FCC ID: GM8BRC100 Bluetooth Remote Controller

BRC-100 Bluetooth Remote Controller Users Manual Version 1.0 2013/12 ID NO:

About This Manual This manual is designed to assist you in installing and using the Bluetooth Keyboard. Information in this document has been carefully checked for accuracy;

however, no guarantee is given to the correctness of the contents. The information in this document is subject to change without notice. Edition 1st Edition, Copyright Copyright 2013 This document contains proprietary information protected by copyright. All rights are reserved. No part of this manual may be reproduced by any mechanical, electronic or other means, in any form, without prior written permission of the manufacturer. Trademarks All trademarks and registered trademarks are the property of their respective owners. 1 FEDERAL COMMUNICATIONS COMMISSION STATEMENT You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the users authority to operate the equipment. This Equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the Federal Communications Commission

(FCC) rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if the not in accordance with installed and used instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to 2 radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into and outlet on a circuit is the receiver to which from that different connected. Consult the dealer or an experienced radio/TV technician for help. Operation is subject to the following two conditions:

1) this device may not cause interference and 3 2) this device must accept any interference, including interference that may cause undesired operation of the device. FCC RF Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Caution:

RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS. 4 Introduction Thank you for purchasing the Bluetooth Remote Controller. This Users Manual contains information that will help to operate the device as well as answering questions about certain special keys and buttons. Please keep this manual in a safe place for future reference. System Requirements iPhone 4/4S/5/5S iPad/ iPad2/ The New iPad/ iPad mini/ iPad Air Smart phones and tablet PCs with Android 3.0 or higher Bluetooth 2.1 or higher Package includes:

Bluetooth Remote Controller * 1, Manual * 1 5 Device pairing 1. 2. Turn on the Bluetooth from iPad/Smart Phone. Turn on the BRC-100 power and press the CONN button. (Please make sure the red LED is flashing) The deviceBluetooth Remote controller displays on iPad/Smart Phone. Then, choose Connect. 4. Start to use BRC-100. 3. Note: 1. Please press any key to re-establish the connection between BRC-100 and iPad/Smart Phone after turning the Power Switch On. 2. There is a power switch at back of the BRC-100. When not in use, please turn to OFF to save battery power. 6 Key function description:

Function name Android V+ / Shutter button Pre-track Play/Pause Increases the devices sound volume. Hold down to increase volume more quickly. Switches to the previous media track. Press once for each preceding media track. Switches between Play and Pause. Once Pause is pressed, pressing this button again resumes play. 7 ios Increases the devices sound volume. Hold down to increase volume more quickly. /

Shutter button Switches to the previous media track. Press once for each preceding media track. Switches between Play and Pause. Once Pause is pressed, pressing this button again resumes play. Next track

-

V-

Switches to the next media track. Press once for each subsequent media track. Decreases the devices sound volume. Hold down to decrease volume more quickly. Home / Siri Back to main screen. Backspace Move up Move left Enter key /

Shutter button Back to previous page Move up. Hold down to move up more quickly Move left. Hold down to move left more quickly Enter key /

Shutter button 8 Switches to the next media track. Press once for each subsequent media track. Decreases the devices sound volume. Hold down to decrease volume more quickly. Back to main screen. /

Hold down 1 seconds into the Siri system Non-function Non-function Non-function Non-function Move right Move down Move right. Hold down to move right more quickly Move down. Hold down to move down more quickly Non-function Non-function Troubleshooting Make sure installed the batteries correctly. Check to make sure the batteries installed are not dead. Try the batteries in another device. 9

Open View of EUT 1 Open View of EUT 2 Open View of EUT 3 Open View of EUT 4 Open View of EUT 5 Open View of EUT 6 Internal View of EUT 1 Internal View of EUT 2 Internal View of EUT 3 Internal View of EUT 4 BT Antenna Location

Front View of EUT Back View of EUT Side View of EUT 1 Side View of EUT 2 Side View of EUT 3 Side View of EUT 4 Battery

RF_ 160, issue 03 Declaration of Authorization We Name: ORtek Technology Inc. Address: 13F, Number 150, Jian-Yi Rd., Zhonghe Dist., New Taipei City, Taiwan, R.O.C. City: New Taipei City Country: Taiwan Declare that:

Name Representative of agent: Willis Chen Agent Company name: SGS Taiwan Ltd. Address: 134, Wu Kung Rd., Wuku Industrial Zone City: Wuku Area, New Taipei City Country Taiwan. is authorized to apply for Certification of the following product(s):

Product description: Bluetooth Remote Controller Type designation: BRC-100 Trademark: ORtek on our behalf. Date: Mar. 27, 2014 City: New Taipei City Name: naw!) 5 2 Function:

Signature:

Notes:

(1): Required for FCC application

(2): For FCC it must be the Grantee Code owner or the authorized agent.

FCC, Request for non-disclosure Date: 16-Jul-10 RF_501, Issue 6 Page 1 of 1 Company Name: ORtek Technology Inc. Address: 13F,Number 150, Jian-i Rd. ,Zhonghe Dist.,New Taipei City, Taiwan,R.O.C. City: New Taipei City Country: Taiwan To: Telefication B.V., Dept. FCC TCB Edisonstraat 12A 6902 PK ZEVENAAR The Netherlands Subject: Request for confidentiality FCC ID: GM8BRC100 Reference number: #HAAH Dear FCC TCB, 1. Long-Term Confidentiality Pursuant to 47 CFR Section 0.459(a) & (b), we hereby requests non-disclosure and confidential treatment of the following materials submitted in support of FCC certification application:

[_] Bills) of Material Block Diagrams Operational Description Schematic Diagrams [-] Tune-up Procedure Above materials contain secrets, proprietary and technical information, which would customarily be guarded from competitors under 47 CFR, section 0.457(d)(2). Disclosure or publication or any portion of this company confidential material to other parties could cause substantial competitive harm and provide unjustified benefits for competitors. 2. Short-Term Confidentiality (STC) Pursuant to Public Notice DA 04-1705 of the Commission's policy, in order to comply with the marketing regulations in 47 CFR 2.803 and the importation rules in 47 CFR 2.1204, applicant hereby requests Short-Term Confidential treatment of the following materials (note 1):

Date: Mar. 27, 2014 Name and signature of applicant: Andy Clow 4 i

Notes:

1) A document or type of document can only have ONE type of confidentiality!

2} Short-Term confidentiality is in principle for 45 days from date of grant; it can be extended max 3 times (total time 180 days max.}!

3) FCC must be informed when marketing begins earlier. 4) Release takes place automatically thus extension must be requested in time. Telefication does not remind you of this!

5) Request for extension or for release must be received by Telefication at least 7 days before date of actual marketing or before expiration of the STC period