Operation Introduction The Operation Introduction of soft bath massage pillow with wireless remote control:
1.3AAA batteries for hand control, and 4AAA batteries for motor in the bath pillow;
2.The direction to replace the 4AAA batteries in the pillow: Open the battery box according to the direction printed on the cover. After the batteries are replaced, tighten and close the battery box well,to keep it waterproof well. Introductions for use 1. Press the switch of the battery box first. When you hear longer sound, the battery power is on. 2. Then press the power button on the hand control , you will hear short sound . The motor will begin to work,and provide vibration massaging;
3. Mode button: 2 modes for choice waving or normal 4. 5. Press the power button on the hand control again, The vibration massaging is stopped;
Intensity button: 2 speeds for choice 6. When you wont use the bath pillow, please press the switch on the battery box to off the power of batteries in the pillow. If the power of the hand control is off ,and the power of the motor is on, you will hear long alarm after 1 minute, to remind you to off the power of the motor . If you dont off the switch of the battery box, the pillow will come to be on battery-saving status in 1 minute.. 7. When the product is in battery-saving status, the hand control isnt workable. When you use the massage bath pillow again, Please switch off the power of the battery box in the pillow first, and press the switch on the battery box again.The hand control is workable. 8. 15 minutes timer. When the product work continued in 15 minutes, the product will come into battery-saving status. FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.