FCC ID: Q3K-BFJET5XT40 5 GHz Beamforming Outdoor Radio Device

RADWIN 5000 JET 5.x GHz 5 GHz Beamforming Outdoor Radio Device REFERENCE GUIDE Regulatory Compliance FCC/ISED - Compliance This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and ISED RSS standards. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. It is the responsibility of the installer to ensure that when using the outdoor antenna kits, only those antennas certified with the product are used. The use of any antenna other than those certified with the product is expressly forbidden by FCC rules 47 CFR part 15.204 and ISED RSS standards. Warning Avertissement Il est de la responsabilit de l'installateur de s'assurer que lorsque vous utilisez les kits d'antennes extrieures, seules les antennes certifis avec le produit sont utiliss. L'utilisation d'une antenne autre que ceux qui sont certifis avec le produit est expressment interdite par la rglementation FCC partie 47 CFR 15.204 et ISDE normes RSS. Outdoor units and antennas should be installed ONLY by experienced installation professionals who are familiar with local building and safety codes and, wherever applicable, are licensed by the appropriate government regulatory authorities. Failure to do so may void the product warranty and may expose the end user or the service provider to legal and financial liabilities. Resellers or distributors of this equipment are not liable for injury, damage or violation of regulations associated with the installation of outdoor units or antennas. The installer should configure the output power level of antennas according to country regulations and antenna type. Caution RADWIN 5000 JET 5.x GHz Reference Guide i Prudence Les units extrieures et les antennes doivent tre installs que par des professionnels expriments d'installation qui sont familiers avec les normes locales et les codes de scurit et, si applicable, sont agres par les autorits gouvernementales de rglementation comptents. Ne pas le faire peut annuler la garantie du produit et peuvent exposer l'utilisateur final ou le fournisseur de services financiers. Revendeurs ou distributeurs de ces quipements ne sont pas responsables des blessures, des dommages ou violation des rglements lis l'installation des units extrieures ou des antennes. L'installateur doit configurer le niveau de puissance de sortie des antennes conformment aux rglementations nationales et le type d'antenne. d'obligations juridiques et Warning The device must be installed to provide a separation distance of at least 52 cm from all persons L'appareil doit tre install pour fournir une distance de sparation d'au moins 96 cm de toutes les personnes The device is granted to operate under FCC certification in the 4.9 / 5.2 /

5.3 / 5.4 / 5.8 GHz bands. Avertissement Warning L'appareil est autoris fonctionner sous certification ISDE dans les bandes 4,9 / 5,3 / 5,4 / 5,8 GHz. Avertissement This device complies with Part 15 of the FCC rules and with Industry Canada license-

exempt RSS standard(s). Operation is subject to the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference that may cause undesired operation. Cet appareil est conforme la norme dIndustrie Canada exempts de licence RSS (s). Son fonctionnement est soumis aux deux conditions suivantes:

1. Cet appareil ne peut pas causer dinterfrences, et 2. Cet appareil doit accepter toute 3nterference, y compris les 3nterferences qui peuvent causer un mauvais fonctionnement de lappareil. This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numrique de la classe B est conforme la norme NMB-003 du Canada RADWIN 5000 JET 5.x GHz Reference Guide ii Overview The RADWIN 5000 JET 5.x GHz is a 5 GHz Base Station operating in the 4.9, 5.2, 5.3, 5.4 and 5.8 GHz frequency bands. It is a TDD OFDM radio supporting 5, 10, 20 MHz, 40 MHz and 80 MHz channel bandwidths. It is a 2x2 MIMO base station. The RADWIN 5000 JET 5.x GHz incorporates an integrated beamforming antenna with software capability to toggle between wide and narrow transmission angles and thus enhance data throughput efficiency with the subscriber units. The RADWIN 5000 JET 5.x GHz is certified under the FCC ID: Q3K-BFJET5XT40. It is also certified under IC: 5100A-BFJET5XT40 excluding the 5.2 GHz band. Condition of Use The RADWIN 5000 JET 5.x GHz is a proprietary base station manufactured by RADWIN. The device is not for sale to the general public and requires professional installation. FCC rules and ISED Regulation Restrictions The firmware is factory programmed to operate under the FCC rules and ISED regulation restrictions. The firmware is locked and inaccessible by third party. As a result of the above the user interface allows both the installer and the user to control the host only within the boundaries of the regional restrictions. Part 15 Subpart B disclaimer The RADWIN 5000 JET 5.x GHz is authorized only for FCC rules Part 90Y and Part 15E. Antenna The RADWIN 5000 JET 5.x GHz incorporates an integrated beamforming antenna capable of transmitting in wide and narrow angle modes Antenna details:

Antenna Type Integrated Beamforming Integrated Beamforming Operating Mode Antenna Passive Gain

(dBi) Antenna BF Gain Antenna Overall Gain

(dBi) Narrow Wide 11.0 11.0 9.5

20.5 11.0 RADWIN 5000 JET 5.x GHz Reference Guide 1 Maximum Output Power 5725 5850 MHz band FCC Part 15 Subpart E, RSS 247 The maximum output power is set as follows, under FCC and ISED regulations. 10 MHz: 29.0 dBm 20 MHz: 29.0 dBm 40 MHz: 29.0 dBm 80 MHz: 29.0 dBm 5150 5250 MHz band FCC Part 15 Subpart E The maximum output power is set as follows, under FCC regulations. 10 MHz: 23.0 dBm 20 MHz: 23.0 dBm 40 MHz: 22.0 dBm 80 MHz: 20.0 dBm 5250 5350 MHz band FCC Part 15 Subpart E, ISED RSS 247 The maximum output power is set as follows, under FCC and ISED regulations. The power values are for systems with 13 dBi antenna gain not exceeding the 30 dBm EIRP limit 10 MHz: 15.0 dBm 20 MHz: 18.0 dBm 40 MHz: 18.0 dBm 80 MHz: 18.0 dBm 5470 5725 MHz band FCC Part 15 Subpart E, ISED RSS 247 The maximum output power is set as follows, under FCC and ISED regulations. 10 MHz: 15.0 dBm 20 MHz: 18.0 dBm 40 MHz: 18.0 dBm 80 MHz: 18.0 dBm 4940 4990 MHz band FCC Part 90 Subpart Y, ISED RSS 111 The maximum output power is set as follows, under FCC and ISED regulations. 5 MHz: 26.0 dBm 10 MHz: 26.0 dBm 20 MHz: 26.0 dBm RADWIN 5000 JET 5.x GHz Reference Guide 2 Labelling Requirements The device is labeled with the identification numbers as follows:

FCC ID: Q3K-BFJET5XT40 IC: 5100A-BFJET5XT40 RADWIN 5000 JET 5.x GHz Reference Guide 3

RADWIN 5000 JET 5.x GHz

<description>

neo fait IP67 Type 4 Enclosure FCC ID: Q3K-BFJETSXT40 IC: 5100A-BFJET5SXT40 REV: A This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference received, including interference that may cause undesired operation.

[= |RADWIN RADWIN 5000 JET Aa

Agent Authorization Company: RADWIN Ltd. Address: 27 Habarzel Street Tel Aviv, 6971039 Israel Product Name: 5 GHz Beamforming Outdoor Radio Device Model Number(s): RADWIN 5000 JET 5.x GHz Product Description: 5 GHz Beamforming Outdoor Radio Device We authorize MiCOM Labs Inc., 575 Boulder Court, Pleasanton, California 94566, USA, to act on our behalf on all matters concerning the certification of above named equipment. We declare that MiCOM Labs Inc. is allowed to forward all information related to the approval and certification of equipment to the regulatory agencies as required and to discuss any issues concerning the approval application. Any and all acts carried out by MiCOM Labs on our behalf shall have the same effect as acts of our own. Signature:

Date: December 30, 2021 Name:

Shlomo Weiss Title:

Standardization Officer Company: RADWIN Ltd.

Date: January 2, 2022 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Subject: FCC Restriction Configuration Control Attestation for FCC ID: Q3K-BFJET5XT40 To Whom It May Concern:

RADWIN Ltd. attests that the software of the model: RADWIN 5000 JET 5.x GHz conforms to the requirements of the FCCs SOFTWARE SECURITY REQUIREMENTS FOR U-NII DEVICES specified in 594280 D02 U-NII Device Security v01r03 and KDB 442812 D01 SDR Apps Guide v02r03 under the SDR rules. We have submitted separate documentation to the FCC outlining the software security features. Furthermore that the software of the RADWIN 5000 JET 5.x GHz cannot be modified by any third party in any way that causes the RADWIN 5000 JET 5.x GHz to operate in violation of the limits of the FCC GRANT OF EQUIPMENT AUTHORIZATION for FCC ID: Q3K-BFJET5XT40. Sincerely Yours, Name:

Title:

Date: January 2, 2022 Shlomo Weiss Standardization Officer RADWIN Ltd.

+972-3-7662988

+972-3-7662902 shlomo@radwin.com Phone:

Fax:

Email:

RDWN65 FCC Restriction Config Control Attestation Rev1.1

FCC Request Date: January 2, 2022 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 USA Attn: OET Dept. Product/ Model Number: RADWIN 5000 JET 5.x GHz To whom it may concern;

The enclosed documents constitute a formal submittal and application for Equipment Authorization for a software defined radio pursuant to the following rules;

Subpart E of Part 15 of FCC rules (CFR 47) UNII devices The device is a 5 GHz base station with an integrated beamforming antenna The application is seeking approval as a software defined radio. Name: Shlomo Weiss Title: Standardization Officer Signature of applicant Date: January 2, 2022

Office of Engineering Technology Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 USA Date: January 2, 2022 Subject; Request for Confidentiality FCC ID: Q3K-BFJET5XT40 To Whom It May Concern, Pursuant to the provisions of the Commissions rules Title 47 Sections 0.457 and 0.459, we are requesting the Commission to withhold the following attachment(s) as confidential documents from public disclosure indefinitely. These documents contain detailed system and equipment descriptions and are considered as proprietary information in operation of the equipment. The public disclosure of these documents might be harmful to our company and would give competitors an unfair advantage in the market. Additionally the device is not accessible to users being installed in hosts manufactured only by RADWIN and hosts being mounted on antenna towers. Schematic Diagram Block Diagram Parts List Operational Description Security Descriptions Internal Photos External Photos Test Setup Photos User Manual In additional to above mentioned documents, in order to comply with the marketing regulations in Title 47 CFR 2.803 and the importation rules in Title 47 CFR 2.1204, while ensuring that business sensitive information remains confidential until the actual marketing of newly authorized devices, we request Short Term Confidentiality of the following attachment(s);

OR For 45 days, pursuant to Public Notice DA 04-1705. For 180 days pursuant to KDB 726920 D01. It is our understanding that all measurement test reports, FCC ID label format and correspondence during the certification review process cannot be granted as confidential documents and this information will be available for public review once the grant of equipment authorization is issued. Sincerely, Signature:

Name: Shlomo Weiss Title: Standardization Officer

FCC Software Configuration Control Declaration Date: January 2, 2022 Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 USA Attn: OET Dept. Product/ Model Number: RADWIN 5000 JET 5.x GHz Regarding FCC Country Code Selection guidelines identified in KDB 594280. All applications for equipment authorization for transmitters that can have radio parameters, or other technical parameters, reported to the Commission set by software must have an attestation indicating that no third party will have software, or configuration control, to program the device out of compliance of the technical rules under which it has been certified. We declare that no third party will have software, or configuration control, to program the device out of compliance of the technical rules under which it has been certified. Name:

Title:

Signature of applicant Date: January 2, 2022 Standardization Officer Shlomo Weiss RDWN65 FCC Software Config Cntl Declaration Rev1.1