Tracker1UserManual Moduledescription Programmingportinterfacedescription DownLoadingcodedescription ExclusiveApplicationPlatformDescriptionforModule Transferprotocol RFGeneralInformation Programmingportinterfacedescription Gnd VCC CLK Data Reset SPI Programming Pins CCDebugger Connector DownLoadingcodedescription Movemousetoupperrightcornericontoclickit, andthenFlashProgrammerwillappear. Next,movethemousetoFlashprogrammer Antiwhiteareaandclickthemouse, thenentertheprogrammingScreen.. Programmingscreen C:\Transmit_20140627_2.HEX 1000 Checkthebox Fillinfour Fillin1000 TransmitterID Selectprogrammingfile 9798999A9B9C9D9E9FA0A1A2A3A4 A5A6A7A8A9AAABACADAEAFB0B1
. ClickPerformactions ProgrammingOK ExclusiveApplicationPlatformDescriptionforModule moduleonlyusedforProTrackerplatform Battery V V+
Afterinstallingthebattery,movemagnetaway, thenturnonthepowertosendoutinformation movemagnetclose,turnoffthepower Transferprotocol BaudRates:2.4K Start First30minutes 12secondsontosendinginformation 6secondsoff After30minutes 10secondson tosendinginformation 6secondsoff After1hour 8secondsontosendinginformation 6secondsoff After1hours 8secondson tosendinginformation 8secondsoff FrequencyRange:902928MHz RFGeneralInformation Modulation:FSK Ch.Frequency:905927.25Mhz Bandwith :250KHz ChannelNumber:89 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. IMPORTANT NOTE:
This module is intended for OEM integrator. The OEM integrator is still responsible for the FCC compliance requirement of the end product, which integrates this module. Appropriate measurements (e.g. 15 B compliance) and if applicable additional equipment authorizations (e.g. Verification , Doc) of the host device to be addressed by the integrator/manufacturer. LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following " Contains TX FCC ID: 2ADB5-TRACKER1 ".