CORPORATION Product Evaluation and Compliance Kimberly Card | Radi Control 100 Throckmorton St Ste 1300 Fort Worth, TX 76102-2802 a o.. a . s |
oa _ Fire Engine with Bump
&) RadioShack. kimberly.card@radioshack.com INSTALLING BATTERIES WARNING: Dispose of old batteries promptly and properly. Do not burn or bury.them. CAUTIONS: , Use only fresh batteries of the required size and recommended type. Ifyou do not plan to use the Fire Engine for a week or more, remove the batteries from both the transmitter and the Fire Engine. Batteries can jeak chemicals that can destroy electronic parts. CONTROLLER BATTERY INSTALLATION Use a Phillips head screw driver to remove the battery compartment cover located on the back of the controller. Insert 1 9V." alkaline battery in the correct position as marked in compartment. Replace cover and screw. :
FIRE ENGINE INSTALLATION 1. Follow all operating instructions and precautions to charge your "6V" rechargeable battery pack. Note: most rechargeable batteries need charging when newly purchased. 2. Insert fully charged battery pack into battery compartment the (+) and (-) ends match. Use a coin oF Philip screw to turn the battery lock and secure the battery in place, RADIO CONTROL DRIVING 1. Slide ON/OFF to ON underneath the Fire Engine. 2. Fully extend the.antenna on the transmitter and slide OFF/ON on the transmitter to ON. The indicator on the transmitter lights. 3. Use the transmitters control levers to move and steer the Fire Engine. 4. When you finish driving the Fire Engine, slide OFF/ON on the Fire Engine and the transmitter to OFF. FIRE ENGINE FUNCTION CONTROLS Install fully charged rechargeable batteries into the Fire Engine battery compartment and transmitter in the correct position as indicated. Install transmitter antenna as indicated. Move power switches located undemeath the Fire Engine and front of the transmitter to the "on"
positions. Fully extend transmitter antenna. Place Fire Engine on a flat surface.
* To drive the Fire Engine, move selector switch to the left to select FireEngine operations.
* Emergency lights will flash with siren sound when Fire Engine is moving.
* To drive forward, move joystick A upward... To drive in reverse, move joystick A downward.
* To tum right, move joystick A upward and joystick B to the right,
* To reverse left, move joystick A downward and joystick B to the left.
* To reverse right, move joystick A downward and joystick B to the right.
* To operate the ladder, move selector switch to the right to select ladder operations. NOTE: This equipment has been tested and found to comply with
* To extend and raise ladder, move joystick A to upward =< the fimits for a Class B digital device, pursuant to Part 15 of the FCC To retract and lower ladder, move joystick Adownward. - Rules. These limits are designed to provide reasonable protection
* To rotate ladder to the right, move joystick B to the right. _ against harmful aeeerance na residential installation This To rotate ladder to the left, move joystick B" to the left . equipment generates, uses and can radiate radio frequency energy
* To squirt water, push the water button locate on the controller and, if not installed and used in accordance with the instructions,
: SN may cause harmful interference to radio communications. Cautions : Do not point water pump at the eyes. y .