RIC BATTERY CAUTION:
1.Alkaline battery is recommended. 2.Non-rechargeable batteries are not to be recharged. 3.Rechargeable batteries are to be removed from the toy before being charged. 4.Rechargeable batteries are only to be charged under adult supervision. 5.Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries. 6.Do not mix old and new batteries. 7.Only batteries of the same or equivalent types as recommended are to be used. 8.Batteries are to be inserted with the correct polarity. 9.The supply terminals are not to be short-circuited. 10.If batteries are loose, bend out the contacts for a tight fit. 11.Exhausted batteries are to be removed from the toy and be disposed of immediately; never dispose of batteries in fire. 12.If storing product for long periods of time, make sure to remove batteries. 13.Check the product periodically for signs of damage to electrical parts; do not play with product until damage has been properly assessed. If the unit malfunctions, please remove the batteries for one minute and reinstall again. If the malfunctions persist, please replace with new batteries. BATTERIES SHOULD BE INSTALLED BY ADULTS ONLY. 1:18 1968 Ford Mustang INGES) Z\ WARNING:
a UP CHOKING HAZARD - smaii parts Not for children under 3 years f Y G oye A QV
O_AA_ OF 5 x AA/ LR6 1x9V 3 x AAALRO3 Don't Put In Trash. Batteries Battery Batteries Recycle or Dispose as
(NotIncluded) (NotIncluded) (Included) Hazardous Waste. L For Vehicle ForTransmiter For Engine BATTERIES SHOULD BE INSTALLED BY ADULTS ONLY. Content )
- Transmitter... sees X 1pc
{| ANTOENNA.......cecsessteceeeeees xX 1pc MUSTANG......scsscsecseeseees xX 1pc
" Engine with Stand....x 1pc w 2
1, 2. Battery Installation- Mustang Make sure the power switch is on OFF position(Pic.1). Use a screwdriver to loosen the screw on the battery compartment anti-clockwise (Pic.2). Open the battery door (Pic.2). %
Put 5x AA batteries in the battery compartment as per the polarities shown inside. Close the battery door and tighten the screw clockwise. Battery Installation- Transmitter 1. Make sure the power switch is on OFF position. Use a screwdriver to loosen the screw on the battery compartment anti-clockwise. Put the 9V battery in the battery compartment as per the polarity shown inside (Pic.3). Close the battery door and tighten the screw clockwise. Battery Installation- Engine stand 1. 2. 3. Use a screwdriver to loosen the screw on the battery compartment anti-clockwise. Put the 3x AAA battery in the battery compartment as per the polarity shown inside. (Pic.4). Close the battery door and tighten the screw clockwise. I; ab oe, Q fh =
Caution: changes or modifications not expressly approved by the party responsible for compliance could q void the user's authority to operate the equipment. a Sy) i vas a Engine installation-Mustang rc Step 1 Make sure the power switch is on OFF position.
(Step 4 Take out the engine from engine stand
Step 2 Turn the engine lock knob to unlock position. 7 Take out the engine hood from the Mustang.
engine socket
( Install the engine to the Mustang and make sure each engine contact is contacted to lock knob to lock position.
(Finally turn the engine +) and sound. XN FCC Statements This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
How To Play - Engine Stand Press the engine top or engine stand for engine vibration , 1) This device may not cause harmful interference, and 2) This device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply within the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, this is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
+ Reorient or relocate the receiving antenna.
+ increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.
+ Consult the dealer or an experienced radio/TV technician for help.
+ Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. Colors & contents may vary. Please keep this packaging for future reference. Conforms to the safety requirements of ASTM F963 and EN-71. 2009 PLAYMIND LTD. Room 413-415, Houston Centre, 63 Mody Road, Tsim Sha Tsui East, Kowloon, Hong Kong Visit us at: www.playmindltd.com LL 2009 Rev 1.0 BACKWARD LEFT ENGINE SOUND
(ACTIVATED AFTER ENGINE INSTALLED) J DESIGN.D EDMOND SALE.D ENGINES.D PRODUCTION.D DIRECTOR.D