Manual Remote Controller Model Number: RC5A1 USER INSTRUCTIONS FOR REMOTE CONTROLLER 1. This remote controller is used to operate Grow & Stow christmas tree product. 2. Remove the battery lid at the back of remote control, install two AAA/UM4/LR03 batteries
(not included) as indicated inside the battery compartment. Make sure to match the (+) and (-) ends of the batteries. (see Fig 2). 3. Press light mode button to navigate the light functions. 3 4. Press the UP button on Remote Control Hand Set to activate the tree Grow motion. 5. Press the DOWN button on Remote Control Hand Set to activate the tree Stow motion. 6 4 5 Fig 2 2 3 5 4 1 Fig 1 6 Key 1 2 3 4 5 6 Description Remote Control handset Remote LED indicator Remote light functions button Remote grow (Up and Pause) button Remote stow (Down and Pause) button Remote battery compartment and lid Qty 1 M A D E I N C H N A I FCC Information and Copyright This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. 28 IC warning This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.