FCC ID: 2A62O-PDT015CXD Remote Controller

REMOTE CONTROL INSTRUCTIONS Battery Replacement 1. Locate the push button near the battery tray at the rear. 2. Using a pin or similar object with a fine tip, press and hold down on the button while pulling on the battery tray to disconnect the tray from the remote controller. 3. Remove the pin and continue to pull the battery tray out completely. 4. Replace the old battery with a new one (Battery type: CR2032). Be sure the new battery is installed with the correct polarity (+ and -). 5. Push the battery tray back into the remote controller. WARNING 1. Dispose used battery properly. Observe local regulations regarding disposal of hazardous waste. 2. Ensure the batteries are installed correctly with regard to polarity (+ and -). 3. This product is powered by a lithium battery. Due to their small size, lithium batteries can easily be swallowed by children. Ingestion of such batteries has been known to cause death. 4. This product contains a lithium battery which if swallowed has been known to cause death. 5. Do not expose light set to moisture. 6. Remove batteries when not used for an extended period of time, or when depleted. 7. Clean the battery contacts prior to battery installation. 8. The external flexible cable or cord of this luminaire cannot be replaced; If the cord is damaged, the luminaire shall be destroyed. 9. Dispose of used batteries properly by following directions on batteries. 10. Use only CR2032 batteries for the remote controller. 11. DO NOT DISPOSE OF BATTERIES IN FIRE. BATTERIES MAY EXPLODE OR LEAK. 12. Non-rechargeable batteries are not to be recharged. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with Innovation, Science, and Economic Development Canadas licence-exempt RSS standard(s). Operation is subject to the following two conditions:

(1) this device may not cause interference, and

(2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR d' Innovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes :

(1) l'appareil nedoit pas produire de brouillage, et

(2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. This equipment complies with FCC/ISED radiation exposure limits set forth for an uncontrolled environment. L'appareil est conforme aux limites d'exposition aux rayonnements spcifies par la FCC/ISED pour les environnements non contrls. Model(s) No.: PDT-015-01, PDT-015-02, PDT-015-03, PDT-015-04, PDT-015-05, PDT-015-06, PDT-015-07, PDT-015-08, PDT-015-09, PDT-015-10, PDT-015-11, PDT-015-12, PDT-015-13, PDT-015-14, PDT-015-15

Model: PDT-015-01 Label Label Location Information Model: PDT-015-02 Label Label Location Information Model: PDT-015-03 Label Label Location Information Model: PDT-015-04 Label Label Location Information Model: PDT-015-05 Label Label Location Information Model: PDT-015-06 Label Label Location Information Model: PDT-015-07 Label Label Location Information Model: PDT-015-08 Label Label Location Information Model: PDT-015-09 Label Label Location Information Model: PDT-015-10 Label Label Location Information Model: PDT-015-11 Label Label Location Information Model: PDT-015-12 Label Label Location Information Model: PDT-015-13 Label Label Location Information Model: PDT-015-14 Label Label Location Information Model: PDT-015-15 Label Label Location Information

Company Name: Polygroup Evergreen Limited Add: Unit 606, 6th Floor, Fairmont House, No.8 Cotton Tree Drive, Central, Hong Kong Tel: 86-769-83915520-2802 Email: michael.wang@polygroup.com Attestation Letter Date: 2024-03-27 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Ref: Attestation Statements CFR 47 2.911(d)(5)(i) Filing FCC ID:2A62O-PDT015CXD Polygroup Evergreen Limited certifies that the equipment for which authorization is sought, is not covered equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules. Sincerely, Signature Michael Wang Manager CFR 47 2.911(d)(5)(i) Attestation Letter

Company Name: Polygroup Evergreen Limited Add: Unit 606, 6th Floor, Fairmont House, No.8 Cotton Tree Drive, Central, Hong Kong Tel: 86-769-83915520-2802 Email: michael.wang@polygroup.com Attestation Letter Date: 2024-03-27 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Ref: Attestation Statements CFR 47 2.911(d)(5)(ii) Filing FCC ID:2A62O-PDT015CXD Polygroup Evergreen Limited certifies that as of the date of the filing of the application, the applicant is not identified on the Covered List as an entity producing covered equipment. Sincerely, Signature Michael Wang Manager CFR 47 2.911 (d)(5)(ii) Attestation Letter

Company Name: Polygroup Evergreen Limited Add: Unit 606, 6th Floor, Fairmont House, No.8 Cotton Tree Drive, Central, Hong Kong Tel: 86-769-83915520-2802 Email: michael.wang@polygroup.com Date: 2024-03-27 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Attestation letter Dear Sir or Madam, Our product Remote Controller, model: PDT-015-15,PDT-015-01, PDT-015-02, PDT-015-03, PDT-015-04, PDT-015-05, PDT-015-06, PDT-015-07, PDT-015-08, PDT-015-09, PDT-015-10, PDT-015-11, PDT-015-12, PDT-015-13, PDT-015-14, FCC ID: 2A62O-PDT015CXD, for marketing purpose, this product only supports 433.92MHz.The other functions, bands and modes was disabled to use by manufacturer in the software, the end user has no capability to activate it. Sincerely, Signature:

Michael Wang Manager

Company Name: Polygroup Evergreen Limited Add: Unit 606, 6th Floor, Fairmont House, No.8 Cotton Tree Drive, Central, Hong Kong Tel: 86-769-83915520-2802 Email: michael.wang@polygroup.com Declaration of Similarity Date2024-03-27 To:

FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Dear Sir/Madam, We, Polygroup Evergreen Limited hereby declare that there are some differences between our Multiple Models and testing products. Details as below:

Products Description Name Manufacturer Remote Controller Polygroup Evergreen Limited TestedModel PDT-015-15 FCC ID:2A62O-PDT015CXD Differences Description Differences Model numbers and appearance. Multiple Models PDT-015-01, PDT-015-02, PDT-015-03, PDT-015-04, PDT-015-05, PDT-015-06, PDT-015-07, PDT-015-08, PDT-015-09, PDT-015-10, PDT-015-11, PDT-015-12, PDT-015-13, PDT-015-14 Details 1. PCB board, structure and internal of these models are the same, only difference from model numbers and appearance. 2. This is a series of certification

(covering 01-15 keys), the number, function and position setting of the keys are flexible as manufacturer need. Multiple Model- have the same or similar structure, PCB, Material and function to the testing products. All models have the same software and firmware. Besides the differences in the table above, we declare the products are identical We guarantee all the information provided above is true, and notice that well bear all the consequences caused by any false information or concealing Company Name: Polygroup Evergreen Limited Add: Unit 606, 6th Floor, Fairmont House, No.8 Cotton Tree Drive, Central, Hong Kong Tel: 86-769-83915520-2802 Email: michael.wang@polygroup.com Best Regards, Sincerely, Signature:

Michael Wang Manager

Company Name: Polygroup Evergreen Limited Add: Unit 606, 6th Floor, Fairmont House, No.8 Cotton Tree Drive, Central, Hong Kong Tel: 86-769-83915520-2802 Email: michael.wang@polygroup.com FCC Authorization Date: 2024-03-27 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Subject: Agent Authorization To whom it may concern:

We Polygroup Evergreen Limited, the undersigned, hereby authorizes World Alliance Testing & Certification (Shenzhen) Co., Ltd to act on its behalf in all matters relating to application for Equipment authorization, including the signing of all documents relating to these matters. All acts carried out by World Alliance Testing & Certification (Shenzhen) Co., Ltd on our behalf shall have the same effect as our own action. We, the undersigned, hereby certify that we are not subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. This authorization is valid until further written notice from the applicant. Sincerely, Signature Michael Wang Manager QA-FR-170-B 7/29/2014

Company Name: Polygroup Evergreen Limited Add: Unit 606, 6th Floor, Fairmont House, No.8 Cotton Tree Drive, Central, Hong Kong Tel: 86-769-83915520-2802 Email: michael.wang@polygroup.com FCC Confidential Authorization Date: 2024-03-27 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Subject: Confidentiality Request regarding application for certification of FCC ID: 2A62O-PDT015CXD In accordance with Sections 0.457 and 0.459 of the Commissions Rules, Polygroup Evergreen Limited hereby requests long-term confidential treatment of information accompanying this application as outlined below:

Block Diagram Schematics Operation Description The above materials contain proprietary and confidential information not customarily released to the public. The public disclosure of these materials provides unjustified benefits to its competitors in the market. Sincerely, Signature Michael Wang Manager

U.S. AGENT LETTER OF ATTESTATION Date: 2024-03-27 FEDERAL COMMUNICATIONS COMMISSION Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Ref: Attestation Statements CFR 47 2.911(d)(7) Filing FCC ID: 2A62O-PDT015CXD Polygroup Evergreen Limited certifies that, as of the date of the filing of the application, Polygroup North America, Inc. is our designated U.S. agent for service of process for the above referenced FCC ID. Polygroup Evergreen Limited accepts to maintain an agent for no less than one year after the grantee has terminated all marketing and importation or the conclusion of any Commission-related proceeding involving the equipment. Polygroup North America, Inc. accepts, as of the date of the filing of the application, the obligation of the designated U.S. agent for service of process for the above referenced FCC ID. Designated U.S. Agent Information:

Name: Polygroup North America, Inc. Address: 303 SW 16th Street, Suite 5, Bentonville, AR, 72712, USA FRN: 0033462706 Tel.: +1 915.355.5952 Email: eric.wong@polygroup.com Signed by (printed name): Eric Wong Signature:

Applicant: Polygroup Evergreen Limited Address: Unit 606, 6th Floor, Fairmont House, No.8 Cotton Tree Drive, Central, Hong Kong FRN: 0032448086 Tel: 86-769-83915520-2802 Email: michael.wang@polygroup.com Signed by (printed name): Michael Wang Signature: