G... Dimensions 418mm x 87mm x 6.5mm (LxWxH) 9) Donot assemble the terminal in explosion hazardous area Weight 485% ;
Optional a Battery Usage Tips Memory: 8MB FLASH , 16MB SDRAM 6]
Bultin Fi module no GSM, GPRS or COMA) Builtn dial-up Modem [ Sync(HOLG up to 9600bps, V.21, 1) Charge indoor by PAX charger, where is cool and well V.22M22is V.29) ventilated;
syne (V.32NV 32bis up to 1400bps) | 2) Dont apart the battery:
Buitin contactless card reader moduieSONEC 14443 Type NB, 3). Donot short circuit the battery Mitare ) 44) Keep the battery away from sunshine, smog and dust Leather Casing, Charging Dock, Car Jack Charger 5) Do not squeeze, punch the battery, putt into liquid or near
: ; fre Installation and Usage Tips 6) Keep way fem envrenment which is too hot, too cod cx damp and highly explosive:
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and lused in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a Particular installation. f this equipment does cause harmful interference to radio or television reception, which can be determined by tuming the equipment off and en, the user is encouraged to try to correct the interference by one or more ofthe folowing measures:
Rectient or relocate the receiving antenna Inerease the separation between the equipment and Connect the equipment into an outlet on circuit different the requirements adopted by the ACTA. On bottom of this equipment i a label that contains, among other infermation, 2 product identifer of [US: PAXNIMOOBS9O]. If requested this number must be provided to the telephone company. Ifthis equipment [Mobile Payment Terminal] causes harm to the telephone network, the telephone company wall natty you in advance that temporary discontinuance of service may be required, But f advance notice isnt practical, the telephone company wil notify the customer as soon as possible. Also, you will be advised of your right to file a Complaint with the FCC if you believe itis necessary. If the telephone company requests information on what equipment is connected to thet lines, inform them of. a) The telephone number that this unit is connected to:
(ipo (Installation Manual s90 Mobile Payment Terminal 2) 3) 4) 5) 8 7 8) Do not damage electric wire and power adapter. If electric wire oF power adapter is damaged, please do net use the terminal any more, Before power adapter is plugged into power socket, please make sure that vokage which the power socket supplies is appropriate working voRage forthe terminal Do nt expose the terminal in sunshine, or in humid, hot, oF dusty environment Keep the terminal away from liquid material, Do not plug any unknown material into any port of the terminal, since it may ereate serious damage to the terminal Ifthe terminal is defective, please contact professional POS, repair technicians, When instaling paper rol, please be aware of the cutter within paper bracket, Please use standard thermal paper, in order to protect the printer and avoid paper jam, 5 1) Once & telwe happens Sick 38. Hening or Ceerton, 2:5 was broken down, Please change new battery 8) Change new battery ift cannet satisfy your requirement, 9) Change new battery if using more than two years, Foe warning Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment This device complies with part 15 of the FCC Rules,
(Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide Feasonable protection against harmful interference in a 6 from that to which the receiver Is connected. Consult the dealer or an experienced radio/TV technician forhelp, Specific Absorption Rate (SAR) information This wireless phone meets the government s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies, The standards Include a substantial safety margin designed to assure the safety ofall persons regardless of age or health, The exposure standard for wireless mobile phones employs 2 unit of measurement known as the Specific Absorption Rate, of SAR, The SAR limit set by the FCC is 1.6 WiKg, Customer Information 1. This equipment complies with Part 68 of the FCC rules and 7 9). The ringer equivalence number (0.055
) The USOC jack required [RJ11C};
) The FCC Registration Number (US: PAXMMOOBSEO)
) Items (b) and (d) are indicated on the label. The ringer equivalence number (REN) is used to determine how many devices can be connected to your telephone line. In most areas, the sum of the RENS of all devices on any one line should not exceed five (6.0). Iftoo many devices are attached, they may not ring property Service Requirements Inthe event of equipment matfunction, all repairs should be performed by our Company or an authorized agent. Itis the responsiblity of users requiring service to report the need
{for service to our Company oF to one of our authorized agents, Service can be facitated through our offce a PAX Technology Ine. 560 Broadhollow Road, Suite 100 Melville, New York 11747. PAX TECHNOLOGY LIMITED