0.1 bar) Temperature Monitoring Range -30 C to 115C Temperature Reading Accuracy +
Module Weight 13.3g+ 19g
w 9 QO Safe Driving With ORO TPMS www.oro-technology.com This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. NCCHaa - (RIDA RSS :
"REIS Raa ES SIEM S Sa eR ASA Tata 18 ZS aR Se FEARS OO) Qo) sek eAS IAS iE BS BIAss . MARS SB Raval ZTE RIDBE SU (IDR SRS Z RANKS VERMRERTEA Ala | MERA THRE VGH WRSSRTBRA GALE -
AUR Ai8 ia Fak Ba ARLE ESR ZR Sa (ETD RAAB RAD RA HS LS SREB Ries Saxe ZTE 4