WIRELESS MICROPHONE 1 2 3 4 Parts Description 1. Grille(Capsule inside) 2. Display 3. Power ON/OFF Switch 4. Battery Compartment/Cover Operation 1. Open battery cover. Install the provided 2pcs 1.5V AA batteries and then close the cover. Pay attention to the correct polarity. 2. Slide power switch to ON position, display will be illuminated. 3. Now receiver RF indicator should light(Please conrm frequency of microphone same as that of receiver before operation). 4. During operation if display is extinguished, this indicates the battery is Iow. Please replace new battery. 5. If the microphone is not going to be used for any length of time, please slide power switch to OFF position and remove the battery. Specications Oscillation Mode: PLL Frequency Range: 517.6 or 537.2MHz Frequency Response: 80~20000Hz at 3dB Frequency Stability: 30ppm Modulation Mode: FM Maximum Deviation: +/-55KHz Mike Capsule: dynamic Pre-emphasis: 50s Antenna: Built-in housing RF Output: <10mW Spurious Emission: <-40dB Power Supply: 2x 1.5V AA batteries Power Dissipation: <250mW NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help Changes or modications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.