FCC ID: 2AI3T-ISB184 Bluetooth Speaker

Aux In FCC WARNINGS ADDITIONAL WARNINGS International Support Contact Information Requires a 3.5mm audio cable (not included). 1. Connect a 3.5mm audio cable to the Aux In on the soundbar and the audio output on an audio device. 2. The soundbar will automatically switch to Aux Mode. 3. Use the controls on the connected device to select and play audio. Be sure the volume on your connected device is audible when you begin playing. Only the volume control on the soundbar will work in Aux In mode. Light Modes Press the Power/Mode/Lights button twice to cycle through LED light modes: breathing, fast flash, slow flash, steady, and lights off. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. The LED lights have five colors: Red, Blue, Green, Increase the separation between the equipment and receiver. Light Blue, and White. Voice Prompts To turn voice prompts on/off, press and hold the Volume Down/Previous Track and Volume Up/

Next Track buttons at the same time for 5 seconds. The soundbar will chime when voice prompts are successfully turned on/off. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. WARNING: To prevent fire or shock hazards, do not expose this unit to rain or moisture. WARNING : Where the mains plug or appliance coupler is used as the disconnect device, such disconnect device shall remain readily operable. Lithium batteries, like all rechargeable batteries, are recyclable and should be recycled or disposed of according to state and local guidelines. They should never be disposed of in normal household waste and they should never be incinerated, as they might explode. Contact your local government for disposal or recycling practices in your area. WARNING : This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to: www.P65Warnings. ca.gov. This product meets and complies with required Federal product guidelines. To download this Users Guide in English, Spanish, or French, or to get answers to frequently asked questions, visit the support section at:

www.iLiveElectronics.com Para descargar este Manual del Usuario en Ingls, Espaol y Francs, o para obtener respuestas a preguntas frecuentes, visite la seccin de apoyo en:

www.iLiveElectronics.com Pour tlcharger ce guide de lutilisateur en Anglais, Espagnol ou Franais, ou pour obtenir des rponses des questions frquemment poses, consultez la rubrique dassistance sur:

www.iLiveElectronics.com Website: www.iLiveElectronics.com Email Support: prodinfo@dpiinc.com Email Parts: partsinfo@dpiinc.com Phone Support: 1-888-999-4215 Warranty For Warranty Information and the most up-to-date version of this Users Guide, go to:

www.iLiveElectronics.com. Made Green Protect for Today Sustain for Tomorrow Specifications are subject to change without notice. Copyright 2023 Digital Products International (DPI, Inc.) All other trademarks appearing herein are the property of their respective owners. 18" Multimedia Sound Bar Users Guide for Model ISB184 v3167-01 Features Overview & Controls Bluetooth v5.3 Wireless range: 33 ft. 18 sound bar Voice prompts announce speaker functions Color changing LEDs Aux In MicroSD and USB inputs (up to 64GB) Micro-USB port for battery recharge DC battery power: built-in rechargeable battery Battery life: approx. 4 hours at 50% volume Includes Micro-USB to USB charging cable Users guide 1 2 3 4 5 1. Power ON/OFF, Mode, and Lights Press and hold to turn soundbar on/off. Press twice to cycle through LED light modes. 2. LED Indicator Light 3. Volume Down/Previous Track Press once to decrease volume. Press and hold to go to the previous track. 4. Volume Up/Next Track Press once to increase volume. Press and hold to go to the next track. 5. Play/Pause/Call Press to play/pause current track or to answer a call. Press and hold to pair/unpair a device. Inputs 2 3 1 4 5 1. MicroSD Slot 2. USB Port 3. Aux In 4. LED Charging Indicator 5. DC Power Input Battery Power Pairing Bluetooth & Playing Audio USB and MicroSD Charge fully before use. For best results, charge Note: This model features automatic Bluetooth pairing. Supports USB drives and MicroSD cards up to 64GB. 1. Insert a USB drive or MicroSD card into the matching port on the soundbar. 2. The soundbar will automatically switch to External Media Mode. 3. Use the controls on the connected device to select and play audio. wil the soundbar is off. The charge time is approximately 4 hours. When the soundbar is charging, the LED Charging Indicator will display a solid red light. When charging is complete, the indicator will turn off. Using a Micro-USB to USB cable (included), connect the DC power input on the soundbar to the USB port of a powered-on computer or USB power adaptor (not included) to charge the soundbar. 1. Power on the soundbar, a voice will announce Bluetooth, when the unit is ready to pair. The LED Indicator Light will also flash blue. When pairing, remain within 3 feet of the unit. 2. Using the controls on your Bluetooth device, select ISB184 in the Bluetooth Settings to pair. A voice will announce Bluetooth is connected, and the Bluetooth LED Indicator will turn a solid blue when the soundbar is successfully paired to your device. If need be, refer to the users manual for your specific device for more information. 3. Use the controls on the connected Bluetooth device to select tracks, play, pause, or answer an incoming call. TWS 1. Power on two ISB184 soundbars, both in Bluetooth mode. 2. Press the Play/Pause/Call button twice on one soundbar to activate TWS. 3. A voice will announce Speaker connected to indicate the two units are connected. Audio will now play through both soundbars.

40*20mm FCC ID: 2AI3T-ISB184 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesire d operation.

Panorama Tech (HK) Co.Ltd. 2023.11.13 Eurofins Electrical and Electronic Testing NA, Inc. 914 W. Patapsco Avenue Baltimore, MD 21230 USA RE: LETTER OF AGENT AUTHORIZATION To Whom It May Concern:

We, the undersigned, hereby authorize Shenzhen BCTC Testing Co., Ltd to act on our behalf in all matters relating to application for equipment authorization, including the signing of all documents relating to these matters. We also hereby certify that no party to the application authorized hereunder is subject to the denial of benefits, including FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C.853(a). This agreement expires one year from the current date. Sincerely, Clients signature:

Clients name / title : pin wang / Manager Contact information / address: 6th, block 2, huafeng technology industry park, gushu, baoan, Shenzhen, China

Panorama Tech (HK) Co.Ltd. 2023.11.13 Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: Attestation Statements Part 2.911(d)(5)(i) request for FCC ID: 2AI3T-ISB184 Panorama Tech (HK) Co.Ltd. certifies that the equipment for which authorization is sought is not covered equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules. Sincerely, Applicant signature:

Applicant printed name: Pin wang/ Manager Panorama Tech (HK) Co.Ltd. 2023.11.13 Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: Attestation Statements Part 2.911(d)(5)(ii) request for FCC ID: 2AI3T-ISB184 Panorama Tech (HK) Co.Ltd. certifies that, as of the date of the filing of the application, the applicant is not identified on the Covered List as an entity producing covered equipment. Sincerely, Applicant signature:

Applicant printed name: Pin wang/ Manager

Panorama Tech (HK) Co.Ltd. 2023.11.13 Eurofins Electrical and Electronic Testing NA, Inc. 914 W. Patapsco Avenue Baltimore, MD 21230 USA RE: CONFIDENTIALITY REQUEST FOR EUT NAME: Bluetooth Speaker MODEL: ISB184 FCC ID: 2AI3T-ISB184 To Whom It May Concern:

This letter serves as an official request for confidentiality under sections 0.457 and 0.459 of CFR 47. We have requested that the

- Block Diagram

- Schematics

- Operational Description required to be submitted with this application be permanently withheld from public review. The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. Please contact me if there is any information you may need. Sincerely, Clients signature:

Clients name / title : pin wang / Manager Contact information / address: 6th, block 2, huafeng technology industry park, gushu, baoan, Shenzhen, China

Panorama Tech (HK) Co.Ltd. U.S. Agent Designation for Service of Process

(Applicant and U.S. Agent are Separate Parties) TO: Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046, USA ATTENTION: FCC Certification Section 2.911(d)(7) Information Designated U.S. Agent Company Name: Digital Products International, Inc. FRN: 0033619347 Contact Name: Lizzy Schubert Street Address: 900 North 23rd Street City/Province/Zip: Saint Louis, MO 63106 Telephone No: (314) 657-2413 Email: Idonahower@dpiinc.com This letter is to confirm that we (Digital Products International, Inc.) have accepted the responsibility to act as the Designated U.S. Agent for Service of Process as required by section 47 CFR 2.911(d)(7) on behalf of the Applicant noted below. U.S. Agent Signature: Lizzy Schubert Date: 2023-1 |-13 Signed by (Printed Name/Title): Lizzy Schubert /VP Marketing The Applicant acknowledges that they must maintain an agent for no less than one year after terminating all marketing and importation OR the conclusion of any Commission-related proceeding involving the equipment. The applicant further acknowledges their responsibility to inform the FCC whenever the Designated U.S. Agent information above changes. Applicant Company name: Panorama Tech (HK) Co.Ltd. FRN: 0025727066 FCC ID: 2A13T-ISB184 Contact Name: pin wang Street Address: 6th, block 2, huafeng technology industry park, gushu, baoan, Shenzhen, China Telephone No: +860755-33659938 Email: sales@panoramatech.net Applicant Signature: pin wang Date: 2023-11-13 Signed by (Printed Name/Title): pin wang / Manager