HoverCam.com HoverCam.com 1.Powering On To first use the Ultra 10,you can plug the included power cord into an available power outlet ,and plug the other end of the cord into the Ultra 10 Type-c outlet . to power outlet When the battery is full, you can remove the power cord and power it directly through the battery Next ,press and hold the power button for five seconds . Boot-up time is approximately 60 seconds. 2.Connecting to Display To connect Ultra 10 with HDMI,simply insert an HDMI cable to the HDMI-Out port on the Ultra 10 and the display you wish to use .Make sure the HDMI Switch is set to OUT. Interactive Display 3.Connecting to Display The Ultra 10 can be operated with a U Disk,with bluetooth mouse or wired mouse, andthekeyboard U Disk Bluetooth Mouse Wired Mouse Installation:
Before use the DotCam RED, You need to install the Flex 11".you can download the software on
"HoverCam Flex 11" for download
,then you found the Support Menu,and Click to Download,Then select www.HoverCam.com HoverCam.com 10 10 to 15 and part installed pursuant Statement reasonable and, if cause energy may device, to This equipment rules. harmful not harmful the FCC against of protection These limits interference FCC comply with the limits for a Class This equipment has been tested and found to are B digital in a provide designed generates, uses and can radiate radio residential installation. the frequency communications. instructions, However, there is no guarantee that interference will not occur in a particular installation. or equipment off and television reception, which can be determined by turning the on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help. outlet on a circuit different from that to which in radio interference interference accordance used to equipment harmful cause radio does with this to If for Responsible equipment. computer or peripheral devices). compliance this
(Example- use only shielded interface cables when connecting to authority operate users could void the to
&KDQJHV
IRU
$Q\
UHVSRQVLEOH
HTXLSPHQW
RU
FRPSOLDQFH
PRGLILFDWLRQV
FRXOG
QRW
YRLG
H[SUHVVO\
XVHU V
WKH
DSSURYHG
DXWKRULW\
E\
WR
WKH
RSHUDWH
SDUW\
WKH
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) received, that may cause undesired operation. interference interference including accept device must This any Radiation Exposure Statement:
FCC The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.