18LCDSP-1 MANUAL
1. Transmitter Model : 18LCDSP-1
2. Technology: SST 2-Way
3. Max Range : 1800M
4. LCD : status indication
5. Battery:CR2450
6. Button:
BUTTON
ACTION
FUNCTION
1
2
3
4
5
1x
1.5sec
3sec
1x
1.5sec
3sec
2x
2sec
1x
1x
Arm / Lock
Silent arm
Panic start / stop
Disarm / Unlock
Silent disarm
Panic start / stop
Remote Start
Trunk release
Aux CH4 output
Aux CH5 output
is not
The manufacturer
FCC Statement
This device complies with FCC Rules part 15. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) This device must
accept any interference that may be received, including interference that may cause
undesired operation.
responsible for any radio or TV
interference caused by unauthorized modifications to this equipment. Such modification
could void the user’s authority to use the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and,
if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation.
interference to radio or
this equipment does cause harmful
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
If
SAR Information Statement
Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed
the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications
Commission of the U.S. Government. These limits are part of comprehensive guidelines and establish
permitted levels of RF energy for the general population. The guidelines are based on standards that
were developed by independent scientific organizations through periodic and thorough evaluation of
scientific studies. The standards include a substantial safety margin designed to assure the safety of all
persons, regardless of age and health. The exposure standard for wireless mobile phones employs a
unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is
1.6 W/kg. * Tests for SAR are conducted with the phone transmitting at its highest certified power
level in all tested frequency bands. Although the SAR is determined at the highest certified power
level, the actual SAR level of the phone while operating can be well below the maximum value. This is
because the phone is designed to operate at multiple power levels so as to use only the power
required to reach the network. In general, the closer you are to a wireless base station antenna, the
lower the power output. Before a phone model is available for sale to the public, it must be tested and
certified to the FCC that it does not exceed the limit established by the government adopted
requirement for safe exposure. The tests are performed in positions and locations (e.g., at the ear and
worn on the body) as required by the FCC for each model. As described in this user guide, is
1.100W/Kg(Body-worn measurements differ among phone models, depending upon available
accessories and FCC requirements).
phone with all reported SAR levels evaluated as in compliance with the FCC RFexposure guidelines.
SAR information on this model phone is on file with the FCC and can be found under the Display Grant
section of http://www.fcc.gov/ oet/fccid after searching on
FCC ID: TBQT30-SS2W-1 Additional information on Specific Absorption Rates (SAR) can be found on
the Cellular Telecommunications Industry Asso-ciation (CTIA) web-site at http://www.wow-com.com.
* In the United States and Canada, the SAR limit for mobile phones used by the public is 1.6 watts/kg
(W/kg) averaged over one gram of tissue. The standard incorporates a sub-stantial margin of safety to
give additional protection for the public and to account for any variations in measurements.
The FCC has granted an Equipment Authorization for this model
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF exposure
requirements, a minimum separation distance of 0mm must be maintained between the user’s
body and the handset,
including the antenna. Third-party belt-clips, holsters, and similar
accessories used by this device should not contain any metallic components. Body-worn
accessories that do not meet
these requirements may not comply with RF exposure
requirements and should be avoided. Use only the supplied or an approved antenna.