submitted | available | document details (if available) | source link |
---|---|---|---|
February 09 2019 | April 09 2019 | Microsoft Word - XMR201705BG96NA_Modular Approval Checklist.docx dell Acrobat Distiller 9.0.0 (Windows) |
various | Modular Approval Checklist | Cover Letter(s) | 105.64 KiB | February 09 2019 / April 09 2019 |
Quectel Wireless Solutions Company Limited Declaration of the Modular Approval Applicant / Grantee FCC ID:
Model:
The single module transmitter has been evaluated then tested meeting the requirements under Part 15C Section 2.12 as below:
Quectel Wireless Solutions Company Limited XMR201705BG96NA BG96-NA
(b) Modular approval requirement
(a) The radio elements of the modular transmitter must have their own shielding. The physical crystal and tuning capacitors may be located external to the shielded radio elements. The modular transmitter must have buffered modulation/data inputs (if such inputs are provided) to ensure that the module will comply with part 15 requirements under conditions of excessive data rates or over-modulation.
(c)The modular transmitter must have its ownpowersupplyregulation.
(d) The modular antenna must transmitter must the antenna and comply with transmission system requirements of Sections 15.203, 15.204(b) and 15.204(c). The be permanently attached or employ a unique antenna coupler (at all connections between the module and the antenna, including the cable). The professional installation provision of Section 15.203 is not applicable to modules but can apply to limited modular approvals under paragraph (b) of this section. either
(e)The modular be transmitter must tested in a stand-alone configuration, i.e., the module must not be inside another device during testing for compliance with part 15 requirements. Unless the transmitter module will be battery powered, it must comply with line conducted requirements found in Section 15.207. AC or DC the AC EUT Condition The radio elements of the modular transmitter have their own shielding. Comply YES The modular has buffered data inputs, it is integrated in chip BG96-NA. Please see schematic.pdf All power lines derived from the host device are regulated before energizing other circuits internal to the BG96-NA. Please see schematic.pdf A permanently attached antenna or unique antenna connector is not a requirement for licensed modules. YES YES Not Applicable YES The BG96-NA was tested in a stand alone configuration via a PCMCIA extender. Please see conducted set up photo.pdf and spurious set up Quec ctel Wirel ess Solu utions Co ompany Limited powe to the will 15.27 lengt unkn there modu acce conn unmo Sect insid er lines and e module mu be marketed 7(a)). The le th typical of nown, at lea e is no cou and ule essories, pe nected to the odified and ion eanotherdev output lines c data input/o ain ferrites, u ust not conta module (se d with the ese lines sh ength of the e or, if that f actual use meters to in ast 10 centi een the cas upling betwe supporting equipme ripherals, o or support e e module d uring testing cially availa d commerc 15.31(i))m connected nless they ee Section all be the length is nsure that se of the ent. Any equipment g shall be able
(see mustnotbe viceduringtes sting. modular uipped with e must be cap FCC identific transmit either a perm pable of elec cation numbe st be mus tter xed label manently affix isplaying ctronically d er. equ or m its F
(f)The
(g) The wit that the inst suc mus equ edo e modular tra h any specifi t ordinarily ap manufacture ructions alon hrequiremen st be include uipmentautho on theintende ansmitter mu ic rules or op pply to a com er must provi ng with the m nts. A copy o ed in the appl orizationrequ eduse/config st comply uirements perating requ mplete transm mitter and e ide adequate plain any module to exp of these instru uctions lication for uirements,wh urations. hicharebas
(h)The m with its fin modular trans any applicab nal configura smitter must ble RF expos ation. comply sure requirem ments in Dated By:
2019/8 8/1 YES Y YES Y YES Y The label po is clearly ind of the modu when it is in label must i Contains FC XMR20170 see the labe The BG96-N all applicabl instructions Manual. osition of BG dicated. If the ule cannot be nstalled, then nclude the te CC ID:
05BG96NA. el.pdf NA is complia le FCC rules are given in G96-NA e FCC ID e seen n the host ext:
Please ant with s. Detail the User The BG96-N comply with exposure re see the MP 20cm as the NA is approv h the applicab equirement, p E evaluation e distance re ved to ble RF please n with estriction. Joh nny Xiang Quectel Wireless Solutions Company Limited Title:
On behalf of :
Signature
(Quectel Limited) Wireless Solutions Printed Telephone:
+86-2150086326-800
This product uses the FCC Data API but is not endorsed or certified by the FCC