TO TURN ON 1. First turn boat to ON (ON/OFF switch located on bottom of car). Lights on car will activate. 2. Turn Remote Controller to ON with indicators on remote set to NORM. A CAUTION A WARNING
+ Correctly charging battery pack will avoid short circuits. Short circuits + The charger is not intended for use by children under 12 years old. Charge under will cause overheating, burning of the cords and other damage to the direct adult supervision. battery pack and charger. + Inspect the charger on a consistent basis, especially the leads and connectors.
+ The Li-ion battery charger should be used for charging one battery pack. Do not use if there are signs of damage. Do not use the charger for charging other types of batteries and battery packs. + Never attempt to dismantle or repair the charger. Only use as a Li-ion battery charger.
+ Do not use charger as a direct current outlet for other electrical Not suitable as a main adaptor or transformer. appliances or machines. + Never attempt to recharge non-rechargeable batteries this could result in damage
+ Make sure that the battery pack and charger are kept out of the hands to battery and charger. of infants and small children at all times. Do not charge near fires, * Do not overcharge your battery pack. This will not increase running time and will locations where the temperature is extremely high. Keep water away cause damage to your battery and charger. from battery pack, especially while charging. * Do not charge near water.
+ The battery and charger will slightly heat up while charging. Keep area free of obstacles while charging. SPECIAL PRECAUTIONS
+ If the power of the battery pack is weak in spite of proper charging, the batteries + Store and operate this product away from excessive heat and moisture. may be worn out from repeated use. Replace it with a new Li-ion battery pack. * Charge battery pack indoors only.
+ Disconnect the A/C Charger before making or breaking connections to the battery. + Dispose of used Li-ion battery packs correctly. Waste Electrical Products should not
+ Only use recommended battery pack. be disposed of with household waste. Recycle where facilities exist.
+ WARNING! DO NOT ATTEMPT TO RECHARGE NON-RECHARGABLE * Never dispose of into a fire. BATTERIES IN CONTROLLER.
+ Use enclosed battery charger for the rechargeable battery pack only. CLEANING AND REPAIR If you do not operate the vehicle for a long period of time, remove the battery or the charge will be lost. Please use a clean, damp cloth to wipe down the product. Do not leave the car or the remote controller near heat source or fire. Do not leave the unit in extreme hot or cold weather, in the rain or in humid conditions. USE GOOD COMMON SENSE WHEN OPERATING, CHARGING OR STORING THE UNIT. 2.4G REMOTE CONTROL BATTERY INSTALLATION The battery cover is located on the bottom of the radio controllers. Slide the battery cover as shown in the photos, install three AA size batteries into the battery compartment, and replace the battery cover. Battery Precautions:
1. Do not mix new and old batteries. 2. Use batteries of same brand. 3. Always remove batteries when not in use. 4. Before using your car, make sure the radio controller is of enough battery power. Low battery power will lead to the loss of control of your car. CHARGING THE BATTERY PACK ouTPUT SOCKET 1. Join the connector of the charger to the connector of the battery pack. 2. Plug the charger into an electrical outlet. 3. Recharge for about 4 hours. 4. When the recharging is over, plug out the charger from the electrical outlet and detach the connectors. ALLOW MOTOR TO COOL DOWN BEFORE CHANGING TO NEW BATTERY!
BATTERY CHARACTERISTICS AND RECHARGING TIPS RECHARGING: WARNING!
When playing for the first tiem after purchase, of USE UNDER THE DIRECT SUPERVISION OF after a long interval, the battery power may be weak. AN ADULT. Even after recharging, the playing time can be The newly purchased battery pak is relatively short. not charged. The battery will gradually regain power after 2 or 3 Charge before operating. repetitions of usage and recharging. OPERATING INSTRUCTIONS LEFT/RIFHT ON/OFF TROUBLESHOOTING PROBLEM CAUSE REMEDY Speed control servo does Transmitter and/or receiver is not Switch on. not operate. switched on. Transmitter batteries are weak. Replace with new batteries. Improper radio installation. Correct as per radio instruction manual. Motor does not rotate. Ni-Cd battery capacity is insufficient. Recharge Ni-Cd battery. Improper radio installation. - Correct as per instruction manual. Loose connectors. - Make connectors tighter(e.g.with minus screwdriver). Motor trouble. -_ Replace with new motor. Motor rotates but boat will Joint is not installed. Tighten screws holding joint. not run. Or, screws are loose. When rotation by hand, propeller Dirt entered rotating parts. -- Clean and regrease. feels heavy or does not rotate. PERFORMANCE TIPS Do not operate on grass, dirt, sand or carpet. Do not drive through water or snow. Do not drive in windy conditions or in the rain. If remote controller or vehicle gets wet, first turn off vehicle and unplug the battery pack, then use a clean, dry cloth to wipe it down. Avoid direct impact with obstacles. Turn off the R/C and car when not in use. Keep wheels clean and free from debris, including hair, sand and dirt. For maximum frequency reception, keep antenna up on remote controller. ay
@CE gear MADEIN CHINA ITEM NO.Y211237 FCC ID : 2A1Y3-Y211237 DESC: 2.4G HOVER BOAT This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, Including interference that may cause undesired operation. Changes or modifications not expressly approved by the manufacturer could void the user s authority to operate the equipment. This eq pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection ment has been tested and found to comply with the limits for a Class B di against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular install on. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receh ing antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. ITEM NOY211237 FCC ID : 2AlY3-Y211237A, DESC: 2.4G HOVER BOAT This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, Including interference that may cause undesired operation ions not expressly approved by the manufacturer could void the user s Changes or mod authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or televi off and on, the user is encouraged to try to correct the interference by one or more of the following 1n reception, which can be determined by turning the equipment measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.