FCC Part 15 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Part 15 Class B-specific Note: This equipment has been tested and found to comply with the limits for a Class B dig-
ital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide rea-
sonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Warning Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. FCC exposure limit compliance statement (SAR statement) This equipment complies with radio frequency (RF) exposure limits adopted by the Federal Communications Commission for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body. Innovation, Science and Economic Development Canada (ISED) statement:
CAN ICES-3 (B)/NMB-3(B) tion nest pas dempcher la transmission dinformations de contrle ou de signalisation, ou encore lutilisation de codes rptitifs exigs par la technique. This device complies with ISEDs license-exempt RSSs. Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR dIndustrie Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes:
(1) lappareil ne doit pas produire de brouillage, et
(2) lutilisateur de lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. The device could automatically discontinue transmission in case of absence of information to transmit, or operational failure. Note that this is not intended to prohibit transmission of con-
trol or signaling information or the use of repetitive codes where required by the technology. The device for operation in the band 51505250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems;
The maximum antenna gain permitted for devices in the bands 52505350 MHz and 54705725 MHz shall comply with the e.i.r.p. limit; an The maximum antenna gain permitted for devices in the band 57255825 MHz shall comply with the e.i.r.p. limits specified for point-to-point and non point-to-point operation as appropriate. Lappareil fonctionnant dans la bande comprise entre 5150 et 5250MHz est uniquement rserv une utilisation en intrieur, afin de rduire le risque dinterfrences nocives aux systmes mobiles par satellite utilisant le mme canal;
Le gain dantenne maximum autoris pour les appareils fonctionnant dans les bandes comprises entre 5250 et 5350MHz, et entre 5470 et 5725MHz, doit se conformer la limite de p.i.r.e.; et Le gain dantenne maximum autoris pour les appareils fonctionnant dans la bande comprise entre 5 725 et 5825MHz doit se conformer aux limites de p.i.r.e. spcifies pour lexploitation point point et non point point, selon le cas. De plus, les utilisateurs de radars de haute puissance sont dsigns comme utilisateurs principaux (c.--d. comme utilisateurs prioritaires) des bandes comprises entre 5250 et 5350MHz, et entre 5650 et 5850MHz, et ces radars pourraient causer des interfrences et/ou des dommages aux appareils LAN-EL. This equipment complies with IC RSS-102 RF exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body. Cet quipement est conforme aux limites dexposition aux rayonnements IC tablies pour un environnement non contrl. Cet quipement doit tre install et utilis avec un mini-
mum de 20 cm de distance entre la source de rayonnement et votre corps. CE RF Exposure Compliance IMPORTANT for UK Power Adapter Cord If the available socket outlet is not suitable for the plug supplied with this equipment, it should be cut off and an appropriate three pin plug fitted. With alternative plugs on ap-
proved 3 amp fuse must be fitted in the plug or adaptor or in the main fuse box. NOTE: The plug severed from the mains lead must be destroyed, as a plug with bared flex-
ible cords is hazardous if engaged in a live socket outlet. In the event of replacing the plug fuse, use a 3 amp fuse approved by ASTA to BS 1362, ie carries the the fuse cover, never use plugs with the fuse cover omitted. mark. Always replace WARNING THIS APPLIANCE MUST BE EARTHED. The wires in this mains lead are coloured in accordance with the following code:
Green-and-Yellow = Earth Blue = Neutral Brown = Live As the colour of the wiring in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured Green-and-Yellow must be connected to the terminal in the plug which is marked with the letter E, or by the earth symbol or coloured Green-and-Yellow. The wire which is coloured Blue must be connected to the terminal which is marked with the letter N or coloured Black or Blue. The wire which is coloured Brown must be connected to the terminal which is marked with the letter L or coloured Red or Brown. Argentina In addition, high-power radars are allocated as primary users (i.e. priority users) of the bands 52505350 MHz and 56505850 MHz and that these radars could cause interference and/
or damage to LE-LAN devices. This device meets the EU requirements (1999/519/EC) and the International Commission on Non-Ionizing Radiation Protection (ICNIRP) on the limitation of exposure of the general public to electromagnetic fields by way of health protection. Lappareil pourrait automatiquement interrompre la transmission sil ny a aucune informa-
tion transmettre ou en cas de panne fonctionnelle. noter que lobjectif de cette disposi-
This device is restricted to indoor use only when operating in the 5150 to 5350 MHz fre-
quency range. Este producto utiliza para su funcionamiento una fuente de alimentacin, modelo FSP040-RHBN3 marca Clover con las siguientes caractersticas tcnicas: Entrada: AC 100-240 V, 50-60 Hz, 1.5 A, Cl. I;
Salida: DC 12 V, 3.33 A, que ha sido certificada para su utilizacin en el mercado argentino. Conectar una fuente diferente a la provista podra ocasionar un incendio o choque elctrico. No utilice una fuente diferente a la provista con el equipo. Mini Quick Start Guide Kurzanleitung / Instructions de dmarrage / Gua de inicio rpido Guida introduttiva / Snelstartgids clover.com/help 1 2 6 5 EU Declaration of Conformity Hereby, Clover Network, Inc. declares that the radio equipment type, C305 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:
eu.clover.com/eu-compliance The frequency band and the maximum transmitted power in EU are listed below:
2400MHz 2483.5MHz: 20 dBm (EIRP) 5150MHz 5250MHz: 23 dBm (EIRP) 5250MHz 5350MHz: 23 dBm (EIRP) 5470MHz 5725MHz: 30 dBm (EIRP) LTE Band 1: 23dBm (conducted) LTE Band 3: 23dBm (conducted) LTE Band 7: 23dBm (conducted) LTE Band 8: 23dBm (conducted) LTE Band 20: 23dBm (conducted) NFC (13.56MHz): -11.33 dBA/m (@10m) Clover Mini 3 Model Number: C305 X-00000 Patent clover.com/patents Clover Network, Inc. 415 N Mathilda Ave Sunnyvale, CA 94085, USA EU Importer: Marketplace Merchant Solutions Ltd Unit 9, Richview Office Park Clonskeagh, Dublin 14, Ireland 3 4 Plug in last, to a grounded AC power outlet. Brancher en dernier sur une prise de courant alternatif (CA) mise la terre. Zuletzt einstecken. Enchufe al ltimo. Collegare per ultimo. Sluit als laatste aan. Restrictions in AT/BE/BG/CZ/DK/EE/FR/DE/IS/IE/IT/EL/ES/CY/LV/LI/LT/LU/HU/MT/NL/NO/PL/
PT/RO/SI/SK/TR/FI/SE/CH/UK/HR. 5150MHz-5350MHz is for indoor use only. Waste Electrical and Electronic Equipment-WEEE Caution: Exposure to Radio Frequency Radiation This equipment complies with EU radiation exposure limits set forth for an uncontrolled en-
vironment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. NOTE: This product is covered electronic equipment under the European Unions Waste from Electrical and Electronic Equipment (WEEE) Directive (2012/19/EU). The WEEE Directive requires that covered equipment be collected and managed separately from typical household waste in all EU member states. Please follow the guidance of your local environmental authority or ask the shop where you purchased the product for collection or recycling options. v3