USER MAUNNAL WIRELESS POWER RECEIVER Model number: R1205C3DG, R1205C3ST, R1205C3I7, R1205C3S8, R1205C3CM R1205C3XX (XX could be CM, ST or DG) 1 PHONEZ-axisdistancePHONECASEPTU(Transmier)PRU(R1205-C3ST) T1205C3XX User Manual / T1205C3XX Key Feature Support mobile phones with Micro-BLightning Micro-BLightning Type-C or Type-C connectors AirFuel (A4WP) When operating with AirFuel (A4WP) compatible transmitter, it can Drop & go convenience, no need to concern about alignment Product Specification 1. Model_: R1205C3XX Output: 5W (5V/1A) 2. 3. 1. : R1205C3XX 2. : 5W (5V/1A) Over Voltage Protection to protect itself from 3. damage caused by unexpected induced rectifier voltage 4. 4. Over Temperature Protection to protect from overheating 5. 5. Current Limit to limit current at pre-configured level 6. 6. Dynamic current adjustment by referring to 7. : 80 x 64 x 1.4 temperature value 8. : 15g 7. Dimension: 80 x 64 x 1.4mm 8. Weight: 15g Before installation Make sure the connector of RECEIVER match the connector connector of mobile phone youd like to charge Installation Procedure Plug the male connector of RECEIVER into the mobile phone connector and put them in the charging area Product Safety Reminder 1. Slightly heat up during charging is normal 1. 2. Please do not soaking in water, drop, bump, or 2. ,, disassemble the product permission for 3. maintenance. 4. PowerWoW PTU , 3. Please use PowerWoW PTU transmitter to ensure 2 the performance. Product Safety Information FCC INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and Canadian ICES-001-V4. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
. Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Caution: (Notice) To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. 3 IMPORTANT NOTE:
To comply with the FCC/IC RF exposure compliance requirements, the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. No change to the antenna or the device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements and void users authority to operate the device. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 4