Product Description corresponding SAM card slot 2) SIMIUIM Card instalation 1D Open up battery cover, which is at the bottom of the terminal; ) Take out battery; Insert SIMUIM card to corresponding SIMIUIM card slot, 3) Battery Installation 1D Hold the battery with its sticker facing up. @) Attach battery forelock to battery bayonet ; Press down the ther side of the battery Instruction 4) Power ON/IOFF display screen 4) Tearing off receipt from the terminal Aer the receipt is printed, pinch the end of the receipt and keep an angle of 45 degrees between receipt and the cutter ofthe terminal tear off the receipt switly Specifications Default cPU 32-bit, ARMS Memory MB FLASH, 16MB SDRAM Display 4128X 64 pixel LCD, LED backlight Keypad 40 alphanumeric keys, 8 function PAX TECHNOLOGY LIMITED reserves the right to change product technology ing. specifications without noti Nanepite Bathe Pad ee
\zatey igure 2: Bottom View 1 Figure 4: SAM/SIM Card Slots Installation eo . 41), SAM Card Installation 1D Open up battery cover, which is at the bottom of the terminal; 2) Take out battery; Insert SAM card to 2 2 3) FCN: OR: ETSOS! POO GAN RUNON'TT & SSCCNeE WERE LED backlight is on, and the buzzer will beep if POS is being turned on successfully Power off: Press power switch button for 2 seconds until the clsplaying content vanishes. POSis being tured off Magnetic Stripe Card When user swipes magnetic stripe card along the sit, the backside of the card, which contains magnetic stripe information, should be facing to the terminal. Bi-directional swiping is supported. It is recommended to swipe starting from the top of the terminal to the bottom of the terminal, with a constant moving speed ICeard When user inserts IC card into the IC alot the chip of IC ard should be facing up; user is recommended to gently insert the card, in order to avoid any physical damage to the card oF the IC slot ofthe terminal. IC eard is successfully read by the terminal, the IC card icon will be shown on LCD. 3 BIR eye One T Seen PI ey Magnetic Card Reader Track 1/2/3, bidirectional swipe ICCard Reader 1 user card (EMV2000) SAM Slots 2,1SO7816 Communication GSM, GPRS er COMA Peripheral Ports 1 RS232, 1 power charge por, 1 Handset port Printer Thermal printer, Speed: 12.5 lines/see Paper width:58mm Paper roll outside diameter:38mm Battery Lirion battery. 1800mAh, 7.4V, Over 40 hours of standby time Input: 100~240VAC, SOHzI60H2, 1.08, Output9.5V0C. 4A Working Environment Temperature: 0 ~50(92T~120) RH.: 10% 90% non-condense) Storage Environment Temperature:~200-70C(-41F ~150) RLH.:5%~95% (non-condense) Power Supply PAX PAX TECHNOLOGY LIMITED Room 2416, 24/F, Sun Hung Kai Centre, 30 Harbour Road, Wanchai, Hong Kong Tel: #882-2588 8808 Fax: +852-2802 3300 Eamail: daniel@pax.com ik Website: wow pax. com hk: