BLE TRX Stick EN User manual Intended use FR Manuel utilisateur Utilisation prvue This BLE TRX Stick is a Bluetooth Low Energy Beacon for indoor positioning using a mobile device. It is designed to be installed in Pricer infrastructure only. Ce BLE TRX Stick est un Beacon Bluetooth Low Energy pour le positionnement indoor laide dun appareil mobile. Il est conu pour tre install dans les infrastructures de Pricer seulement. WARNING!
ATTENTION!
Be careful not to bend the BLE TRX Stick or damage the locking pin. Do not use the stick if the locking pin is damaged. Replace the BLE TRX Stick if damaged. Do not connect to an Ethernet or a Power Over Ethernet (POE) port. Take appropriate safety measures when installing the BLE TRX Stick at high height. Installation 1. Power OFF the Pricer system by switching off the PSU (power supply unit). 2. 3. LED Removal 4. When all BLE TRX Sticks are installed, power ON the Pricer system by turning on the PSU. Veillez ne pas plier le BLE TRX Stick ou dendommager la goupille de verrouillage. Ne pas utiliser le Stick si la goupille de verrouillage est endommag. Remplacez le Stick sil est endommag. Ne pas se connecter un rseau Ethernet ou un Power Over Ethernet (POE) port. Prendre des mesures de scurit appro-
pries lors de linstallation du Stick grande hauteur. 5. Check that the LED starts blinking green:
System is booting Three quick blinks One blink per sec Normal operation No blink Faulty unit 6. If the LED does not blink, remove the BLE TRX Stick (see below) and install it again. If the LED still fails to blink, replace the stick. When all BLE TRX Sticks are installed, power ON the Pricer system by turning on the PSU. 1. 2. 1 Disposal Waste of electrical and electronic equipment must not be disposed as unsorted municipal waste (RoHS and WEEE). Dispose the product separately in accordance with applicable federal, state and local regulations. Specifications Model number:
25081 BLE TRX Stick. Size: 85 22 8 mm. Weight: 12 g. Connecting port:
RJ45 modular jack connector. Supply voltage:
+48 V DC. Contact information www.pricer.com Vstra Jrnvgsgatan 7 SE-11164 Stockholm, Sweden Original language: EN. Version: EN-02-OCT2015 2015 Pricer AB All rights reserved Compliance FCC compliance statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Operation is subject to the following conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. Industry Canada certification/Certification Industrie Canada This device complies with Industry Canada license exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR dIndustrie Canada applicables aux appareils radio ex-
empts de licence. Lexploitation est autorise aux deux conditions suivantes : (1) lappareil ne doit pas produire de brouillage, et (2) lutilisateur de lappareil doit accepter tout brouillage radiolec-
trique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. Certification The system complies with the European Electromagnetic Compatibility Directive 2004/108/EC. FCC ID: 2ACC825081 IC: 20234-25081 2