Wireless charger
user’s manual
A portable device can be charged by just placing “qi” standard
wireless charge compatible portable devices according to the
Wireless Power Consortium, such as portable phones,
smart phones, etc., on the charge area.
This function can not be used with portable devices that are
larger than the charging area. Also, depending on the portable device,
it may not operate as normal. Please read the operation manual for
portable devices to be used.
■The “qi” symbol
The “qi” symbol is a trademark of the Wireless Power Consortium.
■Name for all parts
(1) Operation indicator light
(2) Charge area
■Using the wireless charger
Use the ACC KEY of the car to turn the Wireless charger power ON/OFF.
Place the charging side of the portable device (etc. mobile phone) down.
When charging, the operation indicator light (orange) comes on.
If charging is not occurring, try placing the portable device as close to
the center of the charging area as possible. When charging is complete,
the operation indicator light (green) comes on.
Recharging function
・When charging is compatible and after a fixed timed
in the charge suspension state, charging restarts.
・When the portable device is moved, charging is stopped for a moment
and then it restarts.
■Lighting conditions of operation indicator light
Operation indicator light
Conditions
Turning off
When the wireless charger power supply is off.
Green (comes on)
On standby (charging possible state)
When charging is complete. *
Orange (comes on)
Charging
When placing the portable device on the charging area (detecting the
portable device)
*Depending on the portable device, there are cases where the operation
Indicator light will continue being.
(2)
(1)
Since this device is always used with vehicle, it is not sold to general end users
separately. Therefore there is no user manual of this device by alone.
The following statements must be described on the user manual of the vehicle;
[For FCC]
This device complies with part 15 and part 18 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
FCC CAUTION:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a
wireless power charger, pursuant to part 18 of the FCC Rules.
This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio communications,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines. This equipment should be installed and operated keeping the
radiator at least 20cm or more away from person’s body.
The contact information for maintenance is described in the car manual by the
manufacturer of the car in which this wireless charger is installed.
[For ISED]
IC : 216J-AT2301
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
1.This device may not cause interference.
2.This device must accept any interference, including interference that may
cause undesired operation of the device.
This equipment should be operated keeping at least 10cm or more away from
person’s body.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences et Développement économique
Canada applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes :
1.L’appareil ne doit pas produire de brouillage;
2.L’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
Cet équipement doit être utilisé en gardant au moins 10 cm ou plus loin du
corps de la personne.