2.4 G wireless Remote controller instructions Speed indicator Remote indicator light Forward/back ward left/ right Stop Speed selection The code (car-select key) 1, The first time of using, steps are as follows:
press the car-select key until the remote control ights flashing open the power supply of the car the light Stopped after 3 seconds ,it means car-select succeed, loosen the button, remote control can be used. If the remote light is always on, please restart your baby car power to repeat this step. When the code is successfully matched, it realizes many sets of the same area cars one-to-one control.If you can t use the remote, please match the code again. 2, In the process of driving, can choose according to the needs of driving gear to control speed, manual/remote independently control the speed:a, when use the remote control mode: according to "speed selection" button, top led speed indicator (3) or low gear led speed indicator (1);b, manual control, using the gear stick on the car, from which you can choose top gear or low gear. 3, It has a stop button on the remote control, can be used under any circumstances, hold down the stop button, the car no matter in the case of manual or remote control, can immediately stop, can't operate. Ascending parents to control over cars and improves security;
1, This remote control car operation is adult and children who ride in the car ,their distance shall not exceed 10 m range. 2, Only allow guardian to use remote control, can not let the children touch. 3, Before the remote control, read the instructions carefully, and empty experiments, familiar with the master, then can make children ride . 4, If not use the function of remote control, the remote control on the body/manual switch should be in the "manual" position, avoid other electromagnetic interference. 5, The remote control can not let it get in the rain or any other way of flooding to avoid line damage. 6, If remote distance less than 3 meters, it means remote control battery is insufficient, shall replace NO.5 alkaline batteries (1.5 V) two PCS. Battery Battery Warning Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.