PLEASE NOTE:
This equipment has been tested and found to comply with the limits fora Class B digital device, pursuant to Part 15 of the FCC Rules, These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee thal interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by tuming the equipment of and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna,
- Increase the separation between the equipment and receiver,
- Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.
- Consult the dealer or an experienced radio/TV technician for help, INSTRUCTION MANUAL 6+
ITEM NO. 3532 SLL LLL TROUBLE SHOOTING am aaa Problems Reasons Solution The alkaline battery inside the radio control is too weak. *
ene Replace with new alkaline VA il A li A roblems i P batteries. LICENSED PRODUCT There is a weak or low Yamaha, the Tuning Fork Mark, Raptor 700R, and the reception for the radio control. likeness thereof including the graphics and color Yamaha Team Blue are trademarks of Yamaha Motor used under license. yamaha-motor.com Manufactured & Distributed by
* 2008 sober Full-size ATV's can be hazardous to operate. The Rathi 7OOR Raptor, YFZ450 and Grizzly are recommended AN IADE IN CHINA A small object obstructs Use tweezers or a paper clip Rs anh Dy eens ie TO ae oe SenuEleneievreoom movement of the tire or axle. to remove obstruction. ree. IF ATV DOES NOT RESPOND PROPERLY, PLEASE
*IMPORTANT- REPLACE BATTERIES IN ATV (3 AAA NOT INCLUDED) The vehicle was driven on the Playing on the carpet is not AND BATTERY IN CONTROLLER (1 9V NOT INCLUDED). carpet and has fabric threads recommended. caught in the axle.
"NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.
: SUCH MODIFICATIONS COULD VOID THE USER'S The vehicle does not respond to the radio control. Pp Try playing at another location. AUTHORITY TO OPERATE THE EQUIPMENT. WARNING:
Other Changes or modifications to this unit not expressly approved by the party pease pONOT Some other equipment using responsible for compliance could void the user's authority to operate the RETURN TO STORE The radio control's frequency the same radio wave could Sqiapmnent. Gerais easing is disrupted by something disrupt the radio control. _ This device complies with part 15 of the FCC rules. Operation is subject to 1877-FUN-TOYS around the environment. Either play in another location the following two conditions: :
or turn off other equipment. 1. This device may not cause harmful interference, and 2. This device must accept any interference recieved, including interference cane vary. that may cause undesired operation of the device. for future reference. CHECK LIST NOTE:
To precent damage, the contents of the package that are listed below have been packed in the tray and may be out of plain sight. Please remove all contents from the tray. BATTERY REQUIRMENTS:
ATV: 3 "AAA" Batteries (not included) CONTROLLER: 1 9V Battery (not included) ak CONTROLLER START UP Unscrew and remove the battery covers on both the controller and the R/C ATV. Insert 3 AAA Batties (not included) into the R/C ATV and 1 9V battery (not included) into the controller unit. Then replace the battery covers and tighten the screws (see diagram #1 and #2). Diagram #1 Diagramme No. 1 Unscrew the battery cover. PLEASE NOTE:
A) Make sure the batteries have been inserted correctly (+ or -) into ATV and controller. B) If the ATV does not respond properly, please replace the alkaline batteries in the ATV and/or controller battery.
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon zinc), or rechargeable (nickel-cadmium) batteries.
- Do not dispose of batteries in fire, batteries may explode or leak. OPERATING THE CAR 1. Turn the power switch to ON" on the R/C ATV.
(see diagram 3) 2, Turn the power switch to ON" on the controller.
(see diagram 4) 3. Press the left and right lever to drive your ATV in all directions. (see diagram 5) 4. Adjust the fine tune steering lever located under the ATV to keep it moving straight. 5. After use, turn OFF the ATV and the R/C controller. 6. If the ATV is to be unused for a relatively long time, remove all batteries from the ATV and the R/C controller. FCC NOTE:
THE ANTENNA PROVIDED IS A UNIQUE ANTENNA. BY INSTALLATION OF UNAUTHORIZED ANTENNA TO THIS EQUIPMENT, SUCH UNAUTHORIZD INSTALLAT COULD COID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT. THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT