(AGES) A WARNING: | (@) &
CHOKING HAZARD - small parts Not for children under 3 years C 1797 BATTERY CAUTION: r ~
1.Alkaline battery is recommended. Battery Requirement For _ Battery Requirement For 2.Non-rechargeable batteries are not to be recharged. the Car: the Transmitter:
3.Rechargeable batteries are to be removed from the toy before being charged. 4.Rechargeable batteries are only to be charged under adult supervision. (CAAA @p 5.Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries. 6.Do not mix old and new batteries. { aaa CO + 6F22 7.Only batteries of the same or equivalent types as recommended are to be used. ( aaa @
8.Batteries are to be inserted with the correct polarity. [O _ Aaa @} H I 9V a 9.The supply terminals are not to be short-circuited. 10.If batteries are loose, bend out the contacts for a tighter fit. , 11.Exhausted batteries are to be removed from the toy and be disposed of immediately; never 4x AAA/LRO3 1x9V/6F22 Don't Put In Trash. dispose of batteries in fire. Batteries Battery Recycle or Dispose as 12.If storing product for long periods of time, make sure to remove batteries. (Not Included) (Not Included) Hazardous Waste. 13.Check the product periodically for signs of damage to electrical parts; do not play with ) product until damage has been properly assessed. Caution: changes or modifications not expressly approved by the party If the unit malfunctions, please remove the batteries for one minute and reinstall again. responsible for compliance could void the user's authority to operate the If the malfunctions persist, please replace with new batteries. equipment. BATTERIES SHOULD BE INSTALLED BY ADULTS ONLY. Content Transmitter..........X 1c Antenna.............X 1c Pro Kart......eeeeeeeX TC Battery Installation- Car Battery Installation- Transmitter 1. Make sure the power switch is on OFF position (Pic.1). 1. Make sure the power switch is on OFF position. 2. Use a screwdriver to loosen the screws on the 2 battery cases anti-clockwise (Pic.2). 2. Use a screwdriver to loosen the screw on the battery case anti-clockwise (Pic.4). 3. Open the battery doors (Pic.3). 3. Put the 9V battery in the battery compartment as per the polarity shown inside (Pic.4). 4, Put 4 x AAA batteries in the battery compartment as per the polarities shown inside (Pic.3). 4, Close the battery door and tighten the screw clockwise. 5. Close the battery doors and tighten the 2 screws clockwise.
(Pic.1) (Pic.2) (Pic.3) r To Adjust Steering Alignment Adjust the steering alignment when the vehicle does not run straight forward 7 : em) 7 ON/OFF Switch alg &
4x AAA/LRO3 (Pic.4) Turn the steering alignment lever towards _ Turn the steering alignment lever towards Batteries io =" 1X9V/6F22 L" if the vehicle runs towards right. R if the vehicle runs towards left. (Not Included) Battery (Not Included) N FCC Statements r \
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: How To Control 1) This device may not cause harmful interference, and FEATURES & FUNCTIONS:
2) This device must accept any interference received, including interference that may cause undesired operation. Functions : Forward, Backward, Turn Left, Turn Right. NOTE: This equipment has been tested and found to comply within the limits of a Class B digital device, pursuant to Part Arms move with every turns. 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installation. This equipment generated, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harm to radio communications. However, this is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
POWER LED ON/OFF
. Par RIGHT
+ Reorient or relocate the receiving antenna.
+ increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.
: . a fa) Consult the dealer or an experienced radio/T Vv technician for help. 2010 PLAYMIND LTD. i
* Warning: Changes or modifications to this unit not expressly approved by the party Room 413-415, Houston Centre, BACKWARD LEFT :
responsible for compliance could void the users authority to operate the equipment. 63 Mody Read, Tsim Sha Tsui East, % This RC vehicle comes with 2 bands that allows eS
. ow'oon, Hong Kong playing kart racing together with 2 karts. Colors, designs & contents may vary. Email info@playmindltd.com % Use the right band to ensure control of your kart Please keep this packaging for future reference. Medeln chine ymnemacom |__and avoid interferences with another kart. Conforms to the safety requirements of ASTM F963 and EN-71. 2010 Rev 1.0