REAR PANEL i ove, hleogH,O of high quality peakS,The Wireless Active 2.1 Stereo Speaker to provide si de g n ed The Retro series was e w po platform u rf l s series the past while being accented modernity much we have and look forwadto elevating your experiences of today We know you will enjoy it as uencedby the retro design of with a sleek is heavily in sound a I/
00
- DSP RoHS CE
@BRAND All rights reserved
-=-:.::--..."",.
't Canet,y.Wood oc16 lo SHOCKIWARD OOOOT wo.RNINl3.lOREDUllER(l=REORELE5HOCI{
OOTDEOUf'MEHT TONOR
""
IS/N SUPREME SOUNDS ModelESSENTIA SPEAKER FCC ID2ASRU-ESSENTIA This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. CJ AC 120V- 60Hz,
"""'Coo"9
@
1.Green light:full power 2.RED light:charging 3.Power Cable: Connect the included cable to the back of the speaker and then AC120V-60Hz power to the outlet 4 PAIRING A BLUETOOTH DEVICE 1.Power on the speaker and Bluetooth device 2.Move the selector switch to the BT position and the speaker will automatically enter pairing mode 3.Set your device to search for the nearest Bluetooth speaker and select from the list of discovered devices to complete the connection
*Note: The bluetooth peiodically indicator light will flash quickly during the pairing process and then once connected. It will flash slowly when music begins to stream
**Note: If you are unable to pair the speaker through 3 with your Bluetooth device repeat steps 1 SPECIFICATIONS bass reflex Rear firing Response:
Frequency 88dB3dB Sensitivity:
Impedance:
40 Drivers:
Cabinetry:
Weight:
Dimensions:
5.25" woofer, Wood 4.8 kg 50Hz-20 kHz3dB 1 .5" tweeter
(x2) 355mm (L) x 187mm (W) x 186mm (H) AUDIO SECTION Power Output:
50W (RMS) ACCESSORIES Booklet Instruction AC Cord ................................................................ Audio Cable .......................................................... .............................................. 1 1 1 are subject Note: Specifications improvement prior notice. without to change for continuous 5 NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by tuming the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help. Warning: Changes or modifications to this unit not expressly approved by the part responsible for compliance could void the user's authority to operate the equipment. FCC Radiation Exposure Statement The device has been evaluated to meet general RF exposure requirement. The device can be used in fixed/
mobilemin20cm exposure condition without restriction.