submitted | available | document details (if available) | source link |
---|---|---|---|
July 27 2020 | August 07 2020 |
various | Modular Approval Request | Cover Letter(s) | 125.99 KiB | July 27 2020 / August 07 2020 |
Quectel Wireless Solutions Company Limited Declaration of the Modular Approval Applicant / Grantee FCC ID:
Model:
The single module transmitter has been evaluated then tested meeting the requirements under Part 15C Section 212 as below:
Quectel Wireless Solutions Company Limited XMR202005BG95M5 BG95-M5 Modular approval requirement EUT Condition
(a) The radio elements of the modular transmitter must have their own shielding. The physical crystal and tuning capacitors may be located external to the shielded radio elements. The radio elements of the modular transmitter have their own shielding. Com ply YES
(b) The modular transmitter have buffered modulation/data inputs are provided) to ensure that the module will comply with part 15 requirements under conditions of excessive data rates or over-modulation. inputs (if such must
(c)The modular transmitter must have its own powersupply regulation. The modular has buffered data inputs, it is integrated in chip. Please see schematic.pdf YES All power lines derived from the host device are regulated before energizing other circuits internal to the BG95-M5. Please see schematic.pdf YES Quectel Wireless Solutions Company Limited
(d) The must modular transmitter comply with the antenna and transmission system requirements of Sections 15.203, 15.204(b) and 15.204(c). The antenna must either be permanently attached or employ a unique antenna coupler (at all connections between the module and the antenna, including the cable). The professional installation provision of Section 15.203 is not applicable to modules but can apply to limited modular approvals under paragraph (b) of this section.
(e)The be must modular transmitter tested in a stand-alone configuration, i.e., the module must not be inside another device during testing for compliance with part 15 requirements. Unless the transmitter module will be battery powered, it must comply with the AC line conducted requirements found in Section 15.207. AC or DC power lines and data input/output lines connected to the module must not contain ferrites, unless they will be marketed with the module (see Section 15.27(a)). The length of these lines shall be the length typical of actual use or, if that length is unknown, at least 10 centimeters to insure that there is no coupling between the case of the module and supporting equipment. Any accessories, peripherals, or support equipment connected to the module during testing shall be unmodified and commercially available (see Section 15.31(i))mustnotbeinsideanotherdeviceduringtesting.
(f)The modular be equipped with either a permanently affixed label or must be capable of electronically displaying its FCC identification number. transmitter must
(g) The modular transmitter must comply with any specific rules or operating requirements that ordinarily apply to a complete transmitter and the manufacturer must provide adequate instructions along with the module to explain any suchrequirements. A copy of these instructions must be included in the application for equipmentauthorizationrequirements,whicharebasedonthei ntendeduse/configurations.
(h)The modular transmitter must comply with any applicable RF exposure requirements in its final configuration. A permanently attached antenna or unique antenna connector is not a requirement for licensed modules. YES The BG95-M5 was tested in a stand alone configuration via a PCMCIA extender. Please see spurious setup YES The label position of BG95-M5 is clearly indicated. If the FCC ID of the module cannot be seen when it is installed, then the host label must include the text:
Contains FCC ID: XMR202005BG95M5. Please see the label.pdf The BG95-M5 is compliant with all applicable FCC rules. Detail instructions are given in the User Manual. YES YES The BG95-M5 is approved to comply with the applicable RF exposure requirement, please see the MPE evaluation with 20cm as the distance restriction. YES Quectel Wireless Solutions Company Limited 2020/7/16 Signature Title: Project Manager Limited Dated By:
Jean Hu Printed On behalf of :
Quectel Wireless Solutions Company Telephone:
+86-21-51086236 ext 6511
This product uses the FCC Data API but is not endorsed or certified by the FCC